ReadyWarm 10150 Smart Ceramic Pro Stylex - Fan heater CECOTEC - Free user manual and instructions

Product type	Fan heater
Brand	Cecotec
Model	ReadyWarm 10150 Smart Ceramic Pro Stylex
Power supply	220-240 V ~ 50 Hz
Rated power	2000 W
Dimensions (W x D x H)	20 x 15 x 30 cm
Weight	2 kg
Heating type	Ceramic
Main functions	Ceramic heating, ventilation, adjustable thermostat, 24h timer, remote control, oscillation
Operating modes	Eco, comfort, fan only
Built-in thermostat	Yes, adjustable from 15 to 35 °C
Programmable timer	Yes, up to 24 hours
Remote control	Yes, included
Oscillation	Yes, automatic
Safety	Overheat protection, automatic shut-off if tipped over
Maintenance and cleaning	Unplug and clean the grilles with a soft dry cloth
Spare parts and repairability	Removable and washable filter available as spare part
Warranty	2 years
Package contents	Unit, remote control, user manual

Frequently Asked Questions - ReadyWarm 10150 Smart Ceramic Pro Stylex CECOTEC

How to clean my Cecotec ReadyWarm fan heater?

Unplug the appliance and wait for it to cool down. Use a soft dry cloth to clean the grilles and surface. Never use water or abrasive products.

How to set the timer on the ReadyWarm 10150?

Press the Timer button on the remote control or control panel. Use the arrows to increase or decrease the time (from 1 to 24 hours). The appliance will turn off automatically after the set delay.

My fan heater does not turn on, what should I do?

Check that the appliance is properly plugged in and the outlet works. Make sure the thermostat is set above room temperature. If the problem persists, contact customer service.

Can I use the heater in a bathroom?

The appliance is not designed for humid rooms. Use it only in dry, well-ventilated areas, away from water splashes.

How does Eco mode work?

Eco mode automatically adjusts the power to maintain a comfortable temperature while saving energy. It alternates between heating and ventilation.

What to do if the appliance turns off by itself?

This is likely due to overheat or tip-over protection. Check that the grilles are not obstructed and place the appliance on a stable surface. Wait a few minutes before turning it back on.

The remote control does not work, how to reset it?

Replace the batteries in the remote control. Point it at the appliance's sensor. If the problem persists, remove the batteries, wait 30 seconds and reinsert them.

How to change the filter of my heater?

Unplug the appliance. Remove the filter located at the back (by sliding it). Clean it with a vacuum or rinse with lukewarm water and let it dry completely before reinstalling.

What is the maximum power of the ReadyWarm 10150?

The maximum power is 2000 W, which allows rapid heating of rooms up to about 25 m².

Can I leave the appliance on all night?

Yes, thanks to overheat protection and the thermostat, you can use it continuously. Set a comfortable temperature and activate the timer if necessary.

USER MANUAL ReadyWarm 10150 Smart Ceramic Pro Stylex CECOTEC

Modern cylindrical digital thermometer with digital display showing 25°C, no visible text or symbols on the device itself

ES · Este producto no es adecuado para calefacción primaria. Este producto está indicado únicamente en lugares abrigados o para una utilización puntual. EN · This product is not suitable for primary heating purposes. This product is only suitable for well insulated spaces or occasional use. FR · Ce produit ne convient pas pour une utilisation en tant que chauffage primaire. Cet appareil a été conçu seulement pour être utilisé dans des espaces intérieurs ou pour une utilisation momentanée. DE · Dieses Produkt ist nicht für primäre Heizzwecke geeignet. Dieses Produkt ist nur für gut isolierte Räume oder für den gelegentlichen Gebrauch geeignet. IT · Questo prodotto non è adatto a riscaldamento primario. Questo prodotto è indicato solamente per luoghi caldi o per uso sporadico. PT · Este produto não é adequado para ser utilizado como aquecimento primário. Destina-se a uma utilização ocasional e apenas em locais abrigados. NL · Dit product is niet geschikt voor primaire verwarming. Dit product is alleen geschikt voor gebruik op beschutte plaatsen of voor incidenteel gebruik. PL · Ten produkt nie nadaje się do pierwotnego ogrzewania. Ten produkt jest wskazany tylko do miejsc ostoniętych lub do okazjonalnego użytku. CZ · Tento produkt není vhodný pro primární vytápění. Tento výrobek je určen pouze na topení na chráněných místech nebo pro příležitostné použití.

Manual de instrucciones Instruction manual Manuel d'instructions Bedienungsanleitung Manuale di istruzioni Manual de instruções Handleiding Instrukcja obsługi Návod k použití

Instrucciones de seguridad 4
Safety instructions 5
Instructions de sécurité 6
Sicherheitshinweise 8
Istruzioni di sicurezza 9
Instruções de segurança 10
Veiligheidsvoorschriften 12
Instrukcje bezpieczeństwa 13
Bezpečnostní pokyny 15

ÍNDICE

1. Parts and components 22
2. Before use 22
3. Operation 22
4. Cleaning and maintenance 24
5. Technical specifications 24
6. Disposal of old electrical appliances 24
7. Technical support and warranty 25

SOMMAIRE

Read these instructions thoroughly before using the appliance. Keep this instruction manual for future reference or new users.

• Make sure that the mains voltage matches the voltage stated on the rating label of the appliance and that the wall outlet is grounded.
• Check the power cord regularly for visible damage. If the cord is damaged, it must be replaced by the official Technical Support Service of Cecotec in order to avoid any type of danger.
• The appliance must not be placed immediately below a socket.
• Do not place the appliance close to heat sources, flammable substances, wet surfaces or allow it to come into contact with water or other liquids. Do not operate outdoors.
• Do not introduce or allow objects to be introduced in the air inlet or outlet, this could cause risk of electrical shock, fire or damage.
• If the appliance falls into water, do not touch it and unplug it immediately.
• Do not immerse the cord, plug, or any non-removable part

of the appliance in water or any other liquid, nor expose the electrical connections to water. Make sure your hands are dry before handling the plug or switching on the appliance.

• Always turn off and unplug the appliance when not in use and before moving it to a new location. Pull from the plug, not the cord, to disconnect it from the outlet.
• The appliance is not intended to be used by children under the age of 8.
• It can be used by children over the age of 8, as long as they are given continuous supervision.
• This product can be used by children and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, as long as they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
• Supervise young children to make sure that they do not play with the appliance. Close supervision is necessary when the appliance is being used by or near children.

INSTRUCTIONS DE SÉCURITÉ

1. Knob
2. Air outlet
3. Base
4. Front housing
5. Handle
6. Air inlet
7. Oscillation switch
8. Power cord

2. BEFORE USE

• Take the product out of the box and remove all packaging materials.
• Check for any visible damage. If any is observed, contact as soon as possible the Technical Support Service of Cecotec for advice or reparation.
• Always place the device on a flat and stable surface.
• Turn the power level knob to the "0" position and plug the product's connector to an earthed power socket.

3. OPERATION

Fig. 2

1. Decrease temperature
2. Increase temperature
3. On/Off
4. Mode
5. Oscillation

6. Timer

7. Use the temperature buttons to increase or decrease the temperature. The temperature can be adjusted from 10 °C to 49 °C .

8. When the set temperature is higher than the room temperature, the appliance will start operating in Heating mode and the Mode button will light up.
9. Press the Mode button once or twice to activate the Heating mode automatically. If it is pressed once, the appliance will start running at low temperature. If pressed twice, the

appliance will start running at high temperature.

1. Press this button to set the desired operating time from 1 to 8 hours.
2. Press this button to activate the oscillation mode.
3. Press the power button to switch the device off. The fan's blades light indicator will light up and the appliance will turn off after 30 seconds.

Oscillation button

Press the oscillation button to activate and deactivate the oscillation function.

Timer function

• This function can be activated with any of the modes. The operating time can be set from 1 to 8 hours. Each time the timer button is pressed, the operating time is increased by 1 hour. Once the timer is set, the remaining operating time will be displayed by 1 hour on the panel. Once the time has elapsed, the appliance will turn off.
• Press the timer button one more time after the display shows 8 hours to reset continuous operation.

Thermostat instructions

• Use the temperature buttons to increase or decrease the temperature.
• When the set temperature is equal or lower to the room temperature, the heater will stop operating. Despite this, the fan will continue to run for the appliance to cool down and to keep temperature steady.
• When the set temperature is 2^ above the room temperature, the appliance will start operating at low temperature. When it falls 4^ , it will start operating at high temperature.
• The temperature can be set from 10 °C to 49 °C.

Remote control

Fig. 3

1. On/Off
2. Temperature increase
3. Temperature decrease
4. Oscillation
5. Mode

6. Timer

7. This remote control requires a lithium CR2025 3V battery.

8. Any function activated from the remote control will operate as when activated from the control panel.

Tip-over safety system

The heater is designed to turn automatically off when tipped forward or backward. The unit will automatically turn on once it is returned to its normal upright position.

Protection against overheating system

1. The heater features a protection system that turns the appliance automatically off in case of overheating, for example, when the air inlet or outlet is partially or completely obstructed. If this happens, follow the below steps:
2. Unplug the appliance and wait for 30 minutes approx. until it cools down.
3. Clear the obstruction from the air outlet or inlet.
4. Turn it on again. The appliance should now work properly.

Note

If the problem remains, contact the official Technical Support Service of Cecotec.

4. CLEANING AND MAINTENANCE

– Turn off and unplug the appliance and allow it to cool down before cleaning it.
- Do not use abrasive cleaners or scouring pads to clean the product.
- Use a soft, dampened and clean cloth to clean the product's outer housing. Be careful not to touch the heating element.
- One of the most common causes of overheating is the building up of debris or fluff in the appliance. Make sure to clean it periodically and to vacuum the ventilation grilles.
- If the product is not going to be used for a long period of time, unplug it and store it in a dry and safe place where it is protected from dust.
- Do not disconnect the appliance from the plug, turn it off with the button to avoid it from overheating.

5. TECHNICAL SPECIFICATIONS

Product reference: 05826

Product: Ready Warm 10150 Smart Ceramic Pro

Power and voltage: 2200 W, 220-240 V, 50 Hz

Made in China | Designed in Spain

6. DISPOSAL OF OLD ELECTRICAL APPLIANCES

The European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE), specifies that old household electrical appliances must not be disposed of with the normal unsorted municipal waste. Old appliances must be collected separately, in order to optimise the recovery and recycling of the materials they contain and reduce the impact on

human health and the environment.

The crossed out “wheeled bin” symbol on the product reminds you of your obligation to dispose of the appliance correctly.

Consumers must contact their local authorities or retailer for information concerning the correct disposal of old appliances and/or their batteries.

7. TECHNICAL SUPPORT AND WARRANTY

This product is under warranty for 2 years from the date of purchase, as long as the proof of purchase is submitted, the product is in perfect physical condition, and it has been given proper use, as explained in this instruction manual.

The warranty will not cover the following situations:

• The product has been used for purposes other than those intended for it, misused, beaten, exposed to moisture, immersed in liquid or corrosive substances, as well as any other fault attributable to the customer.
• The product has been disassembled, modified, or repaired by persons, not authorised by the official Technical Support Service of Cecotec.
• Faults deriving from the normal wear and tear of its parts, due to use.

The warranty service covers every manufacturing defects of your appliance for 2 years, based on current legislation, except consumable parts. In the event of misuse, the warranty will not apply.

If at any moment you detect any problem with your product or have any doubt, do not hesitate to contact Cecotec Technical Support Service at [phone].

Information requirement for the electric local space heaters
Model(s) identifier: 05826 Ready Warm 10150 Smart Ceramic Pro
Item	Symbol	Value	Unit	Item	Unit
Heating power				Type of heat input, for electric storage local space heaters only (single select)
Nominal heat output	Pnom	2.2	kW	Manual heat charge control with integrated thermostat	[no]
Minimum heat output (indicative)	Pmin	1.3	kW	Manual heat charge control with room and/or outdoor temperature feedback	[no]
Maximum continuous heat output	Pmax	2.2	kW	Electronic heat charge control with room and/or outdoor temperature feedback	[no]
Auxiliary electricity consumption				Fan assisted heat output	[no]
At nominal heat output	elmax	0	kW	Type of heat output/room temperature control (single select)
At minimum heat output	elmin	0	kW	Single stage heat output and no room temperature control	[no]
In standby mode	eSB	0	kW	Two or more manual stages, no room temperature control	[no]
				With mechanic thermostat room temperature control	[yes]
				With electronic room temperature control	[no]
				Electronic room temperature control plus day timer	[no]
				Electronic room temperature control plus week timer	[no]
				Other control options (multiple selections possible)
				Room temperature control, with presence detection	[no]
				Room temperature control, with open window detection	[no]
				With distance control option	[no]
				With adaptive start control	[no]
				With working time limitation	[yes]
				With black bulb sensor	[no]
Contact details:	Cecotec Innovaciones S.L. · C/de la Pinadeta s/n 46930 Quart de Poblet, Valencia (SPAIN)

1. PIÈCES ET COMPOSANTS

Img. 1

Product: Ready Warm 10150 Smart Ceramic Pro

Vermogen en voltage: 2200 W, 220-240 V, 50 Hz

Made in China | Designed in Spain

6. RECYKLING SPRZĘTU AGD