TW002G - Screwdriver MAKITA - Free user manual and instructions
Find the device manual for free TW002G MAKITA in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product type | Cordless impact driver |
| Brand | Makita |
| Model | TW002G |
| Rated voltage | 40 V max (36 V) |
| Battery type | Lithium-ion, XGT battery |
| No-load speed | 0 - 3 600 rpm |
| Impact rate | 0 - 3 800 ipm |
| Max torque | 200 Nm |
| Screwing capacity | Wood screws up to 12 mm |
| Chuck | Hexagonal 6.35 mm (1/4") |
| Weight (with battery) | Approx. 1.5 kg |
| Dimensions (L x W x H) | 135 x 79 x 250 mm |
| Power supply | Cordless, battery powered |
| Protection | Electronic overload and deep discharge protection |
| LED light | Yes, with illumination function |
| Variable speed | Yes, trigger-controlled |
| Forward/reverse | Yes |
| Maintenance and cleaning | Clean with a dry cloth; do not use corrosive products |
| Spare parts and repairability | Available from Makita; tool is repairable |
| Warranty | 3 years (depending on country) |
Frequently Asked Questions - TW002G MAKITA
How to insert and remove the battery of the TW002G impact driver?
To insert the battery, align the battery grooves with the tool's slides and push until it clicks. To remove, press the battery release buttons and pull backward.
What type of battery to use with the Makita TW002G?
Use only Makita XGT batteries of 40 V max (36 V nominal). 18 V series batteries are not compatible.
How to adjust the tool speed?
The speed is variable depending on the trigger pressure. Light pressure gives slow speed, heavier pressure increases speed. There is no mechanical speed selector.
Can the TW002G be used for drilling?
No, this impact driver is designed for screwing and tightening. For drilling, use a suitable drill.
How to clean the impact driver?
Disconnect the battery. Clean the housing with a slightly damp cloth. Do not use solvents or abrasive products. The ventilation openings must remain clear.
What to do if the impact driver stops suddenly?
This may be due to electronic protection against overheating or overload. Let the tool cool down for a few minutes. If the problem persists, check the battery or contact after-sales service.
How to change the brushes?
The TW002G is equipped with a brushless motor. Therefore, there are no brushes to change.
The LED light does not turn on, what to do?
Check that the battery is charged and properly inserted. If the light still does not turn on, the LED module may be defective; contact an authorized repair center.
What is the maximum screw capacity?
The maximum capacity is approximately 12 mm wood screws and M12 bolts. Performance depends on the type and hardness of the material.
Where to find the user manual?
The user manual is available free of charge in PDF format on sites like notice-facile.com. You can download it or view it online.
User questions about TW002G MAKITA
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Screwdriver in PDF format for free! Find your manual TW002G - MAKITA and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. TW002G by MAKITA.
USER MANUAL TW002G MAKITA
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : MAKITA
Model : TW002G
Category : Screwdriver