ADD6920 - Water dispenser PHILIPS - Free user manual and instructions
Find the device manual for free ADD6920 PHILIPS in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Water Dispenser |
| Brand | Philips |
| Model | ADD6920 |
| Dimensions (W x D x H) | 310 x 300 x 410 mm |
| Weight | Approx. 3.5 kg |
| Power Supply | 220-240 V, 50 Hz |
| Rated Power | 2000 W |
| Water Tank Capacity | 1.2 L (cold), 1.5 L (hot) |
| Water Temperature Settings | Hot (85°C), Cold (5-15°C), Room Temperature |
| UV Sterilization | Yes |
| Child Lock | Yes |
| Energy Saving Mode | Yes |
| Descaling Frequency | Every 3 months |
| Filter Replacement | Every 6 months (type: CPW1) |
| Cleaning Instructions | Wipe exterior with damp cloth; clean tank with mild soap |
| Safety Features | Overheat protection, anti-dry burn, automatic shut-off |
| Spare Parts Available | Drip tray, water tanks, filter, UV lamp |
| Noise Level | < 40 dB |
| Warranty | 2 years |
Frequently Asked Questions - ADD6920 PHILIPS
How do I descale the Philips ADD6920 water dispenser?
Use a descaling solution suitable for water dispensers. Mix according to instructions, run through the hot and cold cycles, then rinse thoroughly with fresh water. Repeat every 3 months.
How to clean the water tank?
Remove the tank and wash with warm soapy water. Rinse well and dry. For the exterior, use a soft damp cloth. Avoid abrasive cleaners.
What should I do if the dispenser is leaking?
Check if the tank is properly seated and the drip tray is not full. Inspect the water line connections. If the problem persists, contact Philips support.
How to replace the filter?
Turn off the dispenser. Remove the old filter by twisting it counterclockwise. Insert a new filter (model CPW1) and twist clockwise until tight. Run water for a few minutes before use.
Why is no water coming out?
Check if the water tank is empty. Ensure the child lock is not activated. Also verify the power supply and that the dispenser is not in energy saving mode.
How to activate child lock?
Press and hold the child lock button for 3 seconds until the lock icon appears. To deactivate, press and hold again. This prevents accidental hot water dispensing.
What are the error codes?
Common codes: E1 (temperature sensor error), E2 (heating issue). Refer to the manual for full list. Reset by unplugging for 30 seconds.
Can I adjust the water temperature?
Yes. The hot water is preset to 85°C. Cold water temperature can be adjusted between 5-15°C using the control panel settings.
How much energy does it consume?
Rated power is 2000W, but standby consumption is low. Energy saving mode reduces power when not in use. Typical daily consumption is about 1 kWh.
Is the Philips ADD6920 noisy?
No, it operates below 40 dB, similar to a quiet conversation. The compressor for cold water may produce a faint hum.
User questions about ADD6920 PHILIPS
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Water dispenser in PDF format for free! Find your manual ADD6920 - PHILIPS and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. ADD6920 by PHILIPS.
USER MANUAL ADD6920 PHILIPS
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : PHILIPS
Model : ADD6920
Category : Water dispenser