SBS-MD-8 - Detector STEINBERG - Free user manual and instructions
Find the device manual for free SBS-MD-8 STEINBERG in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product type | Metal detector |
| Brand | Steinberg |
| Model | SBS-MD-8 |
| Dimensions (L x W x H) | 120 x 25 x 15 cm |
| Weight | 1.2 kg |
| Power supply | 2 AA batteries (1.5 V each) |
| Detection frequency | 7 kHz |
| Max detection depth | Up to 1 m (depending on target) |
| Detection modes | All metal, discrimination, tone |
| Discrimination | Yes, adjustable to eliminate scrap metal |
| Depth indicator | Yes, graphic bars |
| Sensitivity | Adjustable by potentiometer |
| Coil | 20 cm, waterproof |
| Display | LCD with metal and depth indicators |
| Maintenance and cleaning | Clean with a soft, dry cloth. Do not use water or solvents. |
| Safety | Do not use in hazardous areas (gas, explosives). Keep out of reach of children. |
| Spare parts and repairability | Parts available from the manufacturer. Repair possible by an authorized technician. |
| General information | 2-year warranty. Made in China. |
Frequently Asked Questions - SBS-MD-8 STEINBERG
How to turn on the SBS-MD-8 detector?
Press the power button for 2 seconds. A beep confirms startup.
What to do if the detector detects nothing?
Check the batteries, increase sensitivity, and switch to 'All metal' mode to test. If nothing, reset the device by removing the batteries for 10 seconds.
How to adjust discrimination?
Turn the discrimination knob to the right to eliminate ferrous metals. Use a reference object to adjust.
What is the maximum detection depth?
Up to 1 meter for large targets, about 30 cm for a coin. It depends on soil mineralization.
Can I use the detector in the rain?
The coil is waterproof, but the control unit is not. Avoid any exposure to water. Use an umbrella if necessary.
How to replace the batteries?
Open the battery compartment on the back of the device. Insert 2 AA batteries respecting polarity. Close carefully.
What do the beeps mean?
A short beep indicates a low conductivity target (iron). A long beep indicates a high conductivity target (non-ferrous metals). The tone varies by mode.
How to calibrate the detector?
Hold the 'Calibration' button for 3 seconds while moving the coil away from any metal. Release when the indicator blinks.
The detector turns off by itself, why?
The auto-off function activates after 5 minutes of inactivity. To disable, hold the power button for 5 seconds during startup until two beeps.
Where to find spare parts?
Contact Steinberg customer service or visit the official online store. Coils, battery covers, and headphones are available.
User questions about SBS-MD-8 STEINBERG
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Detector in PDF format for free! Find your manual SBS-MD-8 - STEINBERG and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. SBS-MD-8 by STEINBERG.
USER MANUAL SBS-MD-8 STEINBERG
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : STEINBERG
Model : SBS-MD-8
Category : Detector