Comfort 50 - Water filter Steinbach - Free user manual and instructions
Find the device manual for free Comfort 50 Steinbach in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Pool Sand Filter |
| Brand | Steinbach |
| Model | Comfort 50 |
| Dimensions (L x W x H) | 50 x 50 x 80 cm |
| Weight | 25 kg |
| Power Supply | 230 V ~ 50 Hz |
| Motor Power | 0.5 HP |
| Flow Rate | 8 m³/h |
| Maximum Operating Pressure | 2.5 bar |
| Sand Capacity | 50 kg |
| Filter Diameter | 50 cm |
| Body Material | Polyethylene |
| Multiport Valve | Yes, 6 positions |
| Integrated Prefilter | Yes (basket) |
| Protection Rating | IPX4 |
| Max Water Temperature | 35 °C |
| Maintenance | Clean prefilter basket, backwash sand |
| Safety | 30 mA residual current circuit breaker, grounding |
| Spare Parts | Valve, gaskets, pressure gauge, filter sand |
| Repairability | Repairable, parts available |
| General Information | For above-ground pools up to 50 m³ |
Frequently Asked Questions - Comfort 50 Steinbach
How to install the Comfort 50 filter?
Place the filter on a flat and stable surface. Connect the hoses to the inlet and outlet valves. Fill the filter with special pool sand (grain size 0.4-0.8 mm) up to half of the tank. Tighten the lid. Plug the pump into a grounded outlet.
How to perform a backwash?
Set the multiport valve to the 'Backwash' position. Run the pump until the water in the sight glass becomes clear. Stop the pump, then switch to 'Rinse' for 1 minute. Finally, return the valve to 'Filter'.
How often should the sand be cleaned?
The sand is cleaned by backwashing when the pressure gauge reading increases by 0.5 bar compared to the initial pressure. Generally, one backwash per week is sufficient.
What type of sand to use?
Use special pool sand with a grain size of 0.4 to 0.8 mm. The required amount is 50 kg for this model.
What to do if the pressure is too high?
Stop the pump and perform a backwash. If the pressure remains high, check the prefilter basket and clean it. Clogged sand may need replacement.
How to bleed air from the filter?
Open the bleed screw on top of the filter. Air will escape until water comes out. Close the screw as soon as water comes out.
The filter is leaking, what to do?
Check the valve and lid gaskets. Tighten the connections. If the leak persists, replace the O-rings.
What is the lifespan of the sand?
Filter sand should be replaced every 3 to 5 years depending on usage. If the water becomes cloudy despite good maintenance, change the sand.
How to winterize the filter?
Completely drain the water from the filter. Remove the sand and store it dry. Clean the tank. Keep the filter protected from frost.
Where to find spare parts?
Spare parts are available from your Steinbach dealer or on specialized websites. Use the Comfort 50 model reference for ordering.
User questions about Comfort 50 Steinbach
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Water filter in PDF format for free! Find your manual Comfort 50 - Steinbach and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Comfort 50 by Steinbach.
USER MANUAL Comfort 50 Steinbach
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Steinbach
Model : Comfort 50
Category : Water filter