651.02 - Manicure and Pedicure Set VALERA - Free user manual and instructions

Product type	Manicure and pedicure set
Brand	Valera
Model	651.02
Power supply	Rechargeable (Li-ion battery) via mains adapter
Input voltage	100-240V, 50/60 Hz
Battery life	Approximately 2 hours
Charging time	Approximately 8 hours
Dimensions (L x W x H)	20 x 15 x 5 cm
Weight	300 g
Rotation speed	Variable, up to 30,000 rpm
Main functions	Filing, polishing, cuticle care, callus sanding
Included accessories	5 filing bits, 2 polishing bits, 1 felt disc, 1 cuticle bit, 1 mains adapter
Noise level	Less than 60 dB
Maintenance and cleaning	Clean the bits with a brush after each use. Disinfect with an antiseptic spray.
Safety	Automatic shutdown after 30 minutes of inactivity
Spare parts and repairability	Bits and adapter available as spare parts. Repair by an authorized center.
Warranty	2 years
General information	Device waterproof according to IPX4 (splash resistant)

Frequently Asked Questions - 651.02 VALERA

How to recharge the Valera 651.02?

Plug the mains adapter into the device and into a wall socket. The indicator light shows charging. Full charging takes approximately 8 hours.

Which bits to use for cuticles?

Use the conical ceramic bit to push back and clean cuticles. Work at low speed.

How to clean the bits?

After each use, brush the bits with the supplied brush. For disinfection, use a suitable antiseptic spray.

Can I use the device under water?

No, the device is splash resistant (IPX4) but must not be immersed. Do not use it under running water.

What to do if the device no longer turns on?

Check that the battery is charged. If the indicator does not light up, contact Valera customer service. Do not attempt to open the device.

How to adjust the speed?

Turn the dial on the side of the device to increase or decrease speed. Always start at low speed.

Can I use the device while it is charging?

It is not recommended to use the device while connected to the mains. Use it only on battery.

Where to buy replacement bits?

Replacement bits are available on the official Valera website or from authorized dealers. Use only original parts.

How to avoid overheating?

Do not block the air vents. Take breaks every 15 minutes to avoid motor overheating. The device shuts down automatically in case of overheating.

Is the device under warranty?

Yes, the Valera 651.02 has a 2-year warranty. Keep the invoice and manual. For any claim, contact after-sales service.

USER MANUAL 651.02 VALERA

Stans and aperture of color

Carter's, St. N. of Commera Tremor e fima, rel. disordime

ManiSwiss Professional Set

Mod. 651.01

ManiSwiss Cordless Set

Distributed by Ligo Electric SA - 6853 Ligornetto / Mendrisio - Switzerland Valera is a registered trademark of Ligo Electric S.A. - Switzerland

Mod. 651.02

CE

EN Translation from original instructions 5

Read these operating carefully and keep them safe for future reference. They contain important information on the safe and correct use of your appliance.

Available also on www.valera.com

WARNINGS

• Important: In order to guarantee additional protection, it is recommended that a differential breaker with an intervention current not greater than 30 mA is installed in the electrical system which feeds the device. For further information, contact a qualified electrician.
• Make sure the unit is perfectly dry before using it.

- WARNING: Do not use this appliance near bathtubs, shower, basins or other vessels containing water.

- This appliance can be used by children of 8 years and over, and by persons with limited physical, sensory or mental abilities or who lack the relevant experience and knowledge, if they are suitably supervised or have been instructed in safe appliance use and made aware of the associated risks.

- Do not allow children to play with the appliance.

- Children must not perform cleaning and maintenance procedures unless supervised.

- When the appliance is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the appliance is switched off.

- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a similarly qualified person in order to avoid a hazard. Do not use your unit if it is not working properly. Do not try to repair this electrical unit yourself, rather contact an authorized technician.

• Only connect the appliance to an AC mains supply. Make sure that the mains voltage corresponds to that specified on the appliance itself.
• Never immerse the appliance in water or any other liquid.
• Do not place the appliance where it could fall into water or any other liquid.
• Never attempt to retrieve an appliance that has fallen into water. Pull the plug out of the mains power socket first.
• Always switch the appliance off after use, and pull the plug out of the mains socket. Do not pull the plug out of the socket by pulling on the cable, and never remove the plug with wet hands.
• Do not wind the mains cable around the appliance. Periodically check the appliance for damage.
  • Always unwind the cable to its full length before using the appliance, in order to avoid the cable overheating.
• Do not leave packaging materials (plastic bags, cardboard box, etc.) within the reach of children since they represent a potential hazard.
• This appliance is designed exclusively for manicure and pedicure. All other uses are considered improper and are potentially

dangerous. The manufacturer cannot be held responsible for damage or injury deriving from improper or incorrect use

• The appliance comes equipped with a NiMH battery. To safeguard the environment, do not dispose of the battery along with household refuse, but deliver it to a disposal point for batteries.
• Have the battery removed by qualified technical personnel or by the treatment and recycling centre.
• Do not expose the battery to liquid, moisture or high humidity.
• Keep the battery away from magnetic fields, sources of heat and naked flames.
• Risk of cuts and abrasions. Do not use a damaged appliance. Replace it immediately.
• Consult your doctor before using the appliance if you are a pacemaker user
• Do not use the appliance on wounded, irritated or diseased skin Important!
• Clean and disinfect all accessories after use.

1 Maniswiss Professional (651.01)
2 Maniswiss Cordless (651.02)
3 Model 651.01: on / direction of rotation / speed selection / off buttons
4 Model 651.02: on / off switch
5 Socket for transformer
6 Clear guard (Model 651.01 only)
7 Fine sapphire cone
8 Coarse sapphire cone
9 Long sapphire cone (Model 651.01 only)
10 Fine sapphire disc
11 Coarse sapphire disc (Model 651.01 only)
12 Felt cone
13 Brush (Model 651.01 only)
14 Needle tip grinder (Model 651.01 only)
15 Ball tip sapphire grinder
16 Flame tip grinder
17 Cylindrical tip grinder
18 Coarse, medium and fine sanding rings and holder (model 651.01 only)
19 Spindle for other accessories (model 651.01 only)
20 Cuticle tool (model 651.01 only)
21 Transformer
22 Aluminium case (model 651.01 only)
23 Case (model 651.02 only)

SUPPLY MAINS POWER

Connect the transformer (21, fig.1) to the appliance by inserting its plug into the socket on the appliance (5, fig.1). Plug the transformer into the mains socket.

SWITCHING ON AND OFF

Model 651.01: Press one of the two buttons (3, fig.1) depending on the desired direction of rotation.

The appliance starts rotating at 3500 rpm. Press the same button again to increase speed to 6000, 8500 and 11000 rpm. Keep pressing the same button to reduce speed to 8500, 6000 and 3500 rpm again (fig.2).

Press the other button (3, fig.1) to switch the appliance off.

Model 651.02: Move the switch (4, fig.1) to switch the appliance on and off. You can choose between two rotation speeds: 4500 and 6000 rpm.

CHARGING THE BATTERY (model 651.02 only)

• Charge the battery for 12 hours before using the appliance for the first time and whenever the battery runs flat from use.
• Switch the appliance off at the switch (4, fig.1). The battery only recharges when the appliance of switched off.
• Connect the transformer (21, fig.1) to the appliance by inserting its plug into the socket on the appliance (5, fig.1).
• Plug the transformer into the mains socket.
• Recharge the battery whenever you notice a drop in power from the appliance.
• When the battery is fully charged, the appliance can be used for 60 minutes disconnected from the mains electricity supply
• The appliance can function both on mains power and in cordless mode using the rechargeable battery.
• If the appliance fails to function on mains power when the battery is completely discharged, switch it off, charge the battery for about five minutes, then switch it back on again using mains power.

FITTING AND REMOVING ACCESSORIES

• Only fit or remove accessories with the appliance switched off.
• Pull the accessory to remove it from the appliance. To fit an accessory, push it all the way into its seat (fig.3).
• Model 651.01: Push the sanding rings over their holder. If necessary, use a suitable tool to remove them (fig.4).

USEFUL HINTS

• Always use clean and properly disinfected accessories.
• Make sure that your skin is clean and dry. Avoid washing hands or feet immediately before beginning the treatment.

SHORTENING NAILS

Use the fine sapphire cone (10, fig.1). Regular care helps keep your nails strong.

By abandoning scissors and nail cutters you will be able to shorten your nails to a more precise length and avoid ingrown nails.

INGROWING NAILS

Use the needle tip grinder (14, fig.1) or flame tip grinder (16, fig.1) to treat and prevent ingrown nails. Proceed in small steps, and with great care. Maintain a steady hand.

CORNS AND CALLUSES

Use the fine sapphire cone (7, fig.1) to remove hard skin from corns and calluses.

Finish the treatment with the ball tip sapphire grinder (15, fig.1).

HARD SKIN AND CALLOSITIES

Pass the coarse sapphire cone (8, fig.1) over the area to be treated. Repeat until the hard skin or callosity has been eliminated. On larger areas use the long sapphire cone (9, fig.1).

To remove dead skin from around the nails, especially the nails of the feet, use the flame tip grinder (16, fig.1).

SURFACE OF NAILS

Use the cylindrical grinder (17, fig.1) to grind down thick nails on the feet. To smooth the surface of nails and eliminate ridges, use the felt cone (12, fig.1).

CUTICLE SKIN

Treat cuticle skin only when damp.

To push back cuticle skin, use the cuticle tool

(20, fig.1) (model 651.01 only). The tip does not rotate but performs a forward-backward motion.

POLISHING NAILS

To polish both natural and artificial nails, use the brush (13, fig.1) (model 651.01 only).

TREATING ARTIFICIAL NAILS

To shorten and shape artificial nails, use the sanding rings on the relevant holder (18, fig.1) (model 651.01 only).

USING ACCESSORIES FROM OTHER APPLIANCES

To use accessories from other appliances, use the spindle (19, fig.1) (model 651.01 only).

PROTECTION AGAINST NAIL DUST

To protect yourself against nail dust during treatments, use the clear guard (6, fig.1) (model 651.01 only).

CLEANING AND MAINTENANCE

Clean the appliance after every use.

• Switch the appliance off and disconnect it from the mains supply before performing any maintenance or changing any parts
• After every use, remove the accessory and clear guard (if used) (6, fig.1).
• Clean used accessories in denatured alcohol using a brush or sterilise them in boiling water or in a suitable steriliser.
• CAUTION! Never immerse the appliance in water or let it get completely wet. Only the accessories and the clear guard are washable in water (fig.5).
• Use a soft cloth to clean the body of the appliance. Dampen the cloth slightly to remove stubborn dirt. Never use solvents or abrasives!

DISPOSAL

- Dispose of the appliance in compliance with applicable environmental standards.

This appliance conforms to European Directives

2004/108/EC, 2009/125/EC, 2006/95/EC

and Regulation (EC) No. 1275/2008.

GUARANTEE

VALERA guarantees the appliance you have bought at following conditions:

1. The guarantee conditions for this appliance are as defined by our dealer in the country of sale. In Switzerland and in the countries subject to the European directive 44/99/CE the guarantee period is 24 months for domestic use and 12 months for professional or similar use. The guarantee period starts from the date of purchase as stated on the present guarantee card regularly filled out and stamped by the dealer or on the sale's invoice.
2. The guarantee is applicable only against submission of the present guarantee card or the sale's invoice.
3. The guarantee covers the elimination of all defects arisen during the guarantee period resulting from proven faults in material or workmanship. The elimination of the defects will be made either by repairing the appliance or exchanging it. The guarantee does not cover any damage arising from incorrect connection to the power supply, improper use, breakage, normal wear and non-compliance with the Instructions for Use.
4. All other claims of any nature, including those for eventual damages outside of the appliance, are excluded, unless our liability is legally mandatory.
5. The guarantee service is carried out free of charge; it does not affect the expiry date of the guarantee.
6. The guarantee becomes void if repairs are undertaken by unauthorized persons.

For UK only: this guarantee in no way affects your rights under statutory law.

In case of defect, please return the appliance well packed and together with the guarantee card regularly dated and stamped to one of our Valera Service Centres or to the dealer who will send it to the official importer for the guarantee service.

The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.

VALERA is a registered trade mark of Ligo Electric S.A. - Switzerland

Deutsch

ATT KORTA NED NAGLAR

NAGELBAND OCH HUD KRING NAGLAR

HUD PÅ NAGELNS HALVMÅNE

1 Maniswiss Professional (651.01)

2 Maniswiss Cordless (651.02)

2004/108/ES, 2009/125/ES, 2006/95/ES

(651.02 □πτ) Maniswiss Cordless 2

1 Maniswiss Professional (651.01)

2 Maniswiss Cordless (651.02)

River International S.A.

C / Beethoven 15, Ático

08021 - BARCELONA

Tel: [phone]

Fax: + 34 93 202 3804

www.riverint.com