Modular AWM-AHX-B - Bras articulé Atdec - Free user manual and instructions

USER MANUAL Modular AWM-AHX-B Atdec

Heavy Duty Dynamic Arm

Technical line drawing of a mechanical lever assembly (no text or symbols)

COMPONENT CHECKLIST REQUIRED TOOLS

Technical line drawing of a mechanical component with cylindrical ends and mounting feet (no text or symbols)

A

Heavy Duty Dynamic Link

(x1)

Technical line drawing of a mechanical lever or support structure (no text or symbols)

B

Lower Angled Link

(x1)

C

4mm Allen Key

(x1)

All tools supplied

WEIGHT RANGE

Desk Base Mount

$$ 6 - 1 6 \mathrm{kg} $$

$$ (1 3 - 3 5 \mathrm{lb}) $$

Post Mount

$$ 6 - 1 4 \mathrm{kg} $$

$$ (1 3 - 3 1 \mathrm{lb}) $$

Monitor weight should be within the weight range of all modular elements that make up the complete monitor mounting solution.

IMPORTANT INFORMATION

! Please ensure this product is installed as per these installation instructions.
! Curved monitors, deep devices (such as all-in-one PCs) and offset VESA locations exert additional leverage that can exceed the capacity of the mount even though the monitor weight may be within the stated range.
! The manufacturer accepts no responsibility for incorrect installation.
! This product is compatible with AWM Series monitor arm products.

1. Assemble Arm Links

2. Fit arm onto Arm Base (AWM-LB) or Channel Clamp (AWM-LC) (sold separately)

2.1 Push arm onto shaft 2.2 Ensure arm is fully pushed onto base Optional: Set joint rotation to 180° on Arm Base or Channel Clamp by following separate instruction manual. 2.3 Tighten set screw Note: Check that arm rotation is smooth after tightening

3. Fit Heavy Duty Tilt Head (AWM-LTH) or Dual Crossbar (AWM-LR) (sold separately)

Dual Crossbar AWM-LR To set up follow separate installation guide supplied with the Dual Crossbar 3.1 Push link onto shaft 3.2 Ensure link is fully pushed onto shaft Heavy Duty VESA Tilt Head AWM-LTH To set up follow separate installation guide supplied with the Heavy Duty Tilt Head 3.3 Tighten set screw Note: Check rotation is smooth after tightening

4. Adjust arm tension

4.1 Use the provided allen key to adjust the arm tension

Heavier Monitor Lighter Monitor Push & Hold NOTE: Hold arm position

4.2 Installing multiple similar monitors?

1. Set up one monitor and record the position of the marker on the gauge.
2. When installing other similar monitors, pre-tension the arm to the recorded marker position then fine-tune the tension by following steps 4.3 to 4.5.

Marker

4.3 If the monitor sags or falls down, increase the arms tension by rotating the screw anti-clockwise.

Monitor Falls (from top)

• Increase Tension

4.4 If the monitor springs upwards, decrease the arms tension by rotating the screw clockwise.

Monitor Springs (from bottom)

• Reduce Tension
  4.5 If the monitor floats or hovers in all positions the arm tension is balanced and does not require further adjustment.

Monitor 'Floats' (all positions)

Balanced

5. Cable management

5.1 Plug cables into the monitor and route the cables down the arm using the cable hooks and clips.

cables into the monitor and e cables down the arm using e hooks and clips. Important! Ensure enough cable slack is given in this area to allow for movement of the monitor.