SSK-GLDTR4DR - Audio Accessories Soundskins - Free user manual and instructions

USER MANUAL SSK-GLDTR4DR Soundskins

Tools needed for installation:

• Panel/trim tool
• Roller
• Screw driver

• Rubber wedge

• Microfiber cloth
  • Acetone or cleaning solution

• Razor blade

Person adjusting a car door panel on the side of a red vehicle (no visible text or symbols)

1. Start by locating the fastening hardware on the door panel, take the appropriate screw driver and remove.

Person adjusting a black car interior panel, no visible text or symbols

1. Once all the screws are removed you can take off the door panel gently watching that you don't break any of the clips or mounting hardware. Pull the panel away slowly and unplug any electrical connections.

Close-up of a car's front panel with visible internal components and a hand pointing to a component (no text or symbols)

1. You will find an insert that needs to be removed, with mounting screws and cables that control door handle and locking mechanism. Slowly pull the insert away and pull through the cables to give yourself some slack.

Close-up of a car interior showing internal mechanical components and a textured surface (no visible text or symbols)

1. Next you need to prop the window up by either a rubber wedge or simply put a screw driver through the bottom hole as illustrated.

Person assembling or adjusting a black vehicle engine compartment with visible branding (no text or symbols on the main subject)

1. Now you are ready to prep the metal surface using a microfiber cloth, Acetone (use a breathing mask), and wipe away any moisture, oil, debris or etc. Then let air dry for an appropriate time. The point is to get the surface clean to ensure material glue contact.

Close-up of a mechanical assembly with visible components and no readable text or symbols

1. When the surface is dry and clean, locate the piece of the kit with the label on the back that coincides with the door you are working on. Make sure it lines up correctly before pulling the white cover paper off. After you confirm the right piece, pull off the backing paper and start placing the material at the top, working your way down with a roller. Make sure that the material is rolled down completely and no air is trapped. Use a razor blade point or household needle to release any air. Repeat these steps for all door panels.

YOU'RE NOW READY TO HIT THE ROAD!

Soundskins USA 13452 Alondra Blvd, Cerritos, Ca 90703 Phone: [phone] Email: [e-mail] www.SoundSkinsGlobal.com

SKU: SSK-GLDTR4DR

soundskins GLADIATOR

2020+ 8 Piece Custom Cut PRO KIT

INSTALLATION VIDEO

Scan code for "how to" video!

Recommended Installation Instructions

A. Prepping the Surface

After removing interior door panels you are ready to clean the metal areas that will be insulated. If the metal has "new" look without imperfections then take a microfiber cloth and wipe away any dust and debris. If the metal is showing signs of age like rust then we recommend using Acetone with a breathing mask to wipe off debris and loose particles. A shop vacuum might be needed to remove loose debris on the floorboard.

B. Installing Panels

Now that you have a clean surface you are ready to start applying the sheets. We recommend a roller to release air pockets that might be lingering from trapped air. You want to make sure that you have rolled those out to the edge and all the material has a good seal to the metal surface. Make sure all pieces are installed and inspected before reinstalling the interior.

1 soundwave soundwave soundwave soundwave

2 3 4

Top-down line drawing of a vehicle chassis with front panel and side panels (no text or symbols)

S soundproof soundproof soundproof soundproof

6 7 8

1) Driver Front Door Panel
5) Passenger Front Door Panel

2,3,4) Driver Rear Door Panel
6,7,8) Passenger Rear Door Panel