95-6535B - Car Radio Metra - Free user manual and instructions

USER MANUAL 95-6535B Metra

INSTALLATION INSTRUCTIONS FOR PART 95-65358

Fiat 500X 2016-up 95-6535B

KIT FEATURES

• ISO DDIN radio provision
- Painted matte black

KIT COMPONENTS

• A) Radio trim panel • B) Radio brackets

Close-up of a car dashboard with a mounted touchscreen display and control buttons (no visible text or symbols)

WIRING & ANTENNA CONNECTIONS (sold separately)

Wiring Harness: • XSVI-6523-NAV

Antenna Adapter: • 40-EU55

Table of Contents

Dash Disassembly 2

Kit Assembly

- ISO DDIN radio provision .... 3

TOOLS REQUIRED

• Panel removal tool • Cutting tool
  • T-25 Torx screwdriver

CAUTION! All accessories, switches, climate controls panels, and especially air bag indicator lights must be connected before cycling the ignition. Also, do not remove the factory radio with the key in the on position, or while the vehicle is running.

95-65358

Dash Disassembly

1. Open upper storage compartment on passenger side. (Figure A)
2. Unclip, unplug, and remove painted hazard button panel below the radio. (Figure A)
3. Unscrew (2) T-25 Torx screws at the bottom of the radio trim. (Figure B)
4. Unclip the radio trim. (Figure B)
5. Unscrew (4) T-25 Torx screws securing the radio into the dash. (Figure C)
6. Unplug and remove the radio from the dash. (Figure C)
7. Cut the shaded areas in the dash cavity to gain suitable depth for the new radio chassis (CAUTION: The vents are located directly behind the area to be cut, use extreme caution to not cut into them). Be careful, you may want to make multiple cuts. (Figures D, E)

Continue to kit assembly.

Diagram of a car dashboard and air conditioner unit with control panel (no text or symbols)

(Figure A)

Technical diagram of a vehicle front panel with control buttons and sensor components (no text or labels)

(Figure B)

Technical diagram of a vehicle dashboard with control panel and directional arrows (no text or symbols)

(Figure C)

First cut Be careful not to cut into the vents! Remove shaded area

(Figure D)

Second cut Remove shaded area

(Figure E)

95-65358

Kit Assembly

ISO DDIN radio provision

1. Attach the radio brackets to the radio using the screws supplied with the radio. (Figure A)
2. Insert the radio trim panel into the factory radio trim removed in step 4 of dash disassembly. (Figure B)
3. Locate the factory wiring harness and antenna connector in the dash, complete all necessary connections to the radio and test the radio for proper operation. Metra recommends using the proper mating adapter from Metra and/or AXXESS.
4. Mount the radio into the dash using the factory hardware.
5. Reassemble the dash in the reverse order of disassembly.

Technical line drawing of an electronic device chassis with labeled ports and connectors (no text or symbols present)

(Figure A) (Figure B)

Technical line drawing of two rectangular components with internal features and directional arrows indicating movement or assembly (no text or symbols)

INSTALLATION INSTRUCTIONS FOR PART 95-65358

IMPORTANT

If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerInstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow.

Metra recommends MECP certified technicians