ACDC-500-BT - Uncategorized Impact - Free user manual and instructions

USER MANUAL ACDC-500-BT Impact

Black electronic device with a green battery icon and a white dot on top, set against a yellow background (no text or symbols)

ADCD-500-BT

Rechargeable Battery

for ACDC-500-TTL Monolight

QUICK-START GUIDE

Precautions

• Do not attempt to disassemble, open, or repair this product.
• Do not dispose of this product in fire or water.
• Do not store above 140^ (60°C).
• Do not puncture, short, or crush the external contacts.
• Images are for illustrative purposes only.

Battery type Li-ion
Voltage 14.4 V
No. of flashes @ full power 350
Charging time (approximate) 3 hr.
Charger Input: AC 100 to 240 V, 50/60 Hz	Output: DC 16.8 V, 2.5 A
Overheat limit 140°F (60°C)
Dimensions 3.7 × 4.2 × 2.6 in.	(9.4 × 10.7 × 6.6 cm)
Weight Battery: 1.5 lb. (680.4 g)

Charging and Installing the Battery

Use the multivoltage charger that's included with the Cruiser TTL 500.

Note: Impact recommends fully charging the battery before its initial use and after an extended period of inactivity (more than two months).

To charge and then install the battery, follow these steps:

1. Plug the AC cord into a wall outlet. The charger's indicator light will glow green when the charger is receiving power.
2. Connect the DC cord to the battery. The charger indicator light will glow red when the battery is charging, and green when the battery is charged.
3. Install the battery by orienting the contacts on the inside edge of the battery with the contacts in the battery compartment. Press it down into the battery compartment until the locking buttons click shut.

Checking the Battery Level

When the battery is installed in the Cruiser, the remaining charge is always displayed by the battery icon on the LCD screen.

If the battery is not installed, check the battery level by pressing and holding the charge indicator button. The indicator lights will show the remaining charge.

One-Year Limited Warranty

This Impact product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of one (1) year from the original purchase date or thirty (30) days after replacement, whichever occurs later. The warranty provider's responsibility with respect to this limited warranty shall be limited solely to repair or replacement, at the provider's discretion, of any product that fails during normal use of this product in its intended manner and in its intended environment. Inoperability of the product or part(s) shall be determined by the warranty provider. If the product has been discontinued, the warranty provider reserves the right to replace it with a model of equivalent quality and function.

This warranty does not cover damage or defect caused by misuse, neglect, accident, alteration, abuse, improper installation or maintenance. EXCEPT AS PROVIDED HEREIN, THE WARRANTY PROVIDER MAKES NEITHER ANY EXPRESS WARRANTIES NOR ANY IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. This warranty provides you with specific legal rights, and you may also have additional rights that vary from state to state.

To obtain warranty coverage, contact the Impact Customer Service Department to obtain a return merchandise authorization ("RMA") number, and return the defective product to Impact along with the RMA number and proof of purchase. Shipment of the defective product is at the purchaser's own risk and expense.

For more information or to arrange service, visit www.impactstudiolighting.com or call Customer Service at 212-594-2353.

IMPACT®

A Gradus Group Brand

Product warranty provided by the Gradus Group.

www.gradusgroup.com

Impact is a registered trademark of the Gradus Group.

© 2017 Gradus Group LLC. All Rights Reserved.