WDBIE1485 - Washing machine Freggia - Free user manual and instructions

Type	Washing machine with dryer
Brand	Freggia
Model	WDBIE1485
Width	59.5 cm
Height	82.0 cm
Depth	54.5 cm
Max spin speed	1400 rpm
Max wash load	8 kg
Max dry load	5.0 kg (cotton) / 3.0 kg (synthetics)
Recommended drying time	250 min (cotton) / 160 min (synthetics)
Water pressure	0.05 - 1 MPa
Power supply	220-240 V, 50 Hz, 10 A
Display	LCD
Delay start	Up to 19 hours
Child lock	Yes (keylock)
Drum disinfection	Yes (90°C cycle)
Load sensing	Easy Logic automatic adjustment
Number of programs	16 (including cotton, synthetics, wool, silk, jeans, sportswear, etc.)
Extra functions	Prewash, Turbo, Rinse, Dry, Adjustable spin

Frequently Asked Questions - WDBIE1485 Freggia

How do I activate the delay start function?

Press button B repeatedly until the desired delay time (up to 19 hours) appears on the display. The icon 'h' will flash until the cycle starts.

What is the drum disinfection cycle?

A special 90°C cycle that cleans the drum by removing mould and bad smells. It can run automatically after a certain number of low-temperature washes or manually by selecting the DRUM DISINFECTION position on the program knob and pressing Start.

How do I activate the child lock?

Press and hold button B (Delayed start) until three horizontal bars appear on the display. To deactivate, press and hold until the bars disappear.

What should I do if the load is unbalanced during spinning?

The automatic load-balancing system will redistribute the clothes and reduce spin speed for safety. If drastically unbalanced, spinning may not occur.

How can I reduce the wash time?

Press the Turbo button (E) to activate a faster cycle. The machine will adjust parameters to save time while maintaining wash quality.

What is the maximum spin speed and how do I change it?

The maximum spin speed is 1400 rpm. Press button C to adjust it. To disable final spin, select '00'.

How do I use the dry function?

Press button G repeatedly to select the desired drying time. The machine will dry with hot air after washing. Do not place the detergent dispenser in the drum during drying.

What programs are available for delicate fabrics?

Programs include Wool (30°C, up to 2 kg), Silk (30°C, up to 2 kg), and Easy Iron (40°C, up to 2 kg). Use appropriate spin speeds.

How do I clean the detergent drawer?

Remove the drawer by pulling it out, remove the partition for liquid detergent, rinse with water, and dry before reinserting.

What should I do if I need to pause or reset a cycle?

Press the Start/Pause button (H) to pause. To reset, turn the program selector knob (I) to the Stop position. The machine will reset.

USER MANUAL WDBIE1485 Freggia

Thank you for purchasing Freggia household appliance.

Please carefully read the user manual, as it contains the instructions for the safe installation, operation and maintenance of the household appliance.

Save it for future use.

RU

B Delayed start / Keylock

C Spin button

D Prewash/disinfection button

E Turbo button

F Rinse button

G Dry button

H Start/pause button

I Program selector knob

WASH IN THE CORRECT WAY

Before attempting to operate the washing machine, ensure that the installation has been performed correctly, as described in the instruction booklet.

• DAILY USE

1. Before placing the washing in the washing machine, make sure that there are no hard pointed objects in the pockets (nails, screws, coins, pins, stones, etc.) as these can damage both the clothing and the appliance.

2. To improve the performance of the wash, place the washing loosely in the drum without compressing it. Do not overload the machine. A full load of particularly absorbent material such as bathrobes and towelling can unbalance the washing machine during the spin phase.

The automatic load-balancing system distributes the washing as evenly as possible and automatically sets the best spin speed to reduce vibrations to a minimum.

1. Close the door, making sure that no washing has become trapped between the door and the gasket.

2. Place the correct amount of detergent in the appropriate dispenser 2. When using a liquid detergent, insert the partition supplied. If the Prewash function is required, add detergent to compartment 1. Add softener to the compartment marked with the symbol ☒. After adding the detergent, gently close the detergent drawer.

3. Use knob I to select a wash programme suitable for the type of fabric, following the instructions reported in the Programme Table. The LCD will display the duration of the selected programme and the maximum load. The remaining time may vary during the course of the wash programme in accordance with the load in the drum. At the end of the cycle, the word End will appear on the display.

4. The spin speed automatically selected by the programme can be changed by pressing button C. Button B is used to delay the start of the wash cycle by up to 19 hours. Both values appear on the LCD display.

5. Buttons D, E, F and G are used to select the extra functions. The options selected appear on the LCD display. The duration of the wash cycle varies according to which options have been selected.

6. To start the wash cycle, press the Start button H. The LCD will display the duration of the cycle and the maximum load. The Easy Logic system updates the remaining cycle time in accordance with the actual load in the drum.

7. At the end of the wash cycle, the word End will appear on the display. Place knob I in the Stop position and open the door to remove the washing.

8. The washing machine can be reset at any time by placing knob I in the Stop position.

CONTROL PANEL

- LCD DISPLAY

The large LCD display makes the washing machine intuitive and simple to use. The display shows the enabled wash functions, the Delayed Start if activated, the selected spin speed and the time remaining until the end of the cycle. The word End informs that the door has been unlocked.

GB

Delayed start

DELAYED START

This function allows the start of the wash cycle to be delayed by up to 19 hours. Press button B repeatedly until the required delay time appears on the display. Icon h will flash on the display until the wash cycle starts.

• RINSE

Pressing the button F activates the skin care function, which carries out an extra rinsing. The option is recommended for skins particularly sensitive to the enzymes contained in detergents.

Rinse

- PREWASH

To carry out a prewash, press button D and add detergent to the appropriate compartment 1. The washing machine will carry out a prewash at 40^ C max.

Prewash

A Prewash is recommended for items soiled with dust, soil, sand or with particularly resistant stains. See the Programme Table for further information.

• TURBO

To reduce the wash time, press the Turbo button E. The operating parameters are automatically regulated to ensure an effective wash and to save time. See the Programme Table for further information.

Turbo

• ADJUSTABLE SPIN

Button C can be pressed to change the spin speed in line with the wash programme selected and the type of fabrics. The selected spin speed will appear on the LCD display. To disable the end of cycle spin, select value "00"

The maximum spin speed varies according to the model. The spin speed selected by the programme is that recommended.

- LOAD IMBALANCE CHECK DURING SPINNING

This washing machine is fitted with a special electronic load balancing control system. Before each spin, the system makes sure that the clothes are distributed as uniformly as possible in the drum. If the washing is not distributed uniformly, the final spin speed is reduced for safety reasons, while if the load is drastically out of balance, the spin is not effected.

- DRY

When the dry option is selected, the washing will be dried by a current of hot air at the end of the wash phase. The duration of the drying phase is selected by repeatedly pressing button G.

Dry

The time depends on the amount of washing loaded, the type of fabric and the degree of dampness to retain.

When this option is enabled, the no-spin function is disabled. At the same time, the detergent dispenser must not be placed in the drum as it could melt during the drying phase and damage both the washing and the washing machine.

To get the best performance of drying clothes washed, the maximum load of washing said (see Program Chart), you should run this cycle in two phases with a load no more than the value stated in taghetta characteristics.

- START

During the phase for selecting programs and washing options, the start LED stays off. To confirm the selections and start the wash cycle, press "Start" button H.

Start

The LED will light up.

Pause

CONTROL PANEL

• CONTROL LOCK (child safety lock)

To activate the control panel lock hold the B key (Delayed start) until the display shows on the left three horizontal bars. If during the wash cycle you want to reactivate the controls functionality, press the B key (Delayed start) until all the bars are cancelled from the display.

The control panel lock can be activated manually only by pressing and holding a few seconds the Delayed start button.

• DISINFECTING THE DRUM Cotton90° + Prewash ▶ Drum disinfection

Frequent washes at low temperatures can lead to the formation of mould and create bad smells inside the washing machine. The DRUM DISINFECTION function thoroughly cleans the washing machine by means of a special 90°C cycle.

DRUM DISINFECTION will automatically suggest starting the cleaning programme after a certain number of washes, if no hot washes have been carried out during this time. This it does by means of a flashing on the display.

Remove all the washing from the drum, place knob I in position DRUM DISINFECTION, and press Start button H to start the cycle.

The DRUM DISINFECTION programme can be effected at any time or when circumstances require it. Remove the washing in the drum and close the door. Place knob I in position DRUM DISINFECTION, keeping button Prewash, pressed until appears on the display. To start the DRUM DISINFECTION cycle, press the Start button H.

- EASY LOGIC

The EASY LOGIC system automatically regulates the wash time and water and power consumption according to the actual amount of washing placed in the drum.

The 12 load function is therefore redundant in that the EASY LOGIC system automatically sets the wash parameters.

PROGRAM TABLE

PROGRAMS	TEMPERATURE (*)	TYPE OF LAUNDRY	MAX SPIN SPEED (REV/ MIN)	MAX LOAD DEPEND-ING ON THE MODEL AND THE PROGRAM SELECTED (KG)	OPTIONS
				8.0
	90°C	White linens and heavily soiled cotton, including organic stains.	Max 8.0
	60°C	This cycle of washing, centrifuge and drying cycle, corresponds to the standard of reference in accordance with the standard EN50229.	Max 8.0
	40°C	The program ensures the best cleaning efficiency at only 40°C with the maximum saving of electricity.
	20°C	The special program allows you to wash different fabrics together (cotton, synthetics, mixed) with a perfect result.	800 4.0
[DWDS]	40°C	The wool program is ideal for washing delicate items with labels stating “machine washable”. It ensures colour care and that garments stay in good shape.	800 2.0
	35°C	Quick wash cycle is suitable for refreshing, in just 20 minutes, lightly soiled laundry. Quick to save you precious time, performing a wash cycle at 35°C.	800 4.0
	30°C For silk, viscose and lingerie items. 500 2.0
	30°C	The colour program allows you to wash different coloured garments together; you can safely wash light and dark coloured laundry without any risk colours running.	Max 8.0
	40°C	The special jeans program gently washes at 40°C, taking care of the denim fi bres and simultaneously preventing colours from running. Faded denim garments will always come out looking like new.	800 4.0
	40°C	The program reduces ironing time. The temperature, water level, intensity of washing and spin speed are adjusted electronically to prevent creases and making ironing easier.	500 2.0
	40°C	The sportswear program is designed for sports and casual wear. The 40°C wash cycle helps retain the shape of the fabric and the elasticity of modern synthetic fi bres.	800 4.0
	-	The Dry program allows you to dry those clothes already washed that only require drying; also useful to remove moisture from clothing that has to be stored for a long time. If the laundry is a lot wet, to save time and energy, do a spin cycle before drying.	-	5.03.0
	-	The rinse program is useful for re-rinsing hand washed laundry or for refreshing items that have been stored for a long time.	Max 8.0
	- The spin speed is adjustable to suit every type of fabric. Max 8.0
	40°C	The antibacterial program ensures that any germs or bacteria in the laundry are effi ciently removed. The program ensures maximum hygiene for white, coloured and synthetic fi bre fabrics	Max 8.0

(*) Actual water temperature may differ from that indicated in the program.

TECHNICAL SPECIFICATIONS

MODEL WDBIE1485
DIMENSIONS	Width (cm) 59,5
	Height (cm) 82.0
	Depth (cm) 54.5
Maximum spin speed (revs/min)		1400
Maximum load wash (kg)		8
Maximum load dry (kg)		5.0/3.0
The recommended drying time (min)		250'/160'
Pressione dell'acqua		0.05 MPa -1 Mpa
Collegamento elettrico		vedi Targhetta caratteristiche

PRAWIDŁOWY SPOSÓB PRANIA

PRAWIDŁOWY SPOSÓB PRANIA

• CZYSZCZENIE BĘBNA Atton 90° + Prewash ▶ Drum disinfection

This manual can be downloaded at www.freggia.com