SLM8630 - Accessoires pour projecteur Chief - Tasuta kasutusjuhend
Leidke seadme juhend tasuta SLM8630 Chief PDF-formaadis.
Pick your language and provide your email: we'll send you a specifically translated version.
Kasutajate küsimused teemal SLM8630 Chief
0 küsimus selle seadme kohta. Vastake nendele, mida teate, või esitage oma.
Esita uus küsimus selle seadme kohta
Veel pole küsimusi. Olge esimene, kes küsib.
Laadige alla juhend oma Accessoires pour projecteur PDF-formaadis tasuta! Leidke oma juhend SLM8630 - Chief ja võtke oma elektrooniline seade uuesti kätte. Sellel lehel on avaldatud kõik teie seadme kasutamiseks vajalikud dokumendid. SLM8630 kaubamärgi Chief.
KASUTUSJUHEND SLM8630 Chief
SLB-8630 HANGER BRACKET FOR 3M MP8630
Unpack carton and check contents:
| (1) | SLB-8630 | Plate | (2) | U-Form | Rod |
| (4) | 10-24 Lock Nuts | (4) #10 Flatwashers | |||
| (8) | Felt | Squares | (6) | Thumb | Nuts |
INSTALLATION INSTRUCTIONS
- Turn projector upside down.
- Place the SLB-8630 Plate onto the projector bottom.
- Attach the U-Form rods around the projector and up through the two holes in the SLB-8630 plate using the #10 flatwashers and 10-24 nylock nuts. NOTE: The U-Form rods MUST be attached for mount to properly support projector. This is a correct fit. DO NOT OVERTIGHTEN U-Form rod to projector. Only tightened until a secure fit is achieved. Felt squares are provided to protect projector shell, if desired. They can be attached to the projector or wrapped around the U-Form rod.
- See RPA and/or Smart-Lift ^TM Instructions.