Why do the lights on my FABER Arkea 110.0255.506 hood turn on and then immediately off, and how do I replace the light button?

Question

Accepted Answer

If the LEDs of your FABER Arkea 110.0255.506 hood turn on briefly and then immediately off, the most likely cause is a blown or improperly inserted fuse in the lighting unit, or an electrical contact issue at the control panel.

Step one: Check the fuse

Open the lighting unit by pulling firmly on the notch provided for this purpose
Locate the fuse holder situated on the left side of the motor unit
Unscrew the fuse holder and check that the fuse is properly inserted and not burnt out (a broken wire inside indicates a blown fuse)
If it is blown, replace it with a fuse that has the same specifications (check the label on the fuse holder for specifications)
Close the lighting unit and test the lighting by pressing the designated button on the control panel

Step two: Check the lighting buttons

Ensure that the control panel is not damaged and that the light on/off button (marked “Turn On/Off Lights”) is not stuck or defective
Press firmly on the button and hold for a few seconds to ensure it responds correctly

Replacing the LEDs

The LEDs in your hood are special components compliant with the EN 60825-1 standard. You cannot replace them yourself: you must contact FABER customer service or an authorized dealer to obtain a compatible replacement part for your model 110.0255.506 and have it replaced. If the problem persists after checking the fuse and contacts, it is advisable to have a qualified technician intervene.

User manual FABER Lighting : user manuals and guides in PDF

Models FABER Lighting most viewed

Other categories FABER

Recent questions about Lighting FABER