Q: Should the sensitivity potentiometer be set to maximum on the RTF10P?

No, absolutely not. The sensitivity potentiometer on the RTF10P should not be set to maximum. This control is not a volume - it is a gain adjustment to match the amplifier to your audio source. Correct calibration procedure: Set the potentiometer to minimum (turn counterclockwise) Play dynamic music and increase the volume of your source to about 75% of maximum Gradually increase the gain by turning the potentiometer clockwise until you hear distortion Turn it back slightly (about one hour on the dial) to eliminate distortion Stop there: this is the optimal point The amplifier receives signals between 0.1 V and 4 V - setting the potentiometer to full does nothing and risks creating permanent distortion. This adjustment is done only once during installation.

Question 1

Should the sensitivity potentiometer be set to maximum on the RTF10P?

Accepted Answer

No, absolutely not. The sensitivity potentiometer on the RTF10P should not be set to maximum. This control is not a volume - it is a gain adjustment to match the amplifier to your audio source.

Correct calibration procedure:

Set the potentiometer to minimum (turn counterclockwise)
Play dynamic music and increase the volume of your source to about 75% of maximum
Gradually increase the gain by turning the potentiometer clockwise until you hear distortion
Turn it back slightly (about one hour on the dial) to eliminate distortion
Stop there: this is the optimal point

The amplifier receives signals between 0.1 V and 4 V - setting the potentiometer to full does nothing and risks creating permanent distortion. This adjustment is done only once during installation.

Question 2

What settings are available on the MTX Audio RTF10P and how do you configure them?

Accepted Answer

The MTX Audio RTF10P is an amplified subwoofer with few settings, making installation easy. Here’s how to configure the main elements:

Gain Adjustment (Sensitivity)

This is the only volume control available on this subwoofer. The gain potentiometer allows you to adjust the sensitivity from 0.1V to 4V. Recommended procedure:

Turn the gain to minimum at startup
Gradually increase the level until you reach the desired volume
Reduce slightly just before hearing distortion

Audio Connections

The RTF10P offers two types of audio inputs to choose from:

RCA Inputs - for low-level connection from the subwoofer output of your amplifier or receiver
High-Level Inputs - for direct connection to speaker wires if your source does not have a subwoofer output

EBC Remote Control

You can connect a remote EBC control (provided or optional) to adjust the subwoofer level from the front of the vehicle or from your setup.

LED Indicators

A red LED lights up when the amp is operating. If a protection LED also activates, it indicates overheating - check the ventilation.

User manual MTX Audio Speaker : user manuals and guides in PDF

Models MTX Audio Speaker most viewed

Other categories MTX Audio

Recent questions about Speaker MTX Audio