How to connect the hot and cold water hoses to this FRANKE STL-PO-304 faucet?

Q: How to connect the hot and cold water hoses to this FRANKE STL-PO-304 faucet?

The FRANKE STL-PO-304 faucet connects with standard hot and cold water supply hoses. Here’s how to proceed: Connecting the hoses Position the faucet on the sink with a mounting diameter of 35 mm Connect the cold water hose to the cold water supply (usually the lower right inlet) Connect the hot water hose to the hot water supply (usually the lower left inlet) Tighten the connections by hand - do not overtighten Install sealing washers (gaskets) on the threads before tightening to prevent leaks The faucet supports a pressure of 1 to 5 bars . After installation, check for leaks by gradually opening the water supplies. If you detect a leak at the base of the faucet after a few days of use, refer to the section regarding the replacement of the drip-free ceramic cartridge in your manual.

Question

Accepted Answer

The FRANKE STL-PO-304 faucet connects with standard hot and cold water supply hoses. Here’s how to proceed:

Connecting the hoses

Position the faucet on the sink with a mounting diameter of 35 mm
Connect the cold water hose to the cold water supply (usually the lower right inlet)
Connect the hot water hose to the hot water supply (usually the lower left inlet)
Tighten the connections by hand - do not overtighten
Install sealing washers (gaskets) on the threads before tightening to prevent leaks

The faucet supports a pressure of 1 to 5 bars. After installation, check for leaks by gradually opening the water supplies. If you detect a leak at the base of the faucet after a few days of use, refer to the section regarding the replacement of the drip-free ceramic cartridge in your manual.

User manual FRANKE Faucet : user manuals and guides in PDF

Models FRANKE Faucet most viewed

Other categories FRANKE

Recent questions about Faucet FRANKE