Question 1

Where is the fuse for the YORKVILLE PULSE PS210P subwoofer located and how do I replace it?

Accepted Answer

The fuse for the YORKVILLE PULSE PS210P subwoofer is located at the back of the unit, near the power input. It is a small cylindrical element inserted into a fuse holder that is accessible without tools. The exact type of fuse required is 8 amp slo-blo (in North America) or T4A for 230 V export models.

Before starting the replacement, completely turn off the unit and unplug the power cord from the wall outlet. Wait a few seconds to ensure that all circuits are discharged. This precaution is essential to avoid any risk of electric shock when handling the fuse.

To access the fuse, locate the fuse holder at the back of the PS210P, near the power socket. The fuse holder is usually removed by gently twisting it or pulling it straight out. Once removed, examine the condition of the existing fuse. A blown fuse will have a visible broken filament inside the glass tube or a blackened discoloration.

If the fuse is faulty, remove it from the fuse holder and replace it with a new fuse of the same type 8 amp slo-blo. Never replace a fuse with a different amperage model, as this would compromise the electrical protection of the unit. Reinstall the fuse holder by pushing it firmly until it clicks into place.

Plug the power cord back in and turn the unit on to check its normal operation. If the fuse blows again after replacement, this usually indicates that the mains voltage is too high. In this case, try plugging the PS210P into another electrical outlet or circuit. If the problem persists, stop using the unit and contact a qualified technician, as repeated fuse failure may indicate a serious internal electrical problem.

Important: never attempt to bypass the fuse by wrapping it in aluminum foil or any other conductive material. This extremely dangerous practice can cause significant damage to the PS210P or any other electrical equipment, and may even create a risk of fire or electric shock.

Question 2

Why is my microphone not producing sound when I sing with the YORKVILLE AP818 sound system?

Accepted Answer

If your microphone is not producing sound when you sing with the YORKVILLE AP818 sound system, several causes may be behind this issue. Here’s how to identify and resolve the situation:

1. Check the connections

Make sure the microphone is properly connected to the microphone input of the system.
Check that the microphone cable is not damaged or defective.

2. Microphone power

If your microphone requires phantom power (48V), ensure that this function is activated on the YORKVILLE AP818.
Some dynamic microphones do not need power, make sure your model is compatible.

3. Volume and gain settings

Check that the microphone channel volume is sufficiently high.
Check the gain setting to ensure it is not too low or cut off.

4. Channel selection and activation

Confirm that you are using the correct microphone channel on the system.
Make sure the channel is not muted.

5. Test with another microphone

If possible, try another microphone to determine if the problem lies with the microphone or the sound system.

6. Equalization settings

Check that the equalization settings are not cutting off vocal frequencies.

By following these steps, you should be able to identify the cause of your microphone's lack of power. If the problem persists, it may be helpful to have the equipment checked by a professional.

User manual YORKVILLE Sound system : user manuals and guides in PDF

Models YORKVILLE Sound system most viewed

Other categories YORKVILLE

Recent questions about Sound system YORKVILLE