How to reset the SUPRA TINO COMBO heater?

Question

Accepted Answer

The SUPRA TINO COMBO heater does not have a specific reset function in its electronic interface. However, if the device is not functioning properly or stops unexpectedly, you can perform a complete reset by following this procedure:

Turn off the device by pressing the power button.
Unplug the heater from the electrical outlet.
Wait about 15 minutes to allow the electronic system to fully reset and the safety circuits to restart.
Plug the heater back into the electrical outlet.
Turn the device back on by pressing the power button and check for normal operation.

Important points: The TINO COMBO has automatic safety systems that can interrupt its operation. The anti-tip device disconnects the appliance if its working position is not correct (the device must be upright and stable). The thermal safety can also stop heating if overheating is detected. Ensure that the device is properly positioned vertically, that the air intake and outlet grills are not blocked, and that it has good clearance around it.

If after this 15-minute reset and checking the position and ventilation, the heater still does not work properly, contact an authorized SUPRA technical support service, as this may indicate a technical fault requiring professional intervention.

User manual SUPRA Fan heater : user manuals and guides in PDF

Models SUPRA Fan heater most viewed

Other categories SUPRA

Recent questions about Fan heater SUPRA