Q: Where is the oil filter located on the TROY-BILT Bronco 46B?

The oil filter of the TROY-BILT Bronco 46B is part of the Briggs & Stratton 19 HP engine. According to the manual, this filter should be replaced with every oil change, following the maintenance schedule: every 50 hours, 100 hours, or 200 hours of use. Although the manual for this model specifies the procedure for replacing the filter, the notice available on this site does not detail its exact location. However, on this type of riding mower equipped with a Briggs & Stratton engine, the oil filter is generally located directly under the engine cover , often accessible without tools. To access the filter: Lift the engine cover Locate the cylindrical-shaped filter attached to the engine block Turn it counterclockwise to remove it If you have trouble locating it, refer to the full PDF manual (96 pages) available for download on this page, which contains detailed diagrams of the engine. You can also contact Troy-Bilt support for confirmation of the exact location on your model.

Question 1

Where is the oil filter located on the TROY-BILT Bronco 46B?

Accepted Answer

The oil filter of the TROY-BILT Bronco 46B is part of the Briggs & Stratton 19 HP engine. According to the manual, this filter should be replaced with every oil change, following the maintenance schedule: every 50 hours, 100 hours, or 200 hours of use.

Although the manual for this model specifies the procedure for replacing the filter, the notice available on this site does not detail its exact location. However, on this type of riding mower equipped with a Briggs & Stratton engine, the oil filter is generally located directly under the engine cover, often accessible without tools.

To access the filter:

Lift the engine cover
Locate the cylindrical-shaped filter attached to the engine block
Turn it counterclockwise to remove it

If you have trouble locating it, refer to the full PDF manual (96 pages) available for download on this page, which contains detailed diagrams of the engine. You can also contact Troy-Bilt support for confirmation of the exact location on your model.

Question 2

How to remove the tube from the fuel tank?

Accepted Answer

To remove the tube (ventilation or breather tube) located at the top of the fuel tank of your Super Bronco 46K XP, follow these important safety steps:

Safety Preparation

Stop the engine and wait at least 5 minutes before accessing the tank, as per the manual instructions
Ensure that the engine is completely cooled down
Partially or completely drain the fuel using a priming pump to reduce pressure in the system
Work in a well-ventilated area, away from any ignition source

Removing the Tube

Locate the vent tube on top of the 2.5 to 3-gallon (9.46 to 11.35 liters) tank
Gently pull the tube to detach it from the fitting or securing joint
If the tube is tight, check for a clamp or collar to loosen with appropriate pliers
Inspect the rubber seal or grommet to ensure it is not damaged during removal

Tip: Take note of the current configuration (helpful photos) before removal to facilitate the correct reinstallation of the tube.

User manual TROY-BILT Tractor : user manuals and guides in PDF

Models TROY-BILT Tractor most viewed

Other categories TROY-BILT

Recent questions about Tractor TROY-BILT