How to properly connect the suction hose to the DEXTER 710DWS2-225.1001 drywall sander?

Question

Accepted Answer

To connect the suction hose to your DEXTER 710DWS2-225.1001 drywall sander, follow these precise steps:

Always unplug the sander before proceeding with the assembly to ensure your safety.
Loosen the sleeve of the dust extraction port (located on the upper extension shaft). Important: do not completely remove the sleeve, just loosen it.
Before attaching the sanding paper, precisely align the holes of the sanding paper with those of the base plate. This step is essential to ensure effective dust extraction and avoid air leaks.
Gently press the sanding paper to attach it to the base plate.
Insert the suction hose connector into the dust extraction port until it reaches the stop. Make sure it is securely engaged.
Secure the connection by tightening the sleeve on the port. This step prevents any accidental disconnection of the hose during operation.
Then attach the other end of the hose to a suitable vacuum cleaner using the provided vacuum adapter. To remove the hose, simply loosen the sleeve, hold the handles, and pull the connector out of the port.

Important tip: The device can only be connected to one maximum extension tube. Aligning the holes of the sanding paper is crucial as it directly optimizes the suction flow and significantly reduces airborne dust.

User manual DEXTER Plaster sander : user manuals and guides in PDF

Models DEXTER Plaster sander most viewed

Other categories DEXTER

Recent questions about Plaster sander DEXTER