Swarm - Uncategorized 2hp - Free user manual and instructions
Find the device manual for free Swarm 2hp in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Eurorack synthesizer module |
| Brand | 2hp |
| Model | Swarm |
| Width | 2 HP (10.16 mm) |
| Depth | 25 mm (typical Eurorack skiff) |
| Weight | Approximately 30 g |
| Power Supply | +12V: 30 mA, -12V: 20 mA (typical) |
| Power Connector | 10-pin ribbon cable (Eurorack standard) |
| Main Function | Swarm oscillator with detune and spread control |
| Controls | Rate, Spread, and Blend knobs |
| Inputs | CV (control voltage) for rate and spread |
| Outputs | Audio output (mono) |
| Audio Output Level | 10 Vpp typical |
| Construction | PCB with aluminum front panel, skiff-friendly |
| Maintenance | Wipe with dry cloth; avoid liquids |
| Safety | Reverse power protection; use only with Eurorack cases |
| Spare Parts | Contact manufacturer for replacement knobs or PCBs |
Frequently Asked Questions - Swarm 2hp
How do I power the 2hp Swarm module?
Connect the included 10-pin ribbon cable to your Eurorack case's bus board, ensuring the red stripe aligns with the -12V rail. The module draws approximately 30 mA on +12V and 20 mA on -12V.
What is the Swarm module used for?
The Swarm is a oscillator module that generates a detuned 'swarm' of voices, controlled by Rate (speed of modulation), Spread (pitch deviation), and Blend (mix of dry and wet signal).
What are the dimensions of the 2hp Swarm?
It occupies 2 HP (10.16 mm) in width, with a depth of about 25 mm, suitable for most Eurorack skiffs.
Can I use the Swarm with other modular systems?
Yes, it is designed for Eurorack format. Ensure your case has sufficient power and a free 2 HP slot.
What type of outputs does the Swarm have?
It has a single mono audio output with a 10 Vpp signal, suitable for patching into VCA, filter, or mixer modules.
How do I clean the module?
Disconnect power, then wipe the front panel with a dry, lint-free cloth. Do not use liquids or abrasives.
Does the Swarm have reverse power protection?
Yes, it includes reverse power protection to prevent damage if the ribbon cable is connected incorrectly, but always double-check the orientation.
Can I control the Swarm with CV?
Absolutely. It has CV inputs for Rate and Spread, allowing external modulation from sequencers or LFOs.
What if a knob becomes loose or broken?
Contact 2hp support for replacement parts. Knobs can typically be replaced by pulling off and pressing on a new one.
Is there a user manual available?
Yes, you can download the official manual in PDF from the 2hp website or from notice-facile.com for free.
User questions about Swarm 2hp
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Uncategorized in PDF format for free! Find your manual Swarm - 2hp and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Swarm by 2hp.