NVR-327 - Radio NEVIR - Free user manual and instructions

Product Type	Portable Radio
Brand	Nevir
Model	NVR-327
Dimensions (approx.)	200 x 120 x 80 mm
Weight (approx.)	500 g
Power Supply	AC 230V 50Hz or 4 x AA batteries (not included)
Battery Type	AA (1.5V) x 4
Radio Bands	FM 87.5-108 MHz, AM 530-1710 kHz
Tuning Type	Analog dial
Antenna	Telescopic rod antenna for FM, built-in ferrite for AM
Speaker	Single 3-inch, 8 ohm
Audio Output	Built-in speaker, 3.5mm headphone jack
Controls	Volume knob, tuning knob, on/off switch, band selector
Additional Features	AC/Battery auto-switching, carry handle
Cleaning	Wipe with a soft, dry cloth. Do not use liquid cleaners.
Safety	Keep away from water and heat sources. Unplug during storms.
Spare Parts Availability	Contact Nevir support for antennas, knobs, and battery compartments.
Repairability	Designed for professional repair only. Do not disassemble.
Environment	Operating temp: 0-40°C. Storage: -20-60°C.
Warranty	Standard 1-year limited warranty.

Frequently Asked Questions - NVR-327 NEVIR

How do I power the NVR-327 radio?

You can power the radio using the AC cord (230V) or by inserting 4 AA batteries (not included). The radio automatically switches to battery power if AC is disconnected.

How do I tune to a station?

Turn the tuning knob on the front panel to the desired frequency on the AM or FM band. Adjust the volume knob for a comfortable listening level.

Why is the FM reception poor?

Try extending the telescopic antenna fully. For better reception, move the radio near a window or away from electronic devices. AM uses a built-in ferrite antenna, so rotate the unit for best signal.

Can I use headphones?

Yes, plug your headphones into the 3.5mm jack on the side. The built-in speaker will mute automatically.

How do I clean the radio?

Unplug the unit and remove batteries. Wipe the exterior with a soft, dry cloth. Never use water, solvents, or abrasive cleaners.

What type of batteries does it use?

It requires 4 AA (1.5V) batteries. For best performance, use alkaline batteries. Rechargeable NiMH can also be used.

Can I leave batteries in the radio when using AC?

Yes, the radio automatically switches to AC when connected. However, to prevent battery leakage, remove batteries if the unit will not be used for long periods.

The radio does not turn on. What should I do?

First, check if the power cord is properly plugged in or if batteries are inserted correctly and charged. Ensure the on/off switch is in the ON position. If still not working, contact support.

Is there a sleep timer?

No, this model does not have a sleep timer. You must manually turn off the radio.

Can I get spare parts for this radio?

Spare parts such as knobs, antenna, and battery compartment are available through Nevir customer service. Check the official website for information.

USER MANUAL NVR-327 NEVIR

1 SNOOZE (Sono Prorogado)

2 SLEEP (Domir)

1. SNOOZE'SLEEP OFF BUTTON

2. ALARM SET BUTTON

3 TIME SET BUTTON

1. SLEEP SET BUTTON

2. HOUR SET BUTTON

3. MINUTE SET BUTTON

4. ON/OFF/AUTO/ALARM SELECTOR

5. TUNING CONTROL

6. VOLUME CONTROL

10 FM ANTENNA (FOR EXTERNAL ANTENNA)

11 AUTO INDICATOR

12 MAIN PLUG (AC CORD)

13 ALARM OFF BUTTO

14 AM/FM SELECTOR

AC POWER OPERATION

Before connecting to the power supply ensure that the supply corresponds to the information on the rating label on the bottom of the apparatus.

WARNING

Disconnect the mains plug from the supply socket when not in use. To prevent fire or shock hazard do not expose the apparatus to rain or moisture.

CLOCK

1. Set the On/Off/Auto/Alarm Switch (7) to 'OFF'. Connect the Mains Load to the power supply. The clock

display will flash on and off indicating a power interruption and that the display time is incorrect.

1. To set the correct time, press the Time Set together, until the correct time is displayed.

2. Open the Clock Battery Compartment door and sit a PP3 (or equivalent) 9V battery. The purpose of this

Battery is to store the information relating to alarm time, and to keep the clock functioning in the event of

disconnection from the mains supply or power interruption. Should this occur, the clock will continue to keep time, but will not display.

ALARM

1. To set the alarm time, press the Alarm Set Button (2) and Minute Set Button (6), or Hour Set Button (5), together, until the required alarm time is displayed.

2. Switch the On/OFF/Auto/Alarm Switch (7) to either 'AUTO' or 'ALARM' position for choice of wake by

radio or wake by buzzer respectively. The Auto Indicator (11) will illuminate and alarm is now set to

activate at the required time.

1. The alarm can be temporarily stopped for 9 minutes by pressing the Snooze/Sleep Off Button (1). This can be repeated until press the Alarm Button (2).

2. The alarm will activate again after 24 hours unless the On/Off/Auto/Alarm Switch (7) is set to 'OFF'

Note: When setting alarm time always remember to release the Minute Set or Hour Set or Hour Set Button

before releasing the Alarm Set Button to ensure that the real time will not be affected

SLEEP

1. Set the On/Off/Auto/Alarm Switch (7) to 'OFF', 'AUTO' or 'ALARM' position.

2. Press the Sleep Set Button (4) and Minute Set Button (6) together. The sleep time will be displayed and

count down from 59 minutes to zero. Release the button when the required sleep time is displayed

1. The radio will now operate until the sleep time has elapsed or may be switched off by pressing the

Snooze Off Button (1).

KADIO

The FM band required the AC cord for FM ant., this should be uncoiled and positioned for best reception. Set the On/Off/Auto/Alarm Switch (7) to ON' position.

1. Adjust the Tuning Control (8) to select the desired station.

2. Adjust the Volume Control (B) as required

3. To turn off the radio, set the On/Off/Auto/Alarm Switch (7) to 'OFF', if the radio does not switch off this

may be caused by inadvertent operation of the Sleep Set Button (4). To cancel this presses the

Snooze/Sleep Off Button (1) once

1. Adjust the Switch (14) to the required waveband.

BATTERY BACK-UP

Inset a 9-volt battery (not included) in the compartment located in the cabinet bottom; use preferably a long-

life battery. In case of temporary power failure, the battery will keep the time settings even if the display won't show

Note: The effectiveness of this feature depends entirely on the freshness of your battery. The circuit will not

keep the right time if the battery is old or of poor quality

CLEANING

Clean the cabinet with a soft cloth moistened with water or mild detergent. Do not use solvents such as

alcohol, benzene or thinner, as the may damage the cabinet finish. Make sure to disconnect the mains lead from the supply before cleaning. Please retain these instructions for future reference

SPECIFICATIONS

Frequency Range: AM 540-1600KHz

FM 88-108 MHz

Power Source : AC 230V - 60 Hz

DC9V (For back-up)

Power Output: 300 mW

In order to fulfil ruling UNE EN-80065, we indicate that if the flexible wire is damaged, it can only be substituted by a technical service recognized by NEVIR, S.A., as per special fooling is required.