UPS-TRI10K - Inverter Mach Power - Free user manual and instructions

Brand	Mach Power
Model	UPS-TRI10K
Type	Line-interactive UPS
Power Capacity	10 kVA / 9 kW
Input Voltage	208-240 VAC
Output Voltage	208-240 VAC
Frequency	50/60 Hz (auto-sensing)
Waveform	Pure sine wave
Battery Type	Sealed lead-acid (VRLA)
Battery Capacity	External battery pack compatible
Typical Backup Time	10-15 minutes at full load
Number of Outlets	8 (C13 + C19)
Form Factor	Tower / Rack mount 2U
Dimensions (HxWxD)	88 x 438 x 430 mm
Weight	18 kg (without batteries)
Cooling	Forced air, variable speed fan
Communication Ports	USB, RS-232, SNMP slot
LED Indicators	Line, Battery, Fault, Overload
Audible Alarms	On battery, low battery, overload
Surge Protection	RJ45/11, coax, phone line
Operating Temperature	0-40°C
Humidity	0-95% non-condensing
Certifications	CE, UL, EMC

Frequently Asked Questions - UPS-TRI10K Mach Power

What is the typical backup time for the UPS-TRI10K?

At full load (10 kVA), the UPS provides approximately 10-15 minutes of backup. Half load can extend to 20-30 minutes.

How do I connect external battery packs?

The UPS-TRI10K supports external battery packs via a dedicated connector. Refer to the manual for maximum battery capacity and wiring instructions.

Can the UPS be mounted in a rack?

Yes, the UPS-TRI10K is designed for both tower and 2U rack mounting. Rack mount brackets are included.

What type of batteries does it use?

It uses sealed lead-acid (VRLA) batteries. Replacement batteries can be ordered from Mach Power or authorized distributors.

How often should I replace the batteries?

Batteries typically last 3-5 years depending on usage and environmental conditions. Regular self-tests help monitor battery health.

What do the LED indicators mean?

Green: line power. Yellow: on battery. Red: fault or overload. Flashing: low battery. Detailed explanation is in the manual.

Is the UPS compatible with generators?

Yes, but the generator must provide stable voltage and frequency. The UPS may switch to battery if input fluctuates. Use a generator with automatic voltage regulation (AVR).

Can I monitor the UPS via software?

Yes, the UPS includes USB and RS-232 ports. Mach Power provides PowerShield software for monitoring and graceful shutdown.

What should I do if the UPS overload alarm sounds?

Disconnect non-essential devices immediately. The UPS will shut down if overload exceeds 110% for 30 seconds. Ensure total load is below 9 kW.

How do I clean the UPS?

Turn off and disconnect the UPS. Use a dry cloth to wipe the exterior. Do not use liquids or solvents. Keep vents free of dust.

USER MANUAL UPS-TRI10K Mach Power

Black industrial power supply unit with ventilation slots and digital display (no visible text or symbols)

DATASHEET

UPS ONLINE THREE PHASE

10KVA \~ 30KVA

MOELLO: UPS-TRI10K / UPS-TRI20K / UPS-TRI30K

FEATURES

• High frequency and true online double-conversion
• DSP digitali contrai technology
- Input power factor correction (PFC)
- Wide input voltage range (190V - 485V)
• Output power factor 0.9
- Excellent load-carrying capability, linear derating between 50% and 100% load at 190 - 277 Vac
- Optimized battery configuration: 192V / 240V
- Cold start
• Auto sensing frequency
• ECO mode operation for energy saving
- 50 / 60Hz frequency conversion mode
- Selectable output voltage via LCD
- Selectable battery shutdown voltage (EOD) via LCD
- Power-on self test
• Advanced battery management (ABM)
- Short circuit and overload protection
• Automatic charging in OFF mode
• Auto control fan speed when loads varies
- Dual input
- Advanced quick charge technology, charging speed is increased double
- Configurable transfer time from battery to mains power, reducing the impact on grid or generator
- Automatic startup/shutdown function (optional), automatic transfer to bypass at light load, automatic restart at acting load; energy-saving and environment-friendly
• Standard USB communication port
• Standard emergency power off (EPO)
- Standard maintenance bypass
- Optional extension battery bank
- Optional RS465 I SNMP I AS400 communication port
- Optional N+X redundancy parallel up to 6 units
- Optional battery temperature compensation

SPECIFICATION

MODEL	UPS-TRI10K	UPS-TRI20K	UPS-TRI30K
Capacity	10KVA / 9KW	20KVA / 18KW	30KVA / 27KW
INPUT
Rated voltage	360 V /380V /400 V/ 415 Vac
Voltage range	277 - 485 Vac (no derating)
	190 - 277Vac (linear derating between 50% and 100% load)
Rated frequency	50 / 60 Hz (auto-sense)
Frequency range	40 ~ 70 Hz
Power factor	≥ 0.99
Total harmonic distortion THDI	≤5%
Bypass voltage range	-40% - + 15% (settable)
OUTPUT
Voltage	360 V/ 360 V/ 400 V/ 415 Vac (settable)
Voltage regulation	±1%
Frequency	Synchronized with utility in mains mode; 50 / 60 ± 0.1Hz in battery mode
Waveform	Sinusoidal
Crest factor	3:1
Total harmonic distortion THDV	≤ 2% (linear load); ≤ 5% (non-linear load)
Transfer time	Mains mode to battery mode: 0ms; Inverter mode to bypass mode: 0ms
Inverter overload capability	102% - 125%: transfer to bypass in 10 mins;
Bypass overload capability	125% - 150%: transfer to bypass in 1 min;
	> 150%: transfer to bypass in 0.5 s
BATTERIES
DC voltage	240 Vdc; Long time model: 192 Vdc
Inbuilt battery space *	40 x 9Ah	40 x 7/9Ah	60 x 7/9Ah
Typical recharge time	4 Hours
SYSTEM
Efficiency	≥ 93%, ECO mode 96%
Display	LCD+ LED
Alarm	Battery mode, low battery, fans fault etc.

* battery not included

MODEL	UPS-TRI10K	UPS-TRI20K	UPS-TRI30K
Max. parallel numbers	6
EMI	IEC I EN62040-2
EMS	IEC61000-4-2 (ESD)
	IEC61000-4-3 (RS)
	IEC61000-4-4 (EFT)
	IEC61000-4-5 (surge)
COMMUNICATIONS
RS485 / USB I dry contacts	Supports Windows 98 / 2000 / 2003 /XP /Vista/ 2008 / 7 / 8 / 10
SNMP (optional)	Power management from SNMP manager and web browser
OTHERS
Humidity	20 - 90% RH@ O ~ 40°C (non-condensing)
Noise level	≤ 60 dB (1m)	≤ 65 dB (1m)	≤ 65 dB (1m)
Dimensions (WxDxH)	350 x 785 x 868 mm	350 x 785 x 1078 mm	350 x 785 x 1078 mm
Packaged dimensions (WxDxH)	472 x 910 x 1050 mm	472 x 910 x 1260 mm	472 x 910 x 1260mm
Net weight (kg)	115	175	235
Gross weight (kg)	125	190	250

• Derate capacity to 90% when the output voltage is adjusted to 208Vac.

ACCESSORY

External Battery Cabinet for Long Backup (with battery cable and battery breaker)

Technical line drawing of a vertical structural frame with horizontal slats and mounting feet (no text or symbols)

MODEL	UPS-BCTRI	UPS-BCTRI-38A
Dimension (WxDxH)	350 x 785 x 1078mm	950 x 450 x 610mm
Battery Capacity	7groups of 20pcs 7/9Ah	16/20pcs 38Ah