Elibloc 9 ST F/80 - Range hood ELICA - Free user manual and instructions
Find the device manual for free Elibloc 9 ST F/80 ELICA in PDF.
| Product Type | Chimney range hood |
| Brand | Elica |
| Model | Elibloc 9 ST F/80 |
| Width | 80 cm (31.5 inches) |
| Depth | 50 cm (19.7 inches) |
| Height (min/max) | 60 - 100 cm (23.6 - 39.4 inches) |
| Weight | Approx. 15 kg (33 lbs) |
| Power Supply | 220 - 240 V, 50 Hz |
| Motor Power | 200 W |
| Max Extraction Rate | 600 m³/h (212 CFM) |
| Noise Level (max) | 65 dB(A) |
| Lighting | 2 x 20 W halogen or LED (model dependent) |
| Controls | Slider or push-button with electronic display |
| Finishes | Stainless steel / Tempered glass |
| Venting | Ducted (exhaust) or recirculation (with charcoal filter) |
| Air Outlet Diameter | 150 mm (6 inches) |
| Grease Filter | Aluminum mesh, washable in dishwasher |
| Charcoal Filter | Optional, replaceable every 3-6 months |
| Energy Class | A+ (estimated) |
| Maintenance | Clean grease filter monthly, replace charcoal filter as needed |
| Safety Features | Safety switch, thermal protection, anti-return valve |
| Spare Parts Availability | Filters, bulbs, motor, control board available through service centers |
| Warranty | Standard 2 years (subject to local regulations) |
Frequently Asked Questions - Elibloc 9 ST F/80 ELICA
User questions about Elibloc 9 ST F/80 ELICA
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your Range hood in PDF format for free! Find your manual Elibloc 9 ST F/80 - ELICA and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Elibloc 9 ST F/80 by ELICA.
USER MANUAL Elibloc 9 ST F/80 ELICA
EN Instruction on mounting and use
natural_image
Pure electrical circuit lines without any symbols
Sgancio filtro carbone
Carbon filter release
natural_image
Technical line drawing of a mechanical device with a circular component and wiring (no text or symbols)
EN - Instruction on mounting and use
Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. The hood is conceived for the suction of cooking fumes and steam and is destined only for domestic use.
! It is important to conserve this booklet for consultation at any moment. In the case of sale, cession or move, make sure it is together with the product.
! Read the instructions carefully: there is important information about installation, use and safety.
! Do not carry out electrical or mechanical variations on the product or on the discharge conduits.
! Before proceeding with the installation of the appliance verify that there are no damaged all components. Otherwise contact your dealer and do not proceed with the installation.
Caution
WARNING! Do not connect the appliance to the mains until the installation is fully complete.
Before any cleaning or maintenance operation, disconnect hood from the mains by removing the plug or disconnecting the mains electrical supply.
Always wear work gloves for all installation and maintenance operations.
The appliance is not intended for use by children or persons with impaired physical, sensorial or mental faculties, or if lacking in experience or knowledge, unless they are under supervision or have been trained in the use of the appliance by a person responsible for their safety.
This appliance is designed to be operated by adults, children should be monitored to ensure that they do not play with the appliance.
This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance.
Never use the hood without effectively mounted grating!
The hood must NEVER be used as a support surface unless specifically indicated.
The premises where the appliance is installed must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion devices or other fuels.
The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose such as discharging exhaust fumes from appliances burning gas or other fuels.
The flaming of foods beneath the hood itself is severely prohibited.
The use of exposed flames is detrimental to the filters and may cause a fire risk, and must therefore be avoided in all circumstances.
Any frying must be done with care in order to make sure that the oil does not overheat and ignite.
Accessible parts of the hood may become hot when used with cooking appliance.
With regards to the technical and safety measures to be adopted for fume discharging it is important to closely follow the regulations provided by the local authorities.
The hood must be regularly cleaned on both the inside and outside (AT LEAST ONCE A MONTH).
This must be completed in accordance with the maintenance instructions provided in this manual). Failure to follow the instructions provided in this user guide regarding the cleaning of the hood and filters will lead to the risk of fires.
Do not use or leave the hood without the lamp correctly mounted due to the possible risk of electric shocks.
We will not accept any responsibility for any faults, damage or fires caused to the appliance as a result of the non-observance of the instructions included in this manual.
This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
The symbol ■ on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal.
For further detailed information regarding the process, collection and recycling of this product, please contact the appropriate department of your local authorities or the local department for household waste or the shop where you purchased this product.
Additional Installation Specifications:
Use only the fixing screws supplied with the product for installation or, if not supplied, purchase the correct screws type.
Use the correct length for the screws which are identified in the Installation Guide.
In case of doubt, consult an authorised service assistance centre or similar qualified person.
WARNING! Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.
Use
The hood is designed to be used either for exhausting or filter version.
Ducting version
The cooker hood is provided with an upper air exit A with connection ring B, a discharge tube (not provided) should be mounted on the ring for discharging fumes and vapours externally.
Attention! If the hood is supplied with carbon filter, then it must be removed.
Filter version
When there is no exhaust duct for venting outdoors, you can use a carbon filter.
The air is depurated by the filter and put again in the surrounding. To use the appliance in this version, proceeded as follows:
The air is vented outdoors by a duct, passing through the wall units and connected to the connecting ring.
Attention! If the hood is not supplied with carbon filter, then it must be ordered and mounted.
The models with no suction motor only operate in ducting mode, and must be connected to an external suction device (not supplied).
The connecting instructions are supplied with the peripheral suction unit.
Installation
The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must be not less than 65cm from electric cookers and 65cm from gas or mixed cookers.
If the instructions for installation for the gas hob specify a greater distance, this must be adhered to.
Electrical connection
The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area, after installation. If it not fitted with a plug (direct mains connection) or if the plug is not located in an accessible area, after installation, apply a double pole switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over-current category III, in accordance with installation instructions.
Warning! Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that the mains cable is correctly assembled.
Mounting
Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician must verify suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Do not tile, grout or silicone this appliance to the wall. Surface mounting only.
This hood is designed for fitting in a cabinet or on some other support.
Carry out the following instructions for affixing the cooker hood:
Create an opening in the bottom of the cabinet to insert the cooker hood, and drill a hole on the top of the cabinet to fit the discharge tube, connect the cooker hood to an external pipe, predispose the electrical connection, remove the grill or the anti-grease filter, remove the frame C (if provided) by pressing on the two release hooks D (according to the model in possession, the release hook button D may be located externally or inside the cooker hood below the grease filter / grill), insert the cooker hood in the opening (lock in the lateral clasps E if provided by tightening the locking screws F), finally fix the cooker hood to the cabinet with wood screws G supplied. Remount the frame C (if provided), and suction grill H.
Operation
The hood is fitted with a control panel with aspiration speed selection control and a light switch to control cooking area lights.
The switch is located on the side of the suction grill H.
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking.
Maintenance
ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket.
Cleaning
The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat filters) internally and externally. Clean using the cloth dampened with neutral liquid detergent. Do not use abrasive products. DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may cause fire risks.
Therefore, we recommend observing these instructions.
The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations.
Grease filter
Traps cooking grease particles.
If situated inside the support grill, it may be one of the following types:
Paper filter must be replaced once a month or if colouring appears on upper side, in such cases the colouring is evident through the grill openings.
Metallic filter must be cleaned once a month, with non abrasive detergents, by hand or in dishwasher on low temperature and short cycle.
When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity.
To access the grease filter J open the suction grill H via the release hooks L and free from the supports K.
Some models are provided with a metallic filter M without support grill, these should be washed as described above and removed from their housing by pressing the N handles towards the bottom.
Charcoal filter (filter version only)
It absorbs unpleasant odours caused by cooking.
The saturation of the charcoal filter occurs after more or less prolonged use, depending on the type of cooking and the regularity of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least every four months.
The charcoal filter may NOT be washed or regenerated.
May be one of the following:
Rectangular: position the filter P in order to cover the motor protection grill and turn the handle clockwise until locked-in, for dismounting follow instructions in reverse.
Bayonet Circular-Insert position the filter in the centre (in certain cases use the Z hooks for centring the filter) in order to cover the motor protection grill ensuring that the X reference on the carbon filter corresponds to the Y reference on the conveyor, then turn clockwise; for dismounting follow instructions in reverse.
Replacing lamps
Disconnect the appliance from the electricity.
Warning! Prior to touching the light bulbs ensure they are cooled down.
Replace the old light bulb with the one of the same type as specified in the feature label or near the light lamp on the hood.
Remove the anti-grease filter support grill or the anti-grease filter to access the lamp area. Remove the damaged lightbulb and replace with an incandescent oval bulb maximum 40W E14.
In the case where model is provided with a halogen lightbulb, replace with halogen bulb of 20W (GU5.3 - ∅50mm).
If the lights do not work, make sure that the lamps are fitted properly into their housings before you call for technical assistance.
Brand : ELICA
Model : Elibloc 9 ST F/80
Category : Range hood