RS-136 - Radio MAJESTIC - Free user manual and instructions

Product Type	Clock Radio
Brand	Majestic
Model	RS-136
Frequency Range	FM 87.5 – 108 MHz
Power Supply	AC 230V ~ 50Hz, 5W
Backup Battery	1 x 3V CR2032 lithium battery (not included)
Dimensions (approx)	20 x 15 x 10 cm
Weight (approx)	0.5 kg
Alarm Functions	Dual alarms (buzzer or radio), snooze (9 min), sleep timer (10-90 min)
Radio Presets	10 stations
Display	LED with dimmer control (high/low)
Antenna	External FM wire antenna (fully extend for best reception)
Reset	Disconnect AC, remove battery, wait 3 min
Safety Certifications	CE (2014/35/EU, 2014/30/EU, 2009/125/EC, 2011/65/EU)
Cleaning	Mild non-abrasive detergent solution and soft cloth
Operating Conditions	Avoid direct sunlight, extreme temperatures, moisture, dust
Battery Warning	Do not ingest; chemical burn hazard; keep away from children
Disposal	Recycle at collection center; do not dispose with household waste

Frequently Asked Questions - RS-136 MAJESTIC

How do I set the time on the RS-136 clock radio?

Press and hold the CLK.ADJ button until the time flashes. Use the << TUNE DOWN / HOUR button to adjust hours and the >> TUNE UP / MIN button to adjust minutes. Press CLK.ADJ again to confirm.

How many alarms can I set and how do I set them?

You can set two separate alarms (Alarm 1 and Alarm 2). To set Alarm 1, press and hold VOLUME DOWN / ALARM 1 ON-OFF SET; to set Alarm 2, press and hold VOLUME UP / ALARM 2 ON-OFF SET. Adjust hour and minute using the TUNE buttons, then press the same button to save. You can choose between buzzer or radio alarm.

What is the snooze function and how do I use it?

When the alarm sounds, press the SNOOZE/SLEEP/DIMMER button to temporarily silence it. The alarm will sound again after approximately 9 minutes. To cancel snooze, press the POWER ON - OFF / ALARM OFF button.

How do I set the sleep timer?

While in radio mode, press the SNOOZE/SLEEP/DIMMER button repeatedly to select a sleep time from 90 down to 10 minutes (in 10-minute increments). The radio will turn off automatically after the set time. To cancel, press the same button until 'OFF' appears or press the POWER ON - OFF button.

How do I preset and recall radio stations?

Turn on the radio and tune to the desired station. Press and hold CLK.ADJ./MEMORY / M+ until 'PO1' flashes. Press the same button to store the station. Repeat for up to 10 presets. To recall, press the MEMORY button repeatedly to cycle through presets.

What kind of backup battery does the radio use and why?

The radio uses one 3V CR2032 lithium battery (not included) to maintain time and presets during a power outage. Install it following the polarity diagram in the battery compartment. The radio will work without the battery, but settings will be lost if power is interrupted.

How do I adjust the display brightness?

With the radio in standby mode (off), tap the DIMMER button to toggle between high and low brightness. The default setting is low brightness for lower power consumption.

What should I do if the radio stops responding or behaves erratically?

Disconnect the AC power cord and remove the backup battery. Wait at least 3 minutes, then reinsert the battery and reconnect the AC power. This resets the unit, so you'll need to set the time and alarms again.

What cleaning methods are recommended for the radio?

Use a mild non-abrasive detergent solution and a soft cloth to clean the surface. Do not use abrasive cleaners, benzene, thinner, or other solvents. Never insert objects into vents.

Is the radio safe to use with a pacemaker or other medical devices?

The manual does not provide specific medical device compatibility. However, as with any electronic device, it is recommended to maintain a safe distance. If you have concerns, consult your doctor or the device manufacturer.

USER MANUAL RS-136 MAJESTIC

1. This product operates on AC230V\~50Hz power supply. Plug the AC power cord into a household outlet AC source.
2. Clock display will flash 0:00 until set to correct time.

INSTALLING/REPLACING THE BACK-UP BATTERY

This unit is equipped with a battery back-up system, requiring one DC3V CR2032 lithium battery (not included) to maintain the time settings and radio presets during AC power outage.

1. Unscrew and remove the BATTERY COMPARTMENT COVER.
2. Install one fresh CR2032 lithium battery into the battery compartment following the polarity diagram on the BATTERY COMPARTMENT COVER. Use only the specified size and type of battery.
3. Replace the BATTERY COMPARTMENT COVER and tighten its screw.

Note: The unit will operate without a battery installed but your time & alarm setting and radio presets will be lost and will have to be reset in the event of power interruption or failure.

IMPORTANT:

Be sure that the battery is installed correctly. Wrong polarity may damage the unit and void the warranty. For best performance and longer operating time, we recommend the use of good quality battery.

BATTERY CARE:

• Use only the size and type of battery specified.
• If the unit is not to be used for an extended period of time, remove the battery. Old or leaking battery can cause damage to the unit and may void the warranty.
• Do not try to recharge battery not intended to be recharged; they can overheat and rupture (Follow battery manufacturer's directions).
• Do not dispose of battery in fire, battery may leak or explode.

WARNING

DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD

This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.

Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children.

If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.

POWER ON/STANDBY

1. In standby mode, tap the POWER ON-OFF button once to turn on the unit.
2. Press the POWER ON-OFF button once to return the unit to standby mode.

TIME MANUAL SETTING

1. Press and hold the CLK.ADJ button, the time will start to flash.
2. Press the << TUNE DOWN / HOUR button to increase the HOUR.
3. Press the >> TUNE UP / MIN button to increase the MINUTES.
4. Once time is set correctly, press the CLK.ADJ button.

NOTE:

• Press the >> TUNE UP / MIN or << TUNE DOWN / HOUR button once to increase one number at a time.
• Press and hold the >> TUNE UP / MIN or << TUNE DOWN / HOUR button to quickly increase the numbers.

ALARM SETTING

You can preset and store two separate alarm settings. It allows you to set an alarm for yourself and a second as a backup, or use the second independently timed alarm for a partner.

SETTING ALARM 1

1. Please ensure the radio is OFF.
2. Press and hold the VOLUME DOWN / ALARM 1 ON-OFF SET

button to set ALARM

1. The alarm time will flash on the display.
2. Press the << TUNE DOWN / HOUR button to increase the HOUR.
3. Press the >> TUNE UP / MIN button to increase the MINUTES.
4. Press the VOLUME DOWN / ALARM 1 ON-OFF SET button to save the set up
5. To toggle between Buzzer and Radio mode, press VOLUME DOWN/ALARM 1 ON-OFF SET button until the desired option is on display.

- Radio Alarm 1

- Buzzer Alarm 1

ALARM 1 BUZZER INDICATION

ALARM 1 RADIO INDICATION

7:15

1. Once alarm is set, press the ON-OFF / ALARM OFF button to stop the alarm.

SETTING ALARM 2

1. Please ensure the radio is OFF.
2. Press and hold the VOLUME UP / ALARM 2 ON-OFF SET button to set ALARM 2. The alarm time will flash on the display.
3. Press the << TUNE DOWN / HOUR button to increase the HOUR.
4. Press the >> TUNE UP / MIN button to increase the MINUTES.
5. Press the VOLUME DOWN/ALARM 2 ON-OFF SET button to save the set up.
6. To toggle between Buzzer and Radio alarm mode, press the VOLUME UP / ALARM 2 ON-OFF SET button until the desired option is highlighted on the LED display.
7. Radio Alarm 2
8. Buzzer Alarm 2
9. Radio Alarm 2
10. Buzzer Alarm 2

8:15

ALARM 2 BUZZER INDICATION

ALARM 2 RADIO INDICATION

1. Once alarm is set, press the VOLUME UP / ALARM 2 ON-OFF SET button to stop the alarm.

SNOOZE FUNCTION

1. When the alarm (buzzer or radio) is triggered, press the SNOOZE/SLEEP/DIMMER button. The alarm will turn on approximately after 9 minutes.

2. To cancel the SNOOZE function, press the POWER ON - OFF / ALARM OFF button.

LISTENING TO THE RADIO HINTS FOR BEST RECEPTION

FM - To insure maximum FM tuner reception, unwrap and fully extend the EXTERNAL FM WIRE ANTENNA for best FM radio reception.

1. Press the POWER ON - OFF / ALARM OFF button once to turn radio ON.
2. Press the VOLUME DOWN / ALARM 1 ON-OFF SET button to decrease the volume.
3. Press the VOLUME UP / ALARM 2 ON-OFF SET button to increase the volume.
4. Press the << TUNE DOWN / HOUR button to decrease the FM frequency.
5. Press the >> TUNE UP / MIN button to increase the FM frequency.
6. Press the POWER ON - OFF / ALARM OFF button once to turn radio OFF.

TO SET / RECALL THE RADIO PRESETS

You can preset and store the frequency of 10 radio stations in the memory.

1. Press the POWER ON – OFF / ALARM OFF button once to turn the radio ON.
2. Set radio to desired station.
3. Press and hold the CLK.ADJ./MEMORY / M+ button and PO1 will flash on the screen.
4. Press the CLK.ADJ./ MEMORY / M+ button to confirm setting to PO1 or wait 15 seconds for flashing to stop.
5. Repeat the steps above to preset more radio stations.
6. To recall a preset station, press the CLK.ADJ./MEMORY / M+ button to toggle through the current preset radio stations.

The sleep timer allows you to play music for a preset amount of time ranging from 90 minutes to 10 minutes. It is commonly used by people who prefer to go to sleep to music.

1. In radio mode, Press the SNOOZE/SLEEP/DIMMER button. The display will show 90 minutes, your clock radio will turn off in 90 minutes.
2. To change the number of minutes for the SLEEP timer, press the SNOOZE/SLEEP/DIMMER button until you see the desired number of minutes. The SLEEP timer decreases in increments of 10.
3. To cancel the SLEEP timer, press the SNOOZE/SLEEP/ DIMMER button then press again until you see OFF in the display or press the POWER ON - OFF / ALARM OFF button.

DIMMER CONTROL

In radio off mode, Tap the DIMMER button to set the brightness of the LED display to high or low according to your ambient light conditions.

Remark:

1. Clock display with dimmer low" is the default setting.
2. It will consume more power if you set the clock display with dimmer high.

RESETTING THE UNIT

If the system does not respond or exhibits erratic or intermittent operation, you may have experienced an electrostatic discharge (ESD) or a power surge that triggered the internal microcontroller to shut down automatically. If this occurs, disconnect the AC POWER CORD from the wall and remove the backup battery from the compartment. Wait at least 3 minutes, and reinsert the battery for the back-up, and reattach the AC Cord to the wall. The unit is now reset, so you will need to setup the unit time and alarms again.

SPECIFICATIONS

Frequency : FM 87.5 – 108 MHz

Battery backup : 1 x 3V CR2032 flat lithium battery (not included)

Power source : AC 230V \~ 50Hz, 5W

WARNING

1. No naked flame sources, such as lighted candles, should be placed on the apparatus.
2. Do not place the product in closed bookcases or racks without proper ventilation.
3. The mains plug is used as the disconnect device, the disconnect device shall remain readily operable.
4. The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, tablecloths, curtains, etc.
5. It shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus.
6. Do not connect FM antenna to outside antenna.
7. The unit should not be exposed to direct sunlight, very high or low temperature, moisture, vibrations or placed in dusty environment.
8. Do not use abrasive, benzene, thinner or other solvents to clean the surface of the unit. To clean, wipe it will mild non-abrasive detergent solution and clean soft cloth.
9. Never attempt to insert wires, pins or other such objects into the vents or opening of the unit.
10. Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
11. Attention should be drawn to the environmental aspects of battery disposal.
12. Do not dispose this product into usual household garbage at the end of its lifecycle; hand it over to a collection center for recycling the electrical and electronic appliances. By recycling, some of the materials can be reused. You are making an important contribution to protect our environment. Please inquire your community administration for the authorized disposal center.

CAUTION

Danger of explosion if battery is incorrectly replaced Replace only with the same or equivalent type

CE

“CE” marking states that the product is compliant to European Directives: 2014/35/EU Low Voltage Directive
2014/30/EU EMC Directive
2009/125/EC ErP Directive Regulation (EC) n° 1275/2008
2011/65/EU RoHS Directive

It is possible to request a full copy of Declaration of compliance to: New Majestic S.p.A. Via Rossi Martini,41 – 26013 Crema (CR) Italy