CINDERELLA AS 310E - Steam cleaner POLTI - Free user manual and instructions
Find the device manual for free CINDERELLA AS 310E POLTI in PDF.
| Product type | Steam cleaner |
| Brand | POLTI |
| Model | CINDERELLA AS 310E |
| Included accessories | Wand, multi-purpose brush, multi-purpose nozzle, extension tube, crevice tool (optional) |
| Adjustable power | Yes, via suction control |
| Full bag indicator | Red indicator on the hood |
| Motor filter type | Washable, replace every 5 bag changes |
| Microfilter type | Washable, replace every 5 bag changes |
| Dust bag capacity | Fiber bag, visual check via indicator |
| Hanging | Eyelet for wall hook (max load 5 kg) |
| Power cord | With pivot pins for storage |
| Power supply | 220-240V ~50Hz (standard) |
| Approximate weight | Approximately 5 kg |
| Warranty | 1 year against manufacturing defects |
| Maintenance | Clean with damp cloth, no abrasive products |
| Safety instructions | Do not vacuum liquids, hot or sharp objects |
Frequently Asked Questions - CINDERELLA AS 310E POLTI
User questions about CINDERELLA AS 310E POLTI
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your Steam cleaner in PDF format for free! Find your manual CINDERELLA AS 310E - POLTI and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. CINDERELLA AS 310E by POLTI.
USER MANUAL CINDERELLA AS 310E POLTI
USO CORRECTO DEL PRODUCTO
MANUTENTION GENERALE
- Handle
- Motor
- Rotating hooks for cable storage
- Power supply cable
- Handle locking screw
- Mains ON/OFF switch
- Suction variator
- "Full bag" red indicator light
- Cover of bag/filter housing
- Microfilter cover
- Dust bag
- Dust bag support
- Motor filter
- Microfilter
- Socket for carpet sweeper accessory
- Eyelet
a) Lance
b) Multipurpose brush
c) Multipurpose nozzle
d) Extension tube
e) Carpet sweeper (optional)
Polti S.p.A. reserves the right to change equipment or accessory specification without prior notice.

This unit conforms with EC-directives 89/336 as amended by 93/68 (EMC) and 73/23 as amended by 93/68 (low voltage).
CORRECT USE OF THIS PRODUCT
This appliance is intended for use as a vacuum for solids in accordance with the descriptions and instructions in this manual.
PREPARATION FOR USE
1.a Before using the vacuum cleaner, assemble the handle (1)
2.a Remove the locking screw (5) from the handle (1) and locate it in the power plant (2) (fig. 1)
3.a Tighten the screw (5) with the wrench n. 6 supplied, turning it clockwise (fig. 2)
4.a Fix the rotating hooks for cable storage (3) in the holes of the handle (1) by pushing them until they are correctly located.


SUCTION
The appliance is now ready to operate
1.b Connect the accessory required for the cleaning operation.
2.b Connect the supply cable to the mains and push the mains ON/OFF switch
3.b Variable suction (7) allows you to control the suction power according to the surface to be cleaned.
4.b By moving the variable suction slider (7) to the left in the max direction, the power of the appliance will increase
The minimum position is suggested for curtains.
The medium position is suggested for carpets and upholstery.
The maximum position is suggested for hard floors.


MAINTENANCE
Before any kind of maintenance, make sure that the supply cable is not connected to the mains.
REPLACING THE DUST BAG
1.c When the dust bag is full, the indicator light (8) will go from green to red (fig. 5). The fullness of the bag can only be correctly seen when the appliance is operating at maximum power (regulator turned towards max mark).
2.c Lay the appliance on the floor.
3.c Remove the cover (9) (fig. 6) by pushing the opening button.
4.c Take out the dust bag support (12) by pushing it backwards and then lift it by holding the flap (Z), paying attention not to damage it.


5.c Fold the flap (Z) on itself so as to fill the hole and avoid dust leakage.
6.c Insert the new dust bag (11) adapting it to the housing and keeping the flap (Z) upwards, insert the opposite side of the flap in the grooves at the bottom of the housing, as shown in fig. 8.
7.c Insert the sleeve in the hole of the bag.
8.c Put the cover (9) back in its position
CLEANING OR REPLACING THE MOTOR FILTER
It is recommended to clean the filter every two times you replace the dust bag. It is recommended to replace the filter every five times you replace the dust bag.
1.d Lay the appliance on the floor
2.d Remove the cover of bag/filter housing (9)
3.d Take out the dust bag (11), as described in the "Replacing the dust bag" paragraph.
4.d Take out the motor filter (13) as shown in fig.
5.d Wash it with water and soap, rinse it and leave it to dry well. If the filter is damaged, replace it.
CLEANING OR REPLACING THE MICROFILTER
It is recommended to clean the filter every two times you replace the dust bag. It is recommended to replace the filter every five times you replace the dust bag.
1.e Lift the cover (9) which holds the microfilter and it will unhook.
2.e Remove the microfilter (14) from its position (fig. 11) to clean it with soap and water, rinse it and leave it to dry.
3.e Put the filter (14) back in its correct position and close the cover (10).
Cinderella can be hung from the eyelet (16) on a hook, which must be capable of carrying at least 5 kg.
CLEANING THIS APPLIANCE
Wipe the body of the appliance and the accessories with a damp cloth and then dry.
Do not use abrasive products.






PRECAUTIONS
Attention! Do not use the appliance without reading the instructions.
- In case of damage or malfunction, do not attempt to disassemble the appliance but contact the nearest Polti Authorised Service Centre.
- Do not allow children to use the machine or any others who may not know how to operate it.
- Do not touch the appliance with wet hands or feet when it is plugged into the mains.
- In order not to compromise the safety of the appliance, only use original spare parts and accessories, approved by the manufacturer.
- Do not use the appliance if the supply cable or other important parts of the unit are damaged.
- If the supply cable is damaged, it must be replaced by the manufacturer or by its authorized Service Centre.
- Do not suck up undiluted acids or solvents, which may cause serious damage to the appliance and especially do not suck up explosive liquids, inflammable gases, explosive powders, benzines, paints, fuel oil, which may cause explosions if they come in contact with the sucked up air.
- Do not use the appliance outdoor or on wet surfaces or to suck up liquids.
- Do not suck up hard or sharp objects, hot cinders or lit cigarettes or simulars.
- Do not use the appliance in environments where there is danger of explosion.
- Do not suck up objects on fire or that are hot.
- Never immerse the appliance in water.
GUARANTEE
The CINDERELLA AS310 is guaranteed to the original purchaser for one year from purchase date against manufacturing or raw material defects. The guarantee is not valid if the appliance has been misused in any way. Unauthorized alterations or repairs to the machine will automatically invalidate this guarantee.
- Polti declines liability for any damage or accident derived from any use of CINDERELLA AS 310 which is not in conformity with the instructions contained in this booklet.
ATTENTION
The filters and the dust bags are sold by Polti authorized Service Centres and by quality electrical retailers. We recommend to use manufacturer's original spare parts only.
