97H300 - Uncategorized Verto - Free user manual and instructions
Find the device manual for free 97H300 Verto in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Power Tool |
| Brand | Verto |
| Model | 97H300 |
| Dimensions (L x W x H) | 250 x 120 x 80 mm |
| Weight | 1.5 kg |
| Power Input | 800 W |
| Voltage | 230 V ~ 50 Hz |
| No-Load Speed | 0-3000 rpm |
| Chuck Capacity | 1-10 mm |
| Protection Class | II |
| Cable Length | 2 m |
| Housing Material | Reinforced plastic |
| Cooling | Fan cooled |
| Overload Protection | Yes |
| Soft Start | Yes |
| Lock-on Button | Yes |
| Variable Speed | Yes |
| Forward/Reverse | Yes |
| Auxiliary Handle | Included |
| Depth Stop | Included |
| Carrying Case | Included |
Frequently Asked Questions - 97H300 Verto
How do I change the drill bit?
First, ensure the drill is unplugged. Loosen the chuck by turning it counterclockwise, insert the new bit, and tighten clockwise. Use the chuck key if required.
What is the maximum drilling diameter in wood?
The maximum drilling diameter in wood is 25 mm. For metal, it is 10 mm; for masonry, 12 mm.
How to use the forward/reverse switch?
The forward/reverse switch is located near the trigger. Slide it to the right for forward rotation (drilling) and to the left for reverse (unscrewing). Always wait for the chuck to stop before switching.
Why does the drill stop during use?
Possible reasons: overload protection activated, carbon brushes worn, or battery discharged (if cordless). For corded models, check power supply and reset overload protection if applicable.
How to clean the drill?
Unplug the drill. Use a dry cloth to wipe the exterior. Clean the chuck and air vents with a brush. Do not use water or solvents.
What type of oil is recommended for maintenance?
Use a few drops of light machine oil on the chuck and gearbox if recommended. Refer to the manual for specific lubricants.
Can I use the drill with an extension cord?
Yes, but use a cord rated for the drill's power. Ensure the extension cord is fully unwound and has a minimum cross-section of 1.5 mm² for lengths up to 25 m.
How to replace the carbon brushes?
Unplug the drill. Unscrew the brush caps on the motor housing, remove worn brushes, and insert new ones. Ensure they slide freely. Reinstall caps and run the drill for a few minutes to seat brushes.
What does the lock-on button do?
The lock-on button allows continuous operation without holding the trigger. Press the trigger, then press the button. To release, press the trigger again.
Is the drill suitable for metal drilling?
Yes, it can drill metal up to 10 mm. Use appropriate HSS drill bits and apply cutting oil for better performance and longer bit life.
User questions about 97H300 Verto
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Uncategorized in PDF format for free! Find your manual 97H300 - Verto and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. 97H300 by Verto.