M0018 - Uncategorized Emos - Free user manual and instructions

Product Type	Voltage Tester (VT-110)
Brand	Emos
Model	M0018
AC Voltage Measurement (Non-Contact)	70-250 VAC
DC Voltage Measurement	Up to 250 VDC
Polarity Check (Contact Method)	1.5-36 VDC
Microwave Leakage Detection	Yes
Electronic Component Check	Bulbs, diodes, transistors, capacitors, resistors
Battery Type	GP 399, GP 356, GP 351, GP 352 (or equivalent LR44)
Self-Test Function	Yes, by touching upper and lower contacts
Safety Features	Overvoltage protection, insulated casing
Compliance	CE, relevant EU directives
Manual Languages	English, Slovak, Polish, Hungarian, Slovenian, Latvian, Estonian, Bulgarian, Croatian, Serbian, etc.
Battery Replacement	Unscrew upper cap, replace batteries, screw back
Usage Warnings	Do not use without cap, avoid contact method if voltage unknown

Frequently Asked Questions - M0018 Emos

How do I test AC voltage with this device?

Use the non-contact method: hold the tester near the conductor. The red LED will light up if AC voltage is present in the range 70-250 VAC.

What batteries does the M0018 use?

It uses button cell batteries type GP 399, GP 356, GP 351, or GP 352. These are equivalent to LR44 batteries.

How do I replace the batteries?

Unscrew the upper cap of the tester in a counterclockwise direction. Remove the old batteries and insert new ones, then screw the cap back on.

Can I test DC voltage with this tester?

Yes, the tester can measure DC voltage up to 250 V using the contact method. Touch the probes to the positive and negative terminals.

What is the self-test function?

To perform a self-test, touch the upper and lower contacts simultaneously. If the red LED lights up, the tester is functioning correctly.

How do I check polarity with this device?

Use the contact method: touch one pole of the source with your hand and the other pole with the tester's probe. The red LED indicates polarity.

Can I detect microwave leakage with this tester?

Yes, hold the tester near the microwave door edges and glass. The red LED will light up if microwave leakage is detected.

What electronic components can I test?

You can test bulbs, diodes, transistors, capacitors, and resistors. The LED indicates continuity or proper function.

Is the device safe to use?

Yes, it has safety features including overvoltage protection. Always follow the manual and do not use if the cap is missing.

Where can I find the Declaration of Conformity?

The Declaration of Conformity can be found at http://www.emcure.com/ (as stated in the manual).

USER MANUAL M0018 Emos

GB | Voltage Tester VT-110

New Invention and Safety Tester VT-110. It allows you to check/test with safety, quickly and accurately many electrical features.

Tested features

• AC voltage test Non-contact method from 70–250 V AC

- DC voltage test Up to 250 V DC - Polarity test 1.5 V, 76 V DC

• Potarity test 1.5 V – 36 V DC • Continuity check 0–50 MO

• Microwave leakage detection > 5 mW/cm ^2

BATTERIES REPLACEMENT

1. Unscrew the upper cap (contact) completely in anticlockwise direction

2. Gently straighten the wire over batteries

3. Replace the batteries

4. Replace the batteries.

5. Align the batteries and

6. Screw the upper contact in clockwise direction

Suitable batteries

type: GP 392, GP 396, GP 397, GP 192; Battery life: Min. 5 hours of continuity operation.

OPERATION GUIDE

Self-test

Prior to use, please perform a Self-test to ensure guaranteed Indication. We must touch the Driven

Blade and other hand touching the upper contact. Red LED lights up indicating normal function.

Microwave leakage detection

Hold the Driven Blade of the tester. While microwave oven is working, move the tester slowly goes and around the door edge and also front glass of oven. The red LED lights up, if microwave

over and around the door edge and also leakage is detected.

Testing AC Voltage - non-contact method

Hold the tester and touch the upper contact. To locate "Live/Hot" side of wire, gently trace the tester along the wire. Live/Hot side is indicated by the red LED.

along the wire. Live/Hot side is indicated by the red LED.

Polarity check – contact method

You can locate voltage polarity in the range 1.5–36 V. Touch one pole of power source with one hand and other pole with the tester. With hand which is handling the tester touch the upper pole

hand and other pole with the tester. With hand which is handling the tester touch the upper pole of the tester. The tester touches the positive pole, if the red LED lights up.

Electronic Component Check - contact method

Bulb – Hold the bulb socket. Touch the bottom contact of bulb with the tester and touch the upper

contact of the tester with your finger. The bulb is functional, if the red LED lights up.

Fuse - Process is the same as bulb. Coils and resistors. Process is the

Coils and Resistors - Process is the same as Bulb. Diodes - Process is the same as Bulb. The red LEF

Light in reverse direction.

Capacitor - Process is the same as Bulb. If the capacitor is OK, the red LED lights up and slowly no down.

go down. Transistors: PNP – Touch the emitter or collector. Then touch the base with the tester. The red LED

lights up, if the transistor works correctly.

Transistors: NPN – Touch the base. Then touch the emitter or collector with the tester. The red LED lights up, if the transistor works correctly.

▲ CAUTION

CAUTION

- Never use the tester without the upper cap

- Never test the voltage with contact method, if you don't know exactly its range. You can test only the voltage range, which is safe for current environment.

- You can test only the voltage range, which is safe for current environment - Handle the tester according the valid standard

This product is not to be used by persons (including children), whose physical, sensual or mental

abilities or lack of experience and knowledge does not ensure safe use of the appliance, unless

they are supervised or unless they have been instructed about the use of this appliance by a person in charge of their safety. Supervision over children is required to prohibit them from playing

Join in charge of their safety. Supervision over Children is required to prohibit them from playing with the appliance.

Do not dispose with domestic waste. Use special collection points for sorted waste. Contact

local authorities for information about collection points. If the electronic devices would be

■ disposed on landfill, dangerous substances may reach groundwater and subsequently food chain, where it could affect human health.

Emos snols r.o. declares that the VT-110 is in compliance with the essential requirements and other

Elmos sports is declared that the VP 11015 in compliance with the essential requirements and other relevant provisions of Directive. The device can be freely operated in the EU. The Declaration of

Conformity can be found at http://www.emos.eu/download.

No kisistite spout has pannian polravul

- Ne konsite aparat bez gomijeg pokrova: Ne vlasite napan kontalitna, vislike piste ugovati ojevove to knom vallinov

- Ne hijenice napon kontakano, ukoliko histe upoznati s njegovom tochom ve - knitivačem mojeto mieriti samo napon koji je siguran za odrošenu sredinu

- Ispitovacemi možete imjenki samlo naporn koji je siguran za određenu sredinu 5. onerstom redite norma udrési (2)N

• 3 aparatom radite prema vazecuj CSIV Cupl varifai na emily krasit(Ni pasha (vdivitive diary), lved kallh Nielasna, ulina ilmentalna nea

The following table is provided in the image.

1.1.2.

UA | Тестер напруги VT-110

1 1 1

https://www.hocai.601988/

The Ground Truth image displays a single, solid horizontal line. According to Rule 2 (UNDERSCORE & LINE RULES), if the GT contains lines used for stylistic emphasis or as background elements (like ruled paper), the OCR result must ignore them. The line in the GT is clearly a stylistic or background line, not a placeholder for text. Therefore, the OCR should not have output any underscores. Outputting `____` constitutes an error under Rule 2, as it hallucinates placeholder symbols where none are semantically intended. Hence, the OCR result is inconsistent with the Ground Truth.

- Potanticated 1.5 V=30 V DC - Continuous conductance 0.50 MO

• Confrontalea conducilor 0–30 MΩ Radiatii nu mirovan de 1.5 mW/cm²

• Nadiați cu microbunde > 5 MW/cm ^-1

ÎNLOCUIREA BATERIILOR

STVENUES WE HETENEGS WE ETTE VENTURES