PDM3131 - Massage device HMS Premium - Free user manual and instructions

Product Type	Percussion Massage Device
Brand	HMS Premium
Model	PDM3131
Dimensions (L x W x H)	215 x 60 x 230 mm
Net Weight	0.83 kg
Gross Weight	1.3 kg
Power Supply	230 V AC (charger); Rechargeable battery 16.8 V, 1500 mAh
Charging Time	2.5 - 4 hours
Working Time (Full Charge)	120 minutes (approx.)
Motor Power	50 W
Speed Range	1500 - 3300 rpm (10 gear levels)
Vibration Amplitude	7 mm (linear movement)
Number of Massage Heads	6
Display	LED screen (speed level indicator)
Noise Level	35 dB
Material	ABS plastic, silicone massage heads
Automatic Shutoff	After 10 minutes of continuous use or excessive pressure
Warranty	24 months (consumer), 12 months (commercial)
Included in Box	Massage device, 6 massage heads, charger, storage cover, user manual
Compatible Charger	Only original charger (230 V input)

Frequently Asked Questions - PDM3131 HMS Premium

How do I turn on the PDM3131 massage device?

Press the ON/OFF button (button 2) at the bottom of the screen. The device will start at speed 1 (1300 rpm). Increase or decrease speed using the + and - buttons (button 4).

What is the maximum speed and how many speeds are there?

There are 10 speed levels. Level 1 is 1300 rpm, and each additional level increases by 500 rpm, up to a maximum of 3300 rpm (some sources indicate 3500 rpm).

How long does it take to charge the battery fully?

Charging time is approximately 2.5 to 4 hours. The battery indicator lights during charging and turns off when fully charged.

Can I use the device while it is charging?

No, for safety reasons, do not use the device while charging. Always turn off and disconnect before charging.

How long does the battery last on a full charge?

The working time is approximately 120 minutes, but may vary depending on the speed level used. Higher speeds consume more power.

What massage heads are included and how do I change them?

The set includes 6 different massage heads for various body parts. To change, simply pull out the current head and push the desired one into the round hole at the front of the device.

How do I clean and maintain the device?

Wipe the surface with a slightly damp towel and dry with a soft cloth. Do not immerse in water. For storage, separate the device from the battery and place in the original case.

Is it safe to use on bare skin?

No, always use the device over dry, clean clothing or a towel to avoid skin injury. Do not massage the same area for more than 60 seconds.

What should I do if the device stops automatically?

The device has an automatic shutoff after 10 minutes of continuous use or if excessive pressure is applied. Simply turn it on again to continue.

What is the warranty period for the PDM3131?

The warranty is 24 months for consumer use and 12 months for commercial use from the date of purchase. It covers manufacturing defects but not mechanical damage or misuse.

USER MANUAL PDM3131 HMS Premium

Black massage tool with circular head and blue accent stripe (no text or symbols visible)

Six black plastic mechanical components with no visible text or symbols

Użytkowanie

Simple line drawing of a trash bin with two crossed lines indicating no waste or prohibition (no text or symbols)

1) Battery power indicator
2) Power ON/OFF button
3) Gear indicator. For 01 gear, pulse frequency is 1500 rpm, if you add one gear the frequency will increase 500 rpm, the highest grade is 10, and the top speed is 3300 rpm.
4) Increase/ decrease buttons
5) 6 kinds of massage heads

Black handheld massage tool with a circular head and handle, labeled with dimension line '1' (no text or symbols on the device itself)

Instructions for use:

Six black plastic mechanical components with no visible text or symbols

1. According to the needs of different parts, select the appropriate massage head to insert into the round hole in front of the massager
2. Click (2) button at the bottom of the screen-and the massager starts running, the number of the screen represents speed level, each + click button, increase the gear position by one gear, 01 speed is 1300 rpm, every additional gear increased speed by 500 rpm, the highest gear is 10 gears and the speed is 3500 rpm. Once you click - button, the machine minus one gear. In any gear position (01-10).
3. After the massage is complete, push the ON/OFF button
4. In order to protect the machine, the massager will stop running automatically if it is running continuously for more than 10 minutes, or if the pressing force is too big, please turn it on again if you need to keep using it.

Battery use instruction

When the battery is exhausted, it needs 1.5-2.5 hours to be fully charged. The battery working time is determined by the gear position. The battery power-on indicator lights up when the battery is charging, it will stop flash when fully charged. For your safety, you should never turn on the machine when the battery is charging.

Safety instruction

To reduce the risk of electric shock, fire and personal injury, this product must be used in accordance with the following instructions.

1. Only allowed for adults use.
2. This device cannot directly massage the surface of the skin to avoid injury to the skin, the massage area should be worn after wearing dry and clean clothes or a clean and dry towel. You need to gently press and move, the massage time of the same part can not exceed 60s.
3. Use high speed and high pressure only for soft tissue parts of the body without causing pain and discomfort, do not use high speed and high pressure on the head and any bone parts of the body.
4. According to the massage needs of different parts, please choose the right massage head.
5. Frequent use of high-speed high pressure to apply pressure on the same part will cause abrasions, if you feel painful and uncomfortable, please stop using immediately.
6. Finger, hair or any part of the body, please keep away from the telescopic rod of the device and the heat dissipation hole of the motor to prevent from pinching injury.
7. Do not place anything in the heat sink of the motor.
8. Keep away from water
9. Do not discard and misuse the device
10. Use only original charger.
11. Carefully check your device and battery before use.
12. Do not make any changed in the device
13. Do not use the device and charge it in same time.

Maintenance

1. Wipe the surface of the device with a slightly damp towel and dry with a soft cloth.
2. When storing or traveling for a long time, separate the device from the battery and place it in the device's original case.

Warning:

1. Do not stay in the water, keep the machine away from liquids and heat sources, to ensure the motor cooling holes are free of dust and debris.

2. Do not remove the screws by yourself.

3. Turn off the device after one hour of operation and use it after rest for half an hour.

4. Remove the charger from the battery after charging, and do not use the device during charging.
5. The use of this device for the injured part of the body is prohibited without consulting the doctor.

Speed level:	1 ÷ 10
Vibration frequency (linear move):	7mm
Screen type:	LED
length (mm):	215
width (mm):	60
height (mm):	230
Motor power	50W
Output speed/ frequency	1500-3300 rpm
ZPower suply	230V
Battery:	16,8V
Power type	akumulator
Charging time	2,5-4h
Battery capacity	1500mAh
Working time after full charge	120min
Qty of massage head	6
Noise level	35dB
Included in set	cover
Material:	ABS; Silicon
GW/NW	1,3/ 0,83kg

Symbol of a trash bin crossed with a diagonal line, representing no waste or discharge (no text or labels)

Labelling the product with a symbol of a crossed waste container informs us that the worn-out electrical and electronic equipment cannot be put into the same container as other waste. According to the WEEE Directive on the management of electrical and electronic waste, separate recycling methods shall be used for this type of equipment.

A user who wants to dispose of such product is obliged to transfer it to the collection centre for worn-out electrical and electronic equipment, thanks to which they support its re-usage, recycling or recovery and thusly protect natural environment. For this purpose, one should contact the equipment seller or representatives of local authorities. Hazardous components contained in electronic equipment may have long-lasting harmful impact on natural environment as well as adverse effect on human health.

Popis produktu

Black handheld massage tool with a circular head and cylindrical body, labeled with the number 1 (no text or symbols on the device itself)

Six black plastic mechanical components with no visible text or symbols

Použití

Six black plastic mechanical components with no visible text or symbols

Benutzungshinweise

Simple line drawing of a trash bin with no text or symbols

1. The Seller provides guarantee on behalf of the Guarantor within the territory of the Republic of Poland for the period of 24 months from the date of sale.

In the case of sales and use product for the commercial purposes warranty period is equal 12 MSC from sales data

1. The Guarantee will be recognised by the shop or service centre after the client provides:

- clearly and correctly filled-in guarantee card with the sale stamp and the seller's signature - valid purchase confirmation for the equipment including the date of sale / bill / - complained product.

1. Possible defects and damages revealed during the guarantee period shall be remedied free of charge within not more than 21 days from the delivery of the product to the shop or service.

2. Should it be necessary to import some components, the guarantee term can be extended by the period required to import such part, however such period shall not be longer than 40 days.

3. The guarantee does not cover:

- mechanical damages and subsequent defects,

- damages and defects resulting from incorrect storage and usage of the equipment against its purpose,- incorrect assembly and maintenance,

- damages and consumption of such elements as: cables, straps, rubber parts, pedals, sponge grips, wheels, bearings, etc.

1. The guarantee expires in the event of:

- expiry of the validity term,

- self-repairs,

- failure to follow the rules of correct operation.

1. No duplicates of the guarantee cards shall be issued.
2. The product handed over for repair should be complete and clean. If some parts are missing, the service is entitled to refuse to accept the product for repair. The service may refuse to accept a dirty product or clean in on the client's expense after the client's written permit.
3. The guarantee does not cover activities related to assembly, maintenance, which, according to the instruction, the user is obliged to perform themselves.
4. The Guarantor also informs that they offer post-guarantee service.
5. The product should be provided in its original packaging and should be secured for shipment.

The guarantee for sold goods is not exclusive, does not limit or suspend entitlements of the buyer resulting from the non-compliance of the product with the agreement.

Notes on the course of repairs

Item	Date of notificacion	Date of provision	Course of repairs	Signature of the recipient (shop, owner)

ABISAL

ZÁRUČNÍ LIST