CDS 220 N/1-S - Dishwasher CANDY - Free user manual and instructions

USER MANUAL CDS 220 N/1-S CANDY

EN User instructions

		●				○				5	N.V.
●	●	●	●	●	○	75°C	○	○		120	JA
	●	●	●	●		65°C	○		○	95	JA
●	●	●	●	●	○	70°C			○	60	JA
●	●	●	●	●		45°C			○	160	JA
	●	●	●	●		45°C	○		○	80	JA
		●●		●●		50°C			○	32	N.V.

Thank you for choosing a Candy appliance; quality dishwashers which guarantee high performance and reliability.

Candy manufacture a vast range of domestic appliances: washing machines, washer/dryers, cookers, microwave ovens, ovens and hobs, refrigerators and freezers.

Ask your dealer for the catalogue with the complete range of Candy products. Please read this booklet carefully as it provides important information regarding the safe installation, use, and maintenance of the machine, together with some useful advice on how to achieve the best results from your dishwasher.

For future reference please keep this instruction booklet in a safe place.

CUSTOMER SERVICE AND GUARANTEE

Your new appliance is fully guaranteed by the manufacturer for 12 months against electrical/mechanical breakdown excluding:

A. Any faults which occur due to bad installation or misuse of the machine.

B. Any faults which occur due to repair of, or interference with, the machine by any person not authorised by the manufacturer to carry out service.

C. Any faults which occur due to any parts which are fitted to the machine which are not the original manufacturers parts.

D. Any faults arising from non-domestic use or unusual or abnormal use of the machine.

E. Any faults arising from operation at incorrect voltage.

F.Any faults arising from incorrect operation of the machine. The guarantee applies to Gt Britain and Northern Ireland only, and is an addition to your statutory rights.

AFTER SALES SERVICE

For service and repairs call your local engineer on our national telephone number:

GIAS Service

Tel: [phone]

Support Service

(Eire 018301 666)

CONTENTS

Description of the control panel

pag. 17

Technical data

pag. 17

Programme selection and special functions

pag. 18

Programme guide

pag. 20

Water softener unit

pag. 22

DESCRIPTION OF THE CONTROL PANEL

A B C D E F

A "HALF LOAD" option button

D Programme selector

B "ON/OFF" button

E "SALT EMPTY" light

C Door handle

F Indicator light "WASHING"

DIMENSIONS:

Height	cm	82÷88,5
Depth	cm	55
Width	cm	59,8
Depth with door open	cm	117

TECHNICAL DATA:

EN 50242 place load	12
Capacity with pans and dishes	8 persons
Water supply pressure	Min. 0,08 - Max 0,8 MPa
Fuse	(see rating plate)
Power input	(see rating plate)
Supply voltage	(see rating plate)

PROGRAMME SELECTION AND SPECIAL FUNCTIONS

(Use in conjunction with programme guide)

Setting a programme

WARNING!

Before setting any programme, the programme selector must be in the "RESET" position and the indicator light "WASHING"( ▶II ) must be off. Make sure that the "ON/OFF" ( ① ) button is pressed in.

To set the programme, press the "ON/OFF" button: then turn the dial (in a clockwise or anti-clockwise direction) until the pointer (●) is in line with the symbol of the required programme.

After about 4 seconds, the indicator light "WASHING" will come on.

After an audible signal has sounded, the programme will start automatically.

WITHIN 2 minutes of the programme commencing another programme can be selected, simply turning the programme selector to the required position.

IMPORTANT

While a programme is running, the programme selector will remain in the selected position, and will NOT MOVE.

Option button

"HALF LOAD" button 1/2

In response to your everyday washing requirement in addition to the normal wash functions this dishwasher is equipped with the "HALF LOAD" function. This function enables the uses to wash a reduced number of dishes yet retaining the freedom of loading them both on the top and bottom basket. When this function is activated the dishwasher will automatically reduce the water and energy consumption and the wash time. When selecting the "HALF LOAD" ensure a reduced amount of detergent is used.

The option button can be selected or deselected WITHIN 2 minutes of the programme commencing.

Interrupting a programme

Opening the door is not recommended while a programme is running, especially during the main washing phase and final drying.

However, the dishwasher will stop automatically when the door is opened.

If the door is opened during a programme, the indicator light "WASHING" will start flashing, up to when you re-close the door. At this point, the programme will restart from where it had been interrupted.

WARNING!

If you open the door during the drying cycle, an audible audio signal advises you that the drying cycle has not yet finished.

If you wish to change or cancel the programme that is running, carry out the following:

turn the programme selector to "RESET" position. After a few seconds the indicator light "WASHING" will go off.

A new wash setting can now be made.

WARNING!

Before starting a new programme, you should check that there is still detergent in the dispenser. If necessary, top up the dispenser.

If there is any break in the power supply while the dishwasher is operating, a special memory stores the selected programme and, when the power is restored, it continues where it left off.

End of programme

A 5 second alarm will sound (if not muted) 3 times at 30 second intervals to signal that the programme has ended. The indicator light "WASHING" will start to flash.

Turn the programme selector to "RESET" position, wait until the indicator light "WASHING" goes off and press the "ON/OFF" button.

Alarm mute for the PROGRAMME END

The alarm for the programme end may be muted as follows:

IMPORTANT

The dishwasher must be ALWAYS off before start this procedure.

1. When the dishwasher is off, OPEN the door.

2. Turn the programme selector to the "RAPID" programme position.

3. Press the "ON/OFF" button.

4. WITHIN around 15 seconds, turn the dial (in a clockwise direction) to the "RESET" position and then go back to the "RAPID" programme position again, doing this 4 times (finishing with programme selector on the "RAPID" programme position).

5. The indicator light "WASHING" will come on.

6. Turn the programme selector (in a clockwise direction) to the "RESET" position (the indicator light "WASHING" will start to flash to indicate that the alarm has been deactivated).

7. Turn off the dishwasher pressing the "ON/OFF" button to confirm the new setting.

Toturn the alarm on again, follow the same procedure from step 1 to 4 and when the indicator light "WASHING" will come on, turn the dishwasher off by pressing the "ON/OFF" button to confirm the new setting.

WARNING!

If any problem occurs, turn the dishwasher off by pressing the "ON/OFF" button and start the procedure again from the beginning (STEP 1).

Setting of new programme

Whenever you want to set a new programme, you MUST turn the programme selector to "RESET" position and wait for the "WASHING" indicator light to go off.

Troubleshooting

While you are setting a programme, the indicator light "WASHING" will start flashing very quickly (and the alarm will sound) if the electronics detect some incorrect programming function.

In this event, turn the programme selector to the "RESET" position, wait for the

"WASHING" indicator light to go off and turn off the dishwasher pressing the "ON/OFF" button.

After checking to make sure the water inlet hose tap is open, that the drain hose is not bent and that the siphon or filters are not clogged, set the selected programme again.

If the anomaly persists, contact Customer Service Department.

IMPORTANT

This dishwasher is equipped with an anti-overflow safety device which will automatically discharge any excess water should a problem occur.

WARNING!

To ensure the correct operation of the anti-overflow safety device, we recommend that the dishwasher is not moved or tilted during operation. If however it is necessary to tilt or move the dishwasher, please ensure that the washing cycle is complete and that there is no remaining water inside the dishwasher.

PROGRAMME GUIDE

Programme

Description

	COLD RINSE	Short cold pre-wash for items that are stored in the dishwasher until you are ready to wash a full load.
	HYGIENIC 75°C	Once a day - for heavily soiled pans and any other items that have been left all day for washing.
	UNIVERSAL 65°C	Once a day - for normal soiled pans and any other items that have been left all day for washing.
ACLASS 1h	A CLASS 1 h 70°C	Suitable for heavily soiled items that are to be washed straight after a meal. (Max 8 place load)
ECO	ECO 45°C	Energy Saving Programme suitable for normal soiled items. Using detergents with enzyme. Programme standardised to EN 50242.
	DELICATE 45°C	Suitable for delicate crockery and glassware. Also for less soiled items excluding pans.
	RAPID 32' 50°C	Quick wash for dishes which are to be washed immediately after the meal. Wash load of 4/6 persons.

Wash with soaking cycle (Prewash)
If setting the HYGIENIC programme, a second dose of about 20g of detergent (1table-spoon) must be added directly in the dishwasher. For A CLASS 1h programme add 5g .

Check list

Programme contents

Average duration in minutes

Special function buttons available

Dotorgent for soaking (Prewash)

Detergent for washing

Clean filter

Check rinse aid dispenser

Check salt container

Hot pre-wash

Cold pre-wash

Main wash

First cold rinse

Second cold rinse

Hot rinse with rinse aid

		●				○				5	N/A
●	●	●	●	●	○	75°C	○	○		○120	YES
	●	●	●	●		○65°C	○		○	95	YES
●	●	●	●	●	○	70°C			○	60	YES
●	●	●	●	●		○45°C			○	160	YES
	●	●	●	●		○45°C	○		○	80	YES
		●●		●●		50°C			○	32	N/A

N/A = OPTION NOT AVAILABLE

WATER SOFTENER UNIT

Depending on the source of the supply, water contains varying amounts of limestone and minerals which are deposited on the dishes leaving whitish stains and marks. The higher the level of these minerals present in the water, the harder the water is. The dishwasher is fitted with a water softener unit which, through the use of special regenerating salt, supplies softened wafer for washing the dishes. The degree of hardness of your water can be obtained from your water supply company.

Regulating the water softener

The softener unit can treat water with a hardness of up to 90^ fH (French grading) or 50^ dH (German grading) through 6 different settings.

The table below lists different degrees of water hardness with the corresponding setting for the softener unit.

Level	Water hardness		Use of regenerating salt	Water softener setting
	^a H (French grading)	^b dH (German grading)
0	0-5	0-3	NO	Position 1
1	6-15	4-9	YES	Position1
2	16-30	10-16	YES	Position 2
^* 3	31-45	17-25	YES	Position 3
4	46-60	26-33	YES	Position 4
5	61-90	34-50	YES	Position 5

* The water softener unit is set in the factory at level 3, as this is suitable for the majority of users.

According to the degree of hardness of your water, regulate the softener unit in the following way:

IMPORTANT

The dishwasher must be ALWAYS off before start this procedure.

1. When the dishwasher is off, OPEN the door.
2. Turn the programme selector to the "UNIVERSAL" programme position.
3. Press the "ON/OFF" button.
4. WITHIN 15 seconds, turn the dial (in a anti-clockwise direction) to the "RESET" position then go to the "UNIVERSAL" programme position again, doing this 4 times (finishing with the programme selector on the "UNIVERSAL" programme position).
5. The indicator light "WASHING" will flash 3 times and the alarm will sound 3 times, to indicate the factory water softener setting (LEVEL 3).
6. Turn the programme selector to one of the inclusive positions among 1 and 5 to choose the required water softener level.
7. The indicator light "WASHING" will flash and the alarm will sound some times, according to the select level (for example, 5 times for the LEVEL 5).
8. Turn off the dishwasher pressing the "ON/OFF" button to confirm the new setting.

WARNING! If any problem occurs, turn the dishwasher off by pressing the "ON/OFF" button and start the procedure again from the beginning (STEP 1).

RESET Level 0/1 Level 2 Level 5 Level 3 ("UNIVERSAL" programme) Level 4

Enhorabuena,

		●				○				5	N.D.
●	●	●	●	●	○	75°C	○	○		120	SI
	●	●	●	●		65°C	○		○	95	SI
●	●	●	●	●	○	70°C			○	60	SI
●	●	●	●	●		45°C			○	160	SI
	●	●	●	●		45°C	○		○	80	SI
		●●		●●		50°C			○	32	N.D.

Programme

Description

●

○

5

N/A

●

●

●

●

●

○

75°C

○

○

○120

OUI

●

●

●

●

○65°C

○

○

95

OUI

●

●

●

●

●

○

70°C

○

60

OUI

●

●

●

●

●

○45°C

○

160

OUI

●

●

●

●

○45°C

○

○

80

OUI

●●

●●

50°C

○

32

N/A

N/A = OPTION NON DISPONIBLE

ADOUCISSEUR D'EAU

		●				○				5	N/A
●	●	●	●	●	○	75°C	○	○		120	JA
	●	●	●	●		65°C	○		○	95	JA
●	●	●	●	●	○	70°C			○	60	JA
●	●	●	●	●		45°C			○	160	JA
	●	●	●	●		45°C	○		○	80	JA
		●●		●●		50°C			○	32	N/A

The manufacturer declines all responsibility in the event of any printing mistakes in this booklet. The manufacturer also reserves the right to make appropriate modifications to its products without changing the essential characteristics.