Blackview GBV4000 - Smartphone iGET - Free user manual and instructions

Brand	iGET
Model	Blackview GBV4000
Product Type	Smartphone
Display	Tempered glass
Water Resistance	IP68 (1 m depth for 30 minutes, not salt water)
Network Bands	GSM: 850/900/1800/1900; WCDMA: 2100/900
WiFi	2.4 GHz (2412–2472 MHz)
SIM Card Slots	2 Micro SIM
Memory Card Slot	1 Micro SD
Charging Port	Micro USB (rubber armored)
Battery	Lithium-ion, rechargeable
Weight	Approx. 200 g
Dimensions (approximate)	150 x 80 x 15 mm
Operating Temperature	-10°C to +40°C
Warranty	24 months
Security	IP68, tempered glass, moisture label
Accessories	Charger, screwdriver, screws

Frequently Asked Questions - Blackview GBV4000 iGET

Is the Blackview GBV4000 waterproof?

The phone has an IP68 rating, meaning it is resistant to water up to 1 meter depth for 30 minutes. However, this does not apply to salt water, and resistance is not guaranteed in all conditions.

How many SIM cards can I use?

The GBV4000 supports 2 Micro SIM cards simultaneously.

Can I use a micro SD card?

Yes, the phone has a dedicated slot for a Micro SD card (up to capacity not specified). It is separate from the SIM slots.

How do I charge the phone?

Use the included charger with a Micro USB connector. The port is covered by a rubber armor. Do not force the connector. Disconnect when fully charged.

What is the warranty period?

The product comes with a 24-month warranty (unless stated otherwise). The warranty card is on the last pages of the manual.

How to install SIM and SD cards?

Turn off the phone, remove the back cover (not screwed), take out the battery, remove any protective film, insert the Micro SIMs and Micro SD, reinsert the battery, and fasten the cover with the supplied screws using the screwdriver.

What to do if the phone gets wet?

Even though it is water-resistant, it is recommended to dry the phone after contact with water or any liquid. The phone contains a moisture label that turns red if moisture enters; this may void warranty.

Is the screen scratch-resistant?

The display is made of tempered glass, which provides higher resistance to scratches and impacts. However, it can crack if dropped on a hard surface.

Can I use the phone while driving?

No, it is a safety precaution not to use the phone while driving.

How to update the software?

The manual advises to update your device as soon as a new software version is available. Check the manufacturer's website or use the built-in update feature.

USER MANUAL Blackview GBV4000 iGET

Symbol of a trash bin crossed with two crossed lines, no text or numbers present

CZ

Symbol of a trash bin crossed with no text or numbers, representing waste sorting or disposal (no text present)

SK

Symbol of a trash bin crossed with no text or numbers, representing environmental restriction (no text present)

Individual parameters, description by figures and design in the manual may differ depending on the version and updates.

Printing errors reserved.

Update your device as soon as a new version of software is available.

The warranty card is on the last pages of this manual.

Update your device as soon as a new version of software is available.

The buyer is obliged to provide a serial number on the warranty card as well as in the delivery note and the proof of purchase. In this context, the buyer acknowledges that unless the serial number of goods is not marked on the proof of purchase, delivery note and in the warranty card and therefore it cannot be possible to compare this serial number marked on goods and its protective packaging with the serial number stated in the warranty card, delivery note and the proof of purchase and thus to verify that the goods runs from the seller, the service center is competent to claim such a goods automatically and reject it immediately. The buyer must instruct all persons to whom the goods would be subsequently sold. Product complaints do with your dealer if you are not on the web www.iget.eu indicated otherwise.

EN

Safety use:

GBV4000 has an increased resistance. However, it is not mechanically undestroyable.

The display is made of tempered glass, which ensures higher resistance. When dropped on a hard surface or sharp object, it may crack. The display cracked due to mechanical damage or improper misuse of the device is not covered by warranty.

The GBV4000 has the IP68 certification under EN60529:1991+A1:2000+A2:2013 standard.

(According to producer 1 m depth for 30 minutes. IP68 resistance does not apply to salt water.)

The IP68 protection does not guarantee 100% resistance to water in all conditions.

We also recommend that you let your phone dry after contact with water or other liquid.

The warranty is not applied to an intentional damage to the phone.

Installing SIM MICRO and SD cards

Before the cards are installed, the phone must be turned off.

1. Remove the back cover of the phone (only attached but not screwed).
2. Remove the battery of the phone and also remove protective film that overlaps the contacts.
3. You can use 2 MICRO SIM and 1 Micro SD on the GBV4000.

EN

1. Insert the battery back into the phone.
2. Then, fasten the rear cover using the screwdriver and the supplied screws.

Charging the battery:

Before putting your phone into service you must recharge its battery.

1. Connect the adapter to the charger connector.
   The GBV4000 has a Micro USB connector in an extended version due to its rubber "armor". Do not use violence when connecting the connector.
2. Connect the charger to the wall outlet.
3. If the battery is fully charged, disconnect the phone from the charger.

Switching the phone on / off / sleep mode

Make sure that the phone has a SIM card and the battery is fully charged.

Press the ON button to switch on the phone.

Switch off the phone by pressing ON and select OFF. Confirm it by pressing OK.

Press shortly ON button to switch the phone over to the sleep mode.

Safety Precautions:

Do not use your phone while driving

Do not use your phone at the petrol stations.

Hold the phone at least 15 mm from your ear and body.

The phone produces a bright or flashing light.

EN

The small parts of the phone can cause suffocation.

Do not expose your phone to open fire.

The phone can produce a loud sound.

The phone is not resistant to fillings.

Avoid exposure to magnetic fields.

Keep the phone away from medical devices.

Avoid extreme temperatures (-10°C, +40°C).

On request, turn off your phone in hospitals and other medical facilities.

Keep the phone dry.

On request, turn off the phone at airports and on planes.

Do not dismantle the phone.

Turn off the phone in the vicinity of explosive materials and chemicals.

Use the phone only with certified equipment.

Do not reckon only upon your phone during emergency situations.

The phone contains a label that detects moisture. In case of moisture inside phone this label becomes red. The manufacturer has the right to reject a warranty with such a damaged phone.

Damages requiring professional repair:

If such cases may occur, please, contact the authorized service or your distributor:

Moisture got into the phone.

The phone is mechanically damaged. The phone is extremely overheated.

1) For household use: The given symbol (crossed-out wheeled bin) on the product or at accompanying documents means that used electrical and electronic products should not disposed of with household waste. To ensure proper

Simple line drawing of a trash bin with crossed lines indicating no waste or discharge (no text or symbols)

disposal of the product, hand it over to a designated collection point, where it will be accepted free of charge. The correct disposal of this product will help to save valuable natural resources and prevent any potential negative impacts on the environment and human health, which could otherwise be caused by inappropriate disposal of wastes. For more details, please, contact your local authorities or the nearest collection point. The improper disposal of this waste can be penalized in accordance with national regulations. Information for users to disposal of electrical and electronic devices (corporate and business use): For proper disposal of electrical and electronic devices, ask for details from your dealer or distributor. Information for users to disposal of electrical and electronic devices in other countries outside EU: The above mentioned symbol (crossed-out wheeled bin) is valid only in the countries of EU. For proper disposal of electrical and electronic devices, ask for details from your

EN

authorities or dealer. All is expressed by the symbol of crossed-out wheeled bin on product, packaging or in printed materials.

2) Set up the claim for warranty repair of device at your dealer. If you have technical questions or problems, contact your dealer. Follow the rules for working with electrical equipment. The user may not dismantle the device or replace any part of this. Opening or removing the covers poses the risk of electric shock. In case of incorrect reassembly and subsequent connection you are also exposed to electric shock.

Declaration of Conformity:

Company INTELEK spol. s r.o. hereby declares that all GBV4000 devices are in compliance with essential requirements and other relevant provisions of Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available on this website www.iget.eu.

The warranty period of the product is 24 months, unless stated otherwise.

This device can be used in the following countries:

AT	BE	CY	CZ	DK	EE	FI	MT	NL	PL	PT	SK
SI	ES	DE	GR	HU	IE	IT	LV	LT	GB	IS	LI
NO	CH	BG	HR	RU	RO	FR	SE	LU	TR

Restrictions on WiFi use

	IT
	NO

Italy - The conditions for using the WiFi network are described in the so-called Electronic Communications Code

Norway - The 2.4 GHz limitation applies only to the area 20 km from colony of Ny-Ålesund.

RoHS:

The components used in the device meet the requirements on the restriction of hazardous substances in electrical and electronic devices in accordance with Directive 2011/65/EU. The RoHS declaration can be downloaded from www.iget.eu.

Operation of radio equipment:

CZ: This radio equipment can be operated in the Czech Republic under the General Authorizations VO-R / 1 / 05.2017-2 and VO-R / 12 / 09.2010-12. SK: This radio equipment can be operated under General Authorizations VPR - 07/2014, VPR - 02/2017 and VPR - 35/2012.

Maximum EIRP:

Max. 2W / Max. 1W.

Frequency range:

GSM: 850/900/1800/1900

WCDMA: 2100/900

2.4G WiFi (20 MHz): 2412 – 2472 MHz

2.4G WiFi (40 MHz): 2422 - 2462 MHz

Producer / Exclusive importer of iGET products to EU:

INTELEK spol. s r.o., Ericha Roučky 1291/4, 627 00 Brno - Černovice, CZ web: http://www.iget.eu

SUPPORT: http://www.iget.eu/helpdesk Copyright © 2017 Intelek spol. s r.o. All rights reserved.

Instrukcja:

PL

Symbol of a trash bin with crossed lines indicating no waste or discharge, and a solid black rectangle below (no text or labels)

Serial / Batch number: (S/N)

Date of sale:

Warranty until:

Sale document number:

Seal of the store:

Information for Customers about Warranty Terms

and Conditions:

Warranty shall apply to defects of purchased product, found during its warranty period. When purchasing a particular product, please consider carefully what properties and functions you expect your product to have. The fact that purchased product shall not satisfy your later requirements shall not give any reason for complaint. Please, prior to the first use of this product read carefully its operating instructions and follow these

WARRANTY CARD

instructions consistently.

We recommend you to keep original product packing during the warranty period for possible transport of the product in such a way so as to prevent any product damage during its transport and handling.

For the purpose of due application of any complaint about the product we recommend you to ask Seller to fill-in and confirm this Warranty Card including identification of serial number of purchased product, which shall comply with the serial number specified both in the document proving product purchase and delivery note and purchased product.

In this connection Customer hereby takes into account that unless this Warranty Card specifies serial number of purchased product, i.e., comparison of such serial number identified in the product with the serial number identified in this Warranty Card and document of product purchase/or delivery note shall not allow to confirm that particular product has come from Seller, in case of any doubts about the origin of such particular product Seller shall be entitled to automatically and without any other acts to reject the complaint of such goods.

Warranty shall not apply to:

-product damage suffered by unqualified installation of firmware or its modification;

-product damage by static electricity;

-product use for any other purposes than designed, described in attached operating instructions;

-damage to warranty seal of the producer, attached to the product;

WARRANTY CARD

-product damage inconsistent with the operating instructions, technical standards or safety regulations valid in the Czech Republic;

-product damage resulting from normal wear and tear;

-discharged batteries, decrease in battery capacity caused by its wear and tear;

-product defects caused by the use in dusty, polluted or in any other way dissatisfactory environment pursuant to attached operating instructions.

Wear and tear of the product and its components caused by their common use (discharged batteries, decreased capacity of accumulator, wear and tear of mechanical or displaying components, wear and tear of supply cables, headphones etc.) shall be subject neither to defect warranty nor quality warranty in the moment of take-over.

Furthermore, complaints about product parameters, not included in the operating instructions or in any commercial-technical documentation of Seller, related to the product, shall not be subject to quality warranty in the moment of take-over.

Proof of product purchase, or delivery note, shall constitute an integral part of this Warranty Card.