CeramicCare 3in1 AirBrush Elite - Hair Straightener CECOTEC - Free user manual and instructions

USER MANUAL CeramicCare 3in1 AirBrush Elite CECOTEC

Pink and black electric hair brush with a circular grille, no visible text or symbols on the device itself.

Safety instructions 8

1. Parts and components 40

2. Before use 40

3. Operation 41

4. Cleaning and maintenance 41

5. Troubleshooting 42

6. Disposal of old electrical

and electronic appliances 43

1. Copyright 43

2. Simplified EU Declaration of Conformity 43

SOMMAIRE

EN • The coding in this manual is generic and applies to all code variants of the appliance.

Read the following instructions carefully before using the appliance. Keep this instruction manual for future reference or new users.

- All safety instructions must be closely followed when using the appliance.

- Ensure that the mains voltage matches the voltage specified on the appliance rating label and that the plug is earthed.

- This appliance is designed for domestic use only and is not intended for bars, restaurants, farmhouses, hotels, motels, and offices.

- If the appliance is to be used in a bathroom, it must be unplugged from the wall socket after use, as the proximity to water could be a risk even with the appliance switched off.

- As additional protection, it is recommended that a Residual Current Device (RCD) having a rated operating fault current not exceeding 30 mA be installed in the electrical circuit supplying the bathroom. We recommend you ask a qualified installer for advice.

- This appliance can be used by children aged from 8 years and above and people with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning

use of the appliance in a safe way and understand the hazards involved. Children must not play with the appliance. Cleaning and user maintenance must not be carried out by unsupervised children.

• This symbol means that the appliance must not be used in bathtubs, showers, or any other water-filled tank.
• WARNING: do not use this appliance near bathtubs, showers, sinks or other containers filled with water.
• Do not immerse the cord, plug, or any other non-removable part of the appliance in water or any other liquid or expose electrical connections to water. Make sure your hands are dry before handling the plug or switching on the appliance.
• This symbol means: "Caution, hot surface".

• Check the power cord regularly for visible damage. If the cord is damaged, it must be replaced by Cecotec's Official Technical Support Service to avoid any danger.
• Ensure that the air inlets and outlets are not blocked.
• Turn off and unplug the appliance from the power supply immediately after use.

• Immediately unplug the appliance from the socket in these cases:

• Abnormal operation.

• Cleaning.

• After use.

• Do not insert metal objects through the air inlets to avoid electric shocks.

• Do not wind the power cord around the appliance.
• Keep your face, neck, and scalp away from the appliance.

• Do not leave the appliance on any surface while in operation.

• Do not use the appliance to comb wigs, natural hair extensions, fake hair, or animal hair.

• The air inlet ensures good ventilation of the appliance. Do not cover or obstruct it, as this may cause overheating.
• Do not insert objects in the air inlet.

INSTRUCTIONS DE SÉCURITÉ

The graphics in this manual are schematic representations and may not exactly match the product.

2. BEFORE USE

• This appliance comes in a packaging designed to protect it during transport. Take the appliance out of its box and remove all packaging materials. You can keep the original box and other packaging materials in a safe place to prevent damage to the appliance if you need to transport it in the future. If you wish to dispose of the original packaging, make sure all items are recycled properly.
• Check that all parts and components are included and in good condition. If any of them are missing or damaged, please contact the official Cecotec Technical Support Service immediately.
• Do not remove the serial number of the appliance in order to keep a correct traceability of it in case of assistance.

Box content

• Hot air brush
• 3 attachments
• Instruction manual
• Comb and clips

3. OPERATION

1. Make sure that the mains voltage matches the voltage specified on the product's rating label and that the plug is earthed. Plug the appliance into the mains.
2. Press the power button to turn on the brush. The default mode is the lowest temperature mode.
3. Press the power button again to switch to medium temperature mode and press the button a third time to switch to warm air mode.
4. From the warm air mode, press the power button to turn off the brush.

Fitting the attachments

• To fit an attachment, place it onto the brush handle by aligning the slots and then turn it clockwise until you hear a click.
• To remove it, slide down the attachment release button. Then turn the attachment anticlockwise and pull it upwards to separate it from the handle.

WARNING:

Do not force the removal of the attachment, as this could break the locking mechanism. If it offers too much resistance when turning it, make sure that the release button is in its lowest position.

Using the brush

Basic hair drying tips:

1. Wash your hair with shampoo and towel-dry to remove excess moisture, then section your hair.
2. Dry the roots with a hairdryer before using the brush.
3. Take a section of hair and pass the brush from roots to tips, always directing the airflow towards the hair, not the scalp.
4. To prevent over-drying, do not concentrate heat on a single section of hair for too long. Keep the brush moving while in use.

WARNING: Keep the brush's air inlet grille clean and unobstructed.

4. CLEANING AND MAINTENANCE

Note: Before performing any of the following operations, ensure the brush is unplugged from the mains.

ENGLISH

1. Remove any hair residue or dirt trapped between the bristles using a comb or small brush.
2. Gently clean the ceramic barrel and bristles with a soft, slightly dampened cloth. Do not use chemical products or abrasive detergents that could damage the ceramic surface.
3. Use a soft, damp cloth to clean the product's surface.
4. You can remove the air inlet grille by pulling the tabs. Use a soft brush or cotton bud to clean the air inlet.
5. Never immerse the device in water or other liquids.
6. Do not use scouring pads, powders, or abrasive cleaning products to clean the product.
7. Do not twist, bend, stretch, or damage the power cord.
8. Clean any dirt and hair that may block the appliance.

Storage

• Store the brush in a dry place protected from dust.
• Avoid wrapping the power cord around the brush, as this could damage it.

5. TROUBLESHOOTING

Problem Possible causes
The brush does not work properly.	- Check if it is properly connected to the mains.- Make sure it is not in the off position.- Check the plug.
Hot air does not come out.	- Make sure it is not in the cool air position.- Turn off and unplug the appliance from the mains and allow it to cool properly.- Before turning it on again, check there is nothing obstructing the air inlet.

WARNING:

Do not attempt to repair the appliance yourself. If the problem persists after performing the checks described, please contact authorised personnel, the shop where you purchased the product, or Cecotec's Official Technical Support Service.

6. DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES

This symbol indicates that, according to the applicable regulations, the product and/or batteries must be disposed of separately from household waste. When this product reaches the end of its service life, you must remove the batteries/accumulators and take it to a collection point designated by local authorities. For detailed information on how to properly dispose of electrical and electronic equipment and/or the corresponding batteries, consumers should contact their local authorities.

Compliance with the above guidelines will help protecting the environment.

7. COPYRIGHT

The intellectual property rights over the texts in this manual belong to CECOTEC INNOVACIONES, S.L. All rights reserved. The content of this publication may not, either in part or in its entirety, be reproduced, stored in a retrieval system, transmitted or distributed by any means (electronic, mechanical, photocopying, recording or similar) without prior authorisation from CECOTEC INNOVACIONES, S.L.

8. SIMPLIFIED EU DECLARATION OF CONFORMITY

CE Cecotec Innovaciones hereby declares that this appliance complies with the essential requirements and other relevant provisions of applicable European Union regulations. This appliance has been designed, manufactured and tested in compliance with required safety and quality standards. The full text of the EU Declaration of Conformity can be found on the following website: https://cecotec.es/es/information/declaration-of-conformity

FRANÇAIS

1. PIÈCES ET COMPOSANTS

Img. 1

5. PROBLEEMOPLOSSING