FBL760599 - Toilet Vevor - Free user manual and instructions

Product Type	Toilet Safety Rails
Brand	Vevor
Model	FBL760599
Maximum Load	300 lb (136 kg)
Raised Height	3.5 in (89 mm)
Product Dimensions	440 × 610 × 275 mm
Net Weight	2.01 kg
Material	Steel with Coating
Usage	Toilet Riser with Armrests
Installation	Attaches under existing toilet seat (bolts included)
Maintenance	Clean with mild detergent and warm water; dry thoroughly
Package Contents	Seat, rails, L-shaped tubes (long and short), C-clips, bolts, wing nuts, washers
Warranty	3 years
Safety Standards	Do not exceed 300 lb; use on a flat and stable surface
Repairability	Replacement parts available via Vevor
Country of Manufacture	China

Frequently Asked Questions - FBL760599 Vevor

How to install the Vevor FBL760599 toilet safety rails?

Installation is simple: remove the existing seat, place the raised seat with the rails, then secure everything with the provided bolts and wing nuts. Follow the detailed steps in the manual.

What is the maximum weight capacity of this product?

The maximum load is 300 lb (136 kg). Never exceed this limit to avoid risk of injury or damage.

Are the rails compatible with all toilets?

They fit most standard toilets. Check that the mounting holes align with those on your toilet bowl before purchase. The manual recommends confirming compatibility before first use.

How to clean and maintain the safety rails?

Clean regularly with a mild detergent and warm water, then rinse and dry thoroughly. Avoid abrasive products that could damage the coating.

What to do if parts are missing or damaged?

Do not attempt to assemble the product. Contact Vevor customer service at www.vevor.com/support to obtain replacement parts.

Can this product be used with a raised toilet?

Yes, it is a toilet riser with armrests. It adds 3.5 inches (89 mm) of extra height.

Is there a warranty?

Yes, Vevor offers a 3-year warranty against defects in materials and workmanship. It is valid for the original purchaser and non-transferable.

Can the rails be disassembled for transport?

Yes, the product can be easily disassembled by removing the C-clips and bolts. Keep the parts for reassembly later.

Is this product suitable for people with reduced mobility?

Yes, it provides extra support for standing up and sitting down. However, consult a healthcare professional to ensure it meets your specific needs.

Can I use this product without the original seat?

No, the riser attaches under the existing seat. You must keep the original seat and lid for installation.

USER MANUAL FBL760599 Vevor

Technical Support and E-Warranty Certificate www.vevor.com/support

TOILET SAFETY RAILS

MODEL: FLB760599

We continue to be committed to providing you with tools at competitive prices. "Save Half", "Half Price", or any other similar expressions used by us only represent an estimate of savings you might benefit from buying certain tools with us compared to top brands, and do not necessarily mean to cover all categories of tools offered. We kindly remind you to verify carefully when placing an order with us to ensure you are actually saving half in comparison with the top major brands.

VEVOR®

TOUGH TOOLS, HALF PRICE

TOILET SAFETY RAILS

MODEL: FBL760599

NEED HELP? CONTACT US!

Have product questions? Need technical support? Please feel free to contact us:

Technical Support and E-Warranty Certificate www.vevor.com/support

This is the original instruction. Please read all manual instructions carefully before operating. VEVOR reserves the right to interpret the user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won't inform you of any technology or software updates on our product.

Warning - To reduce the risk of injury, users must read the instructions manual carefully.

WARNING:

Read the manual completely to avoid harm, product damage, or warranty voidance. Seek professional help if you encounter discomfort, pain, or worsening symptoms. If necessary, use supervision in order to assemble and use this product correctly and safely. Do not exceed the 300 lbs weight limit. Regularly check for secure assembly and contact support if in doubt. Ensure product's legs are even and locked before use, and discontinue usage if there are signs of wear, damage, or missing parts. The product is to be used on flat surfaces. Do not disassemble if not necessary, as it might compromise the longevity of the product. Do not modify the product unless specified in the manual. Use only parts approved by VEVOR for this specific product. Check the compatibility of the toilet rail with your toilet before first use. The product is built to withstand pressure or impact, and isn't to be used as a ladder or loaded with heavy objects.

Keep away from children and pets. Contains potentially hazardous small parts; choking hazard. Exercise caution during operation and assembly.

Avoid extreme temperatures or open flames. If an allergic reaction occurs, cease use immediately and consult a healthcare professional.

Warranty Policy

We warrant your new VEVOR product to be free from defects in materials and workmanship for 3 years from the original purchase. However, please keep in mind that our guarantee policy does not cover counterfeit or replica items, nor does it extend to products purchased from unauthorized resellers or in used condition. Please note that each purchase is eligible for only one guarantee redemption; we cannot repeatedly refund, replace, or exchange your product. We also kindly ask that you handle the product with care and use it according to the instructions provided. Unfortunately, we cannot cover damage resulting from misuse or abuse of the product. This warranty is not transferable and applies only to the original purchaser.

IMPORTANT

1. Do not exceed the weight capacity - 300 lbs max.
2. Use on stable surfaces only.
3. Regularly inspect for signs of wear, damage, or loose parts.
4. Clean regularly using a mild detergent and warm water, rinse off any soap residue. After cleaning, dry thoroughly.
5. Before use, confirm with your healthcare provider that the product meets your specific needs. The following guidelines are not a substitute for medical advice.

SAVE THESE INSTRUCTIONS

PARAMETER LIST

Model	FBL760599
Rated load (lbs)	300
Elevated height (in)	3.5
Net weight(kg)	2.01
Product size(mm)	440*610*275

PART LIST

When unpacking this product, check to make sure the parts listed below are included and carefully inspect for any damage that may have occurred during transit. If any part is missing or damaged, do not attempt to assemble or use the product.

NO	PICTURE	PART NUMBER	QTY	NO	PICTURE	PART NUMBER	QTY
1		Seat	1	6		Bolt	2
2		Handrail	2	7		Butterfly nut	2
3		LongL-shaped tube	2	8		Ironwasher	2
4		ShortL-shaped tube	2	9		Plasticwasher	2
5		C-clip	4

OPERATION

1. Installation Procedures

1. As shown in the figure, assemble the right handrail ② by inserting the long L-shaped tube ③ and short L-shaped tube ④ into the handrail tubes in order of their perforated ends, and then inserting the two C-clips into the aligned holes from the sides of the two L-shaped tubes in order of their perforated ends. (Note: the L-tube is on the lower side of the right diagram)

Insert the C-clip as shown in the right figure.

1. Follow the previous steps to install the left handrail.

Insert the C-clip as shown in the right figure.

1. As shown in the figure, insert the assembled left/right handrail into the opening of the seat cushion ① in the direction of the figure below. Ensure the marbles of the long L-shaped tube ③ and the short L-shaped tube ④ are smoothly ejected from the holes of the short tube at the bottom. The long L-shaped tube is at the front of the seat cushion.

Pictures of the completed assembly

1. As shown in the figure, cover the toilet's original seat plate and seat cover. Locate the nut that secures the seat plate and seat cover, and remove the original seat plate and seat cover by turning the butterfly nut counterclockwise.

1. As shown in the figure, place the assembled seat on the toilet, aligning the toilet's original seat plate and seat plate cover so that the fixing holes of the toilet, seat, seat plate, and seat plate cover are aligned.

1. As shown in the figure, insert the bolt ⑥ into the fixing holes aligning the toilet, seat, seat plate, and seat plate cover, and then put the plastic washer and butterfly nut on the other end of the bolt in turn and turn the nut clockwise to lock it.

Manufacturer: Zhongshan Bliss Medical Instrument Co., Ltd

Address: 3-6F & 7F-1, No. 63, Tongxing East Road, Yumin Community, Xiaolan, Zhongshan, Guangdong, 528414, CHINA

Imported to AUS: SIHAO PTY LTD. 1 ROKEVA STREET, EASTWOOD NSW 2122, Australia

Imported to USA: Sanven Technology Ltd. Suite 250, 9166 Anaheim Place, Rancho Cucamonga, CA 91730

UK

REP

Pooledas Group Ltd

Unit 5 Albert Edward House, The Pavilions

Preston, United Kingdom

EC

REP

SHUNSHUN GmbH

Römeräcker 9 Z2021, 76351

Technical Support and E-Warranty Certificate

www.vevor.com/support

VEVOR®

TOUGH TOOLS, HALF PRICE

NEED HELP? CONTACT US!

Manufacturer: Zhongshan Bliss Medical Instrument Co., Ltd Address: 3-6F &

7F-1, No. 63, Tongxing East Road, Yumin Community Xiaolan, Zhongshan, Guangdong, 528414,

CHINA Imported in AUS: SIHAO PTY LTD. 1

ROKEVA STREETASTWOOD NSW 2122 Australia

NEED HELP? CONTACT US!

Manufacturer: Zhongshan Bliss Medical Instrument Co., Ltd Address: 3-6F &

7F-1, No. 63, Tongxing East Road, Yumin Community Xiaolan, Zhongshan, Guangdong, 528414, CHINA

www.vevor.com/support

VEVOR®

TOUGH TOOLS, HALF PRICE

NEED HELP? CONTACT US!

7F-1, No. 63, Tongxing East Road, Yumin Community Xiaolan, Zhongshan, Guangdong, 528414, CHINA

Imported into AUS: SIHAO PTY LTD. 1 ROKEVA

STREET EASTWOOD NSW 2122 Australia

7F-1, No. 63, Tongxing East Road, Yumin Community Xiaolan, Zhongshan, Guangdong, 528414,

CHINA Imported into AUS: SIHAO PTY LTD. 1

ROKEVA STREET EASTWOOD NSW 2122 Australia

Imported into USA: Sanven Technology Ltd. Suite 250, 9166 Anaheim Place, Rancho Cucamonga, CA 91730

Grupo Pooledas Ltd

NEED HELP? CONTACT US!

Manufacturer: Zhongshan Bliss Medical Instrument Co., Ltd Address: 3-6F and 7F-1, No.

63, Tongxing East Road, Yumin Community Xiaolan, Zhongshan, Guangdong, 528414, CHINA Import to

Australia: SIHAO PTY LTD. 1 ROKEVA STREET EASTWOOD

NSW 2122 Australia

Import to USA: Sanven Technology Ltd. Suite 250, 9166 Anaheim Place, Rancho Cucamonga, CA 91730

www.vevor.com/support

VEVOR®

TOUGH TOOLS, HALF PRICE

Technical support and e-warranty certificate www.vevor.com/support

TOILET SAFETY RAILS

MODEL: FLB760599

NEED HELP? CONTACT US!

Place the C-clip

Manufacturer: Zhongshan Bliss Medical Instrument Co., Ltd Address: 3-6F & 7F-1,

No. 63, Tongxing East Road, Yumin Community Xiaolan, Zhongshan, Guangdong, 528414, CHINA

Imported in AUS: SIHAO PTY LTD. 1 ROKEVA

Rancho Cucamonga, CA 91730

Pooledas Group Ltd

Unit 5 Albert Edward House, The Pavilions

warranty certificate www.vevor.com/support

VEVOR®

TOUGH TOOLS, HALF PRICE

NEED HELP? CONTACT US!

Manufacturer: Zhongshan Bliss Medical Instrument Co., Ltd. Address: 3-6F &

7F-1, No. 63, Tongxing East Road, Yumin Community Xiaolan, Zhongshan, Guangdong, 528414, CHINA

Imported to AUS: SIHAO PTY LTD. 1 ROKEVA

STREETEASTWOOD NSW 2122 Australia

Imported to USA: Sanven Technology Ltd. Suite 250, 9166 Anaheim Place, Rancho Cucamonga, CA 91730

UK

REP

Pooledas Group Ltd

Unit 5 Albert Edward House, The Pavilions

www.vevor.com/support