KM-320MAH-E - Ice Maker Hoshizaki - Free user manual and instructions

USER MANUAL KM-320MAH-E Hoshizaki

ISSUED: April 11, 2008

REVISED: October 29, 2008

CRESCENT CUBER

EISMASCHINE FÜR SICHELFÖRMIGE EISWÜRFEL

PRODUCTOR DE FORMAS DE HIELO

DISTRIBUTEUR DE CUBELETS EN DEMI-LUNE

CUBETTATRICE MEZZALUNA

HALVE-MAANVORMIGE IJSMACHINE

INSTRUCTION MANUAL BEDIENUNGSANLEITUNG MANUAL DE INSTRUCCIONES NOTICE D'UTILISATION MANUALE DI ISTRUZIONI GEBRUIKSAANWIJZING

KM-320MAH-E

KM-515MAH-E

KM-650MAH-E

KM-1301SAH-E

FOR END USER

FÜR DEN ENDBENUTZER

1. This booklet is an integral and essential part of the product and should be kept and preserved by the user. Please read carefully the guidelines and warnings contained herein as they are intended to provide the user with essential information for the continued safe use and maintenance of the product. In addition, it provides GUIDANCE ONLY to the user on the correct services and site location of the icemaker. Please preserve this booklet for any further consultation that may be necessary.
2. This is a commercial icemaker, and should be destined only to be used for the purpose for which it has been expressly designed and attached to a suitable storage bin as specified by Hoshizaki. Any other use should be considered improper and therefore dangerous. The manufacturer will not be held liable or responsible for any damage caused by improper, incorrect and unreasonable use.

I. Installation Instructions

WARNING

The installation must be carried out by qualified personnel, in accordance with current regulations, according to the manufacturer's instructions.

1. Location

IMPORTANT

1. This icemaker is not intended for outdoor use. Normal operating ambient temperature should be within +7°C to +40°C. Normal operating water temperature should be within +7°C to +35°C. Operation of the icemaker, for extended periods, outside of these normal temperature ranges may affect production capacity.
2. The icemaker should not be located next to ovens, grills or other high heat producing equipment.
3. The location should provide a firm and level foundation for the equipment.
4. Allow 15 cm. clearance at rear, sides and top for proper air circulation and ease of maintenance and/or service should they be required.
5. This appliance is not suitable for installation in an area where a water jet could be used and where dripping is not allowed.

6. Do not place anything in front of the louver.

7. This icemaker will not work at subfreezing temperatures. To prevent damage to the water supply line, drain the icemaker when air temperature is below zero.

2. Electrical Connection

WARNING

THIS APPLIANCE MUST BE EARTHED

This icemaker requires an earth that meets the national and local electrical code requirements. To prevent possible severe electrical shock to individuals or extensive damage to equipment, install a proper earth wire to the icemaker. Turn off the power supply before any maintenance, repairs or cleaning is undertaken.

• This icemaker must have a separate power supply or receptacle of proper capacity. See the nameplate. It is recommended that this icemaker be the only electrical device on its power supply circuit.
• Stacked icemakers should each have a separate receptacle.
• Usually an electrical permit and services of a licensed electrician are required.
• If a power cord and/or a plug should need to be fitted/ replaced, it should only be done by a qualified service engineer.
• Factory fitted power cords are coloured in accordance with the following code:

Green & Yellow = Earth

Blue = Neutral

Brown = Live

(Plugs and power cords are not supplied with the KM-1301SAH-E.)

For the U.K. and the Republic of Ireland Only

• The non-rewirable plug must never be used without a fuse cover being fitted.
• The correct replacement for the detachable fuse cover is identifiable from the manufacturer's reference number stamped on the plug.
• Supply of replacement fuse covers can be obtained from Hoshizaki Parts/Service Centres.
• Fuses should be rated at 13A and approved to BS 1362.

For KM-1301SAH-E only

A suitably sized power supply cord (see the rating on the nameplate) must be fitted by a qualified installer into the terminal box on the rear of the machine. The wires in the terminal box are coloured in accordance with the following code:

Green & Yellow = Earth

Blue = Neutral

Brown = Live

3. Water Supply and Drain Connections

Note: A plumbing permit and services of a licensed plumber may be required in some areas.

• Only potable water should be used for this icemaker.
• Water supply pressure should be minimum 0.7 bar and maximum 8 bar. If the pressure exceeds 8 bar, use a pressure reducing valve. Do NOT throttle back the supply tap.
• The icemaker drain is gravity flow, so ensure that the drainpipe has an adequate pitch or fall.
  • Water should drain into an open trap.

II. Operating Instructions

WARNING

1. This icemaker is designed to produce edible ice. To keep the icemaker hygienic:

2. Wash your hands before removing ice.

3. Use the plastic scoop provided (accessory).
4. The storage bin is for ice use only. Do not store anything else in the bin.

- Clean the storage bin before use (see "III. 1. Cleaning").

- Keep the scoop clean. Clean it by using a neutral cleaner and rinsing thoroughly.

- Close the door after removing ice to prevent entrance of dirt, dust or insects into the storage bin.

1. The use of any electrical equipment involves the observance of some fundamental rules. In particular:

- Instances of high humidity and moisture increase the risk of electrical short circuits and potential electrical shocks. If in doubt, disconnect the icemaker.

- Do not use the icemaker when you have bare feet.

- Do not pull the power cord in order to disconnect the icemaker from the feed network.

- This appliance is not suitable for unsupervised use by young children or aged or infirm persons.

1. All parts are factory-adjusted. Improper adjustments may result in failure.

2. If the unit is turned off, wait for at least 3 minutes before restarting the icemaker to prevent damage to the compressor.

3. Do not operate the unit in the "WASH" position without water in the water tank. This will cause damage to the water pump seal.

1. Operation

The installer will normally commission the icemaker to start the automatic icemaking process. To ensure continuous operation, make sure that:

• The water supply tap is on, and
• The power supply is on.

2. Preparing the Icemaker for Long Storage

1) Disconnect the power supply.
2) Close the water supply tap, and remove the Inlet hose.
3) Remove all ice from the storage bin.
4) Ask for draining of the icemaker by professional qualified personnel.

III. Maintenance

1. Cleaning

WARNING

1. Before carrying out any cleaning or maintenance operations, turn off the power supply.
2. Ask a trained service person to clean and sanitize the icemaker water system at least twice a year and to check and clean the condenser at least once a year.
3. This appliance must not be cleaned by use of a water jet.

[1] Machine and Bin Exterior

Wipe the exterior at least once per week with a clean, soft cloth. Use a damp cloth containing a neutral cleaner to wipe off grease or dirt.

[2] Scoop

1) Either mix 3 litres of water with 11 ml of 5.25% sodium hypochlorite solution in a suitable container, or the recommended Hoshizaki sanitiser as directed.
2) Soak the scoop in the solution for more than 3 minutes. Rinse thoroughly, and shake to remove surplus liquid.
Note: Using a cloth to dry may re-contaminate.

[3] Storage Bin Interior Cleaning/Sanitisation (Weekly)

1) Open the storage bin door, and remove all ice.
Note: Hoshizaki recommends various types of storage bin for the icemaker which vary in size and design. The following instructions are therefore for general guidance only.
2) Wash the bin liner and door inner surface with a neutral non-abrasive cleaner. Rinse thoroughly with a clean cloth and fresh water.

3) Either mix 5 litres of water with 18 ml of 5.25% sodium hypochlorite solution in a suitable container, or the recommended Hoshizaki sanitiser as directed.

4) Soak a clean sponge or cloth with the solution, and wipe the bin liner and door inner surface.

5) Rinse thoroughly with fresh water and a clean cloth to wipe off the solution. Close the bin door.

Note: Some solutions may cause damage to the bin liner surfaces or corrosion on the metal parts. Always rinse the sanitiser unless directed otherwise by Hoshizaki guidelines.

[4] Air Filter (Air-Cooled Model Only)

A plastic mesh air filter removes dirt or dust from the air and keeps the condenser from getting clogged. As the filter gets clogged, the icemaker's performance will be reduced. Contact an authorised Hoshizaki service company to complete air filter cleaning as part of a regular maintenance programme.

[5] Icemaking Water System

To keep the icemaker hygienic, periodic cleaning of the icemaking water system is recommended. Always ask a trained service person to clean the water system.

Note:

1. The washing switch on the control box is intended for use by service personnel only.

2. During normal icemaking operation, keep the washing switch in the "ICE" position.

2. Before Calling a Service Agent

If the icemaker does not work properly or does not work at all, before calling for service, check that:

- The power is supplied to the unit.

• The water is turned on.

For further assistance or advice, contact your local Hoshizaki service agent.

3. Warranty

Hoshizaki warrants to the original owner/user that all Hoshizaki branded products shall be free of defects in material and/or workmanship for the duration of the "warranty period". The warranty shall be effective for two years from the date of installation in EU countries, but only one year in other countries. Hoshizaki's liability under the terms of the warranty are limited and shall exclude routine servicing, cleaning, essential maintenance and/or repairs occasioned by misuse and installations not in accordance with Hoshizaki guidelines.

Warranty repairs should be completed by an approved Hoshizaki dealer or service agency using genuine Hoshizaki components.

To obtain full details of your warranty and approved service agency, please contact your dealer/supplier, or the nearest Hoshizaki Service office:

UK/Ireland - Hoshizaki UK

TEL : [phone]

FAX: [phone]

Holland - Hoshizaki Europe

TEL : [phone]

FAX: [phone]

Belgium/Luxemburg - Hoshizaki Belgium

TEL : [phone]

FAX: [phone]

Germany/Switzerland/Austria - Hoshizaki Deutschland

TEL : [phone]

FAX: [phone]

France - Hoshizaki France

TEL : [phone]

FAX: [phone]

Other countries - Hoshizaki Europe

TEL: [phone]

FAX: [phone]

This product includes a hermetically sealed refrigeration system that contains fluorinated greenhouse gases covered by the Kyoto Protocol:

KM-320MAH-E R-404A / GWP 3260 / 0.575 kg

KM-515MAH-E R-404A / GWP 3260 / 0.525 kg

KM-650MAH-E R-404A / GWP 3260 / 0.640 kg

KM-1301SAH-E R-404A / GWP 3260 / 1.620 kg

This product is insulated with foam blown with fluorinated greenhouse gases.

DECLARATION OF CONFORMITY

(Name of company) HOSHIZAKI AMERICA, INC.

(Address) 618 Highway 74 South

Peachtree City, Georgia 30269

declares, in sole responsibility, that the following products

(Designation) ICE MAKER

(Model) HOSHIZAKI brand

KM-320MAH-E, KM-515MAH-E, KM-650MAH-E, KM-1301SAH-E

referred to in this declaration conform with the following standard(s) or directive(s):

Electromagnetic Compatibility Directive 89/336/EEC

(Title or number and issue date of standards or other normative documents)

Low Voltage Directive 73/23/EEC

(Title or number and issue date of standards or other normative documents)

The company named above will keep on file for review the following technical documentation:

• operating instructions as required
• plans
• description of measures designed to ensure conformity
* other technical documentation
• Data on components, general information, test report, attestation of conformity

(Place and date of issue)

Peachtree City, GA October 15, 2008

(Name)

Youki Suzuki

(Position in Company)

President & CEO

ACHTUNG

(Adresse) 618 Highway 74 South

Peachtree City, Georgia 30269

KM-320MAH-E, KM-515MAH-E, KM-650MAH-E, KM-1301SAH-E

Peachtree City, Georgia 30269

KM-320MAH-E, KM-515MAH-E, KM-650MAH-E, KM-1301SAH-E

France - Hoshizaki France

TEL : [phone]

FAX: [phone]

(Adresse) 618 Highway 74 South

Peachtree City, Georgia 30269

KM-320MAH-E, KM-515MAH-E, KM-650MAH-E, KM-1301SAH-E

Peachtree City, Georgia 30269

KM-320MAH-E, KM-515MAH-E, KM-650MAH-E, KM-1301SAH-E

DIT APPARAAT MOET WORDEN GEAARD

(Adres) 618 Highway 74 South Peachtree City, Georgia 30269

(Benaming) IJSMACHINE

(Model) HOSHIZAKI merk KM-320MAH-E, KM-515MAH-E, KM-650MAH-E, KM-1301SAH-E