Retro SK34020 - Kettle SWAN - Free user manual and instructions

USER MANUAL Retro SK34020 SWAN

Swan Retro designed for life Dome Kettle/ Bouilloire Dôme Models: SK34020 v2.0

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be followed including the following:

• Read all instructions.
• Do not touch hot surfaces. Use handles or knobs.
• To protect against electrical hazards, do not immerse cord, plugs, or the appliance in water or other liquid.
• Close supervision is necessary when any appliance is used by or near children. Children should be supervised to ensure that they do not play with the appliance.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
• Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts, and before cleaning the appliance.
• DO NOT operate any appliance with a damaged cord or plug or after the appliance malfunctions, or is dropped or damaged in any manner. Return appliance to the manufacturer for examination, repair or electrical or mechanical adjustment. All servicing, other than cleaning, should be performed by an authorized service representative. See Warranty section.
• The use of accessories or attachments not recommended by the manufacturer may result in fire, electric shock or personal injury.
• Do not use outdoors.
• Do not let cord hang over edge of table or counter, or touch hot surfaces.
• Do not place on or near a hot gas or electric burner, or in a heated oven.
  • Always attach plug to appliance first, then plug cord into the wall outlet. To disconnect, turn any control

Swan

IMPORTANT INFORMATION - RETAIN FOR FUTURE USE

to 'OFF', then remove plug from wall outlet.

• Do not use appliance for other than intended use.
• Do not leave unit unattended while in use.
• Extreme caution must be used when moving an appliance containing hot liquids.
• Do not use Kettle without the Lid in place.
• Scalding may occur if the Lid is opened while the Kettle is hot.
• Direct kettle spout away from cabinets, walls, etc. to prevent possible steam damage

SAVE THESE INSTRUCTIONS HOUSEHOLD USE ONLY

GROUNDED PLUG

To reduce the risk of electric shock this appliance has a grounded plug (2 blades and 1 pin). If the plug does not fit fully into the electrical outlet contact a qualified electrician. Do not modify the plug in any way or use an adaptor.

POWER CORD

A short supply cord is provided to reduce the hazards of becoming entangled in or tripping over a long cord. Extension cords may be used if care is exercised in their use. If an extension cord is used, the marked electrical rating of the detachable power-supply cord or extension cord should be at least as great as the electrical rating of the appliance. If the appliance is of the grounded type, the extension cord should be a grounded 3-wire cord. The extension cord should be arranged so that it will not drape over the counter top or table top, where it can be pulled on by children or tripped over.

Swan

BEFORE FIRST USE

• Read all instructions carefully and keep them for future reference.
• Remove all packaging.
• The filter has been installed in the spout of the Kettle during production. If it has been dislodged during shipping check inside the Kettle or in the box. Install the Filter before using the Kettle.

IMPORTANT NOTES:

1. DO NOT remove or install the filter when the Kettle is hot.
2. DO NOT use the kettle without the filter in position:

- This may allow water to spit out when boiling

- The kettle may remain in the boil cycle too long once the water has boiled

- The kettle may not shut off

1. Fill the Kettle with 4 cups (1L) of cold tap water and bring to a boil. Add 2 cups (500 ml) of white vinegar and let stand for at least 1 hour or overnight. Discard.
2. Fill the kettle to the maximum fill line with cold tap water. Bring to a boil and discard. Repeat.
3. The kettle is now ready to use.

Swan

HOW TO USE

1. Fill the kettle with water via the spout. You can also fill the kettle by opening the lid. Ensure the lid is firmly closed after filling.
2. Check that the water level is between the MIN and MAX lines on the water gauge. DO NOT FILL THE KETTLE PAST THE MAX LEVEL. DOING SO POSES A SCALDING RISK.
3. Place the kettle on a flat, level, dry, heat resistant surface. Plug into a 120V AC wall outlet. Press the ON/OFF switch down to start the boil cycle. NOTE: Never plug the kettle into an electrical outlet when the kettle is empty.
4. Direct kettle spout away from cabinets, walls, etc. to prevent possible steam damage.
5. The kettle shuts off automatically after the boiling cycle is complete. If the kettle is removed from the base before the boiling cycle is complete, the boiling cycle will be cancelled. To turn the kettle off before the boiling cycle is complete raise the on/off button or lift the kettle off the base..
6. The lid should not be opened when the kettle is hot.
7. If the kettle is accidentally switched on when empty, the thermostat will automatically cycle on and off to prevent the Kettle from overheating. If this situation occurs, unplug the kettle immediately and allow it to cool before refilling.
8. It is recommended that the power cord be disconnected from the wall outlet when not in use.
9. DO NOT attempt to connect any other appliance to the power base or tamper with the connector in any way.

CARE & CLEANING

1. All servicing, other than cleaning, should be performed by an authorized service representative. See Warranty section.
2. Unplug the Base from the wall outlet. Empty the Kettle and allow it to cool before cleaning. Exterior- Use a soft, damp cloth to clean the exterior. - DO NOT use abrasive cleaners. Dry exterior thoroughly before use. - DO NOT immerse kettle or power base in water or other liquid.

Descaling: Under normal use, scale build-up will form on the inside of the kettle and will coat the stainless steel plate. Scale,

Swan

CARE & CLEANING

which has accumulated inside the kettle must be removed by boiling equal parts of white vinegar and water (500ml/2 cups of each is recommended). Once the water has boiled, allow the mixture to stand several hours or overnight. Empty out mixture and fill kettle to the MAX level with fresh water. Bring water to a boil and discard. For heavy scale build-up, use a scale/lime remover and follow its manufacturer's instructions. This descaling process should be repeated periodically. NOTE: Scale build-up can be delayed by pouring out water after use then refilling the kettle when required.

LIMITED WARRANTY

**The original sales receipt is the only acceptable proof of purchase**

Salton Canada warrants that this appliance shall be free from defects in material and workmanship for a period of two (2) years from the date of original purchase. Salton Canada, at its sole discretion during this warranty period, will repair or replace a defective product or issue a refund. Any refund to the purchaser will be at a pro-rated value based on the remaining period of the warranty. All liability is limited to the amount of the purchase price. This warranty covers normal domestic usage and does not cover damage which occurs in shipment or failure which results from alteration, accident, misuse, abuse, glass breakage, neglect, improper maintenance, use contrary to the operating instructions or commercial use. This warranty is not available to retailers or other commercial purchasers or owners.

TO OBTAIN PROMPT WARRANTY SERVICE:

Contact one of our many Service Centers found on our website: www.salton.com/customer-care

or

Securely package and return the appliance to us. Please enclose:

• Original proof of purchase
- The completed form below with a \$12.50 Return Shipping & Handling fee – either a cheque, money order or credit card (A personal cheque will delay return shipping by 2-3 weeks)

For added protection, we suggest that you use an insured delivery service with tracking information when returning your product. Salton Canada will not be held responsible for in-transit damage or for packages that are not received. This warranty does not include the cost of shipping, which is to be borne by the customer.

Swan

WARRANTY FORM

Name

Address

City

Prov/State

Postal/Zip Code

Daytime Phone No.

Email

Product defect:

Type of payment Cheque/Money Order

□ Visa

MasterCard

Name on card

Expiry Date CSV No

Card No.

To contact our Customer Service Department:

SALTON CANADA

Telephone: [phone] (Ext

81A Brunswick,

E-mail: [e-mail]

Dollard-des-Ormeaux, Quebec H9B 2J5 Fax: [phone]

Canada

www.salton.com

Swan

PRÉCAUTIONS IMPORTANTES

Type of payment Cheque/Money Order

□ Visa

MasterCard

Name on card

Expiry Date CSV No

Card No.

To contact our Customer Service Department:

SALTON CANADA

Telephone: [phone] (Ext

81A Brunswick,

E-mail: [e-mail]

Dollard-des-Ormeaux, Quebec H9B 2J5 Fax: [phone]

Canada

www.salton.com

Swan

NOTES

Swan

Stylized white and gray swan logo on black background (no text or symbols)

www.swan-brand.com

Scan this QR code to hear about our story

We love what we do

we're proud of our quality

Find us on Facebook

Distributed by / Distribué par: Salton Canada 81A Brunswick, Dollard-des-Ormeaux, QC, Canada H9B 2J5