Attivap G90036 - Steam cleaner G3 Ferrari - Free user manual and instructions

USER MANUAL Attivap G90036 G3 Ferrari

Yellow GFERRARI electric shaver with black handle and black tip, isolated on white background (no text or symbols on device body)

Pulitore a vapore - Steam Cleaner

ATTIVAP

ITA: INDICE

Simbologia.... p. 2

Safety instructions.... p. 10

G90036....p. 11

Operating....p. 11

Waste of electric and electronic equipment (WEEE Directive).... p. 28

PORTUGUES:....p. 12

ESPAÑOL....p. 17

FRANCAIS p. 22

CLASSI DI PROTEZIONE / PROTECTION CLASSES

ATTENZIONE RISCHIO DI SCOSSE ELETTRICHE NON ESPORRE A PIOGGIA E UMIDITA'

WARNING ELECTRIC SHOCK RISK DO NOT EXPOSE TO RAIN OR MOISTURE

ATTENZIONE: NON APRITE L'APPARECCHIO. ALL'INTERNO NON VI SONO COMANDI MANIPOLABILI DALL'UTENTE NE' PARTI DI RICAMBIO. PER TUTTE LE OPERAZIONI DI SERVIZIO RIVOLGERSI AD UN CENTRO DI ASSISTENZA AUTORIZZATO.

This symbol warns the user that un-insulated dangerous voltage inside the system may cause an electrical shock. Do not open the case.

Class I Appliance symbol. This means the appliance must have the chassis connected to electrical earth/ground by an earth conductor.

Caution: this symbol reminds the user to read carefully the important operations and maintenance instructions in this owner's guide.

AVVERTENZE DI SICUREZZA

Labeled diagram of a hair dryer with numbered parts for identification

FUNZIONAMENTO

Diagram of a mechanical component with a threaded shaft and flange, showing internal structure (no text or symbols)

Technical line drawing of a mechanical component with a threaded base and protruding pipe (no text or symbols)

Figure 2. Box 1 (V)

(V)

CARATTERISTICHE TECNICHE

ENGLISH: SAFETY INSTRUCTIONS

The following are important notes on the installation, use and maintenance; save this instruction manual for future reference; use the equipment only as specified in this guide; any other use is considered improper and dangerous; therefore, the manufacturer cannot be held responsible in the event of damages caused by improper, incorrect or unreasonable use.

Before use, ensure the equipment is undamaged; if in doubt, do not attempt to use it and contact the authorized service center; do not leave packing materials (i.e. plastic bags, polystyrene foam, nails, staples, etc.) within the reach of children as they are potential sources of danger; always remember that they must be separately collected. Make sure that the rating information given on the technical label are compatible with those of the electricity grid; the installation must be performed according to the manufacturer's instructions considering the maximum power of the appliance as shown on the label; an incorrect installation may cause damage to people, animals or things, for which the manufacturer cannot be considered responsible thereof. If it is necessary to use adapters, multiple sockets or electrical extensions, use only those that comply with current safety standards; in any case do not exceed the power consumption limits indicated on the electrical adapter and / or extensions, as well as the maximum power shown on multiple adaptor.

Do not leave the unit plugged; better to remove the plug from the mains when the device is not in use. Always disconnect from power supply if you leave it unattended.

Cleaning operations should be carried out after unplugging the unit.

If the unit is out of order and you do not want to fix it, it must be made inoperable by cutting power cord.

- Do not allow the power cord to get closer to sharp objects or in contact with hot surfaces; do not pull it to disconnect the plug.

- Do not use the appliance in the event of damage to the power cord, plug, or in case of short circuits; to repair the product only address an authorized service center.

- Do not handle or touch the appliance with wet hands or bare feet. Do not expose the appliance to harmful weather conditions such as rain, moisture, frost, etc.. Always store it in a dry place.

- This appliance can be used by children of 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they received supervision or instruction concerning use of the appliance in a safe way and understand hazards involved; children shall not play with the appliance; cleaning and user maintenance shall not be made by children without supervision.

- Children must not play with the appliance.

- Keep the appliance and its cord out of reach of children less than 8 years.

If the power cord is damaged, or in case of failure and / or malfunction do not tamper with the unit. The reparation must be done by manufacturer or by service center authorized by the manufacturer in order to prevent any risk. Failure to comply with the above may compromise the unit safety and invalidate the warranty.

WARNING: This appliance includes heating function. Do not cover. Keep space on sides when using. Surfaces, other than functional surfaces may develop high

temperatures. Since temperatures are perceived differently by different people, this device should be used with CAUTION. Hold the appliance exclusively to grip surfaces intended to be touched.

• This appliance is intended to be used in household and similar applications such as: staff kitchen areas in shops, offices and other working environments; by clients in hotels, motels and other residential type environments; farm houses, bed and breakfast type environments.
• The appliance is not intended to be operated by means of an external timer or separate remote-control system.
• Before every use, unroll the power cord.
• Use original spare parts and accessories only.
• Do not subject the product to strong impacts, serious damages may result. Don’t use near or under flammable materials (like curtains), heat, cold spots and steam.

GENERAL INFORMATION

When you first use it, take out the steam repeatedly, to remove any manufacturing residue.

Do not leave the product unattended when in use. Keep the power cord free of knots and tangles. Do not wrap the power cord around the product, either before or after use. When inside the boiler there is enough pressure to produce steam, do not screw the cap off. Once pressure decreases, the cap can be opened. When water is finished, the unit will automatically shut down to prevent damage.

CAUTION: if you want to open the tank, wait a few minutes and then unscrew the cap very slowly so to release residual steam from the tank.

Always unplug before you fill or empty the tank. We recommend the use of distilled water to avoid excessive fouling (not covered by warranty).

Use provided measuring cup and funnel to fill the tank; do not supply it directly under the tap or with cold liquids.

Do not overfill the water tank and do not to introduce into the tank mixtures for removing stain, vinegar, descaling agents or chemicals in general.

Do not use the device as a heating unit.

Do not expose the product to high temperatures and do not place it near heat sources. Do not immerse in water or other liquids; always clean it with a damp cloth.

Fill the tank when you notice a decrease in the jet of steam. Before filling the tank, disconnect the power cord from the electrical outlet.

When using, do not tilt over 45^ . Do not direct the flow of steam towards people, animals, electrical equipment, CAUTION: the steam outlet nozzle becomes very hot: be careful not to burn yourself. Do not put your face in front of the steam coming out of the nozzle.

DESCRIPTION G90036

(1) Tank (2) Short spout (3) Safety cap (4) Steam emission button
(5) Handle (6) Power cord (7) Control light (8) Funnel
(9) Measuring cup (10) Round brush (11) 90^ nozzle (12) Main spout

(13) Flexible hose (14) Brush (15) Mirror brush (16) Cloth

OPERATING

The device can be used to disinfect and sterilize surfaces, clean clothes, doors, windows, mirrors, remove the dirt in the grooves between tiles, etc. ...

• Unscrew the cap (3) by turning it counterclockwise.
• To fill the tank, insert the funnel (8) and enter the water using the measuring cup (9, 150ml capacity) without exceeding the maximum capacity of the tank (350ml).
• Screw the cap and connect the plug to the power outlet. The red lamp (7) will light on and the boiler starts heating up. When the green light (7) goes on, it means that the boiler is ready to produce steam.
• On first use, or if the product did not operate for a long time, it is recommended to expel steam by using the proper button (4) for about 2 minutes on a cloth. This will eject processing residues and limestone.
• For using the steam, press the steam emission button (4). The button has 2 safety systems:
  ○ Automatic release: steam exits only when you press the button, if you release the emission will stop.
  o Safety lock: you can block button moving the safety lock that is under of the button.

- It is recommended to drain the remaining water after each use.

When you use the unit with steam emission, wait until the complete heating of the boiler. CAUTION: do not fill the tank completely (max 350ml) since this operation prevent the steam formation and causes water leaks.

ACCESSORIES

Main spout (12), for a long and localized jet of steam.

Assembling: Align the "I" mark on the spout (12) with the sign "II" on housing (Figure 1) and then turn the nozzle clockwise until it locks. To remove it, turn it counterclockwise.

Technical line drawing of a mechanical component with no visible text or symbols

(I)

Flexible hose (13), to expand the range.

Assembling it in the same way as the main spout. The spout (12) can be mounted on the hose (13).

Round brush (10), to remove encrusted dirt thanks to the bristles.

Installation: Mount the main spout (12) or the extension hose (13) and then insert the brush (10) at the end, blocking it with the hexagonal joint (Figure III).

90° nozzle (11), to reach nooks and crannies. Assembling: Mount spout (12), flexible hose (13) and then insert the 90° nozzle (11) in the end, fixing it with hexagonal joint (Fig III). Brush (14), suitable for cleaning various kinds of surfaces.

Same assembling as the spout. You can cover the brush (14) with the cloth (16) to improve the performance and sensitivity of cleaning.

Windows and door brush (15).

Assembling: must be mounted on the brush (14).

First align (figure IV) the joints in the back of the brush (14) with the tabs of the mirror brush (15), then fix it (15) by framing the front tab to the body of the brush (fig V).

Technical line drawing of a mechanical component with a conical tip and protruding rod (no text or symbols)

REFILLING THE WATER TANK

When steam power fails, the water tank must be supplied.

• Disconnect the plug from the electrical outlet
• Press the steam emission button (4) until all the steam has come out.
• Press the cap (3) and unscrew it slowly, being careful not to burn yourself with the steam coming out.
• Allow the unit to complete cool down for 5 minutes
• Fill in the tank with water by using the provided funnel and measuring cup, then secure the cap.

CLEANING - CAUTION Before cleaning any part of the appliance, make sure that the plug is disconnected from the electrical outlet and that every part of the unit has cooled down.

The main body can be cleaned with a damp cloth and neutral detergent and then wiped with a dry cloth. Do not immerse the product in water or other liquids. The accessories can be washed under the jet of tap water; dry them completely before re-assembling them to the unit.

TECHNICAL FEATURES

• Power supply: AC 220-240V\~50 Hz. Power: 950-1100W
• Control light, Safety cap
• Water tank capacity: 350 ml - Working pressure: 1,5 – 4 Bar - Steam volume: 30g/min

PORTUGUÊS ADVERTÊNCIAS

Diagram of a mechanical component with a pointed tip and internal structure, labeled (I), showing no text or symbols.

Diagram of a mechanical component with a pin and handle, labeled (III), showing no text or symbols.

RECARGA DE ÁGUA

Technical diagram of a mechanical component with three views: top view (I), side view (II), and bottom view (III), showing internal structure without any text or symbols.

Diagram of a mechanical component with a threaded shaft and internal structure, labeled (I), showing no text or symbols.

ACCESSOIRES

Technical line drawing of a mechanical component with a threaded base and a protruding knob (no text or symbols)

The product is made of non-biodegradable and potentially polluting substances if not properly disposed of; other parts can be recycled. It’s our duty to contribute to the ecological health of the environment following the correct procedures for disposal. The crossed out wheelie bin symbol indicates the product complies with the requirements of the new directives introduced to protect the environment (2002/96/EC, 2003/108/EC, 2002/95/EC, 2012/19/EC) and must be properly disposed at the end of its lifetime. If you need further information, ask for the dedicated waste disposal areas at your place of residence. Who does not dispose of the product as specified in this section shall be liable according to the law.

To find the nearest service center, please call the telephone number 0541 694246, fax number 0541 756430 or contact us at [e-mail] asking for the service centers supervisor.

Appliance is conform to the pertinent European regulation and is therefore marked with the CE mark.

www.g3ferrari.it TREVIDEA S.r.l.

TREVIDEA S.R.L. – Strada Consolare Rimini – San Marino n. 62 – 47924 – RIMINI (RN) - ITALY

MADE IN CHINA