E43924 - Grinding tool accessory IFM - Free user manual and instructions

USER MANUAL E43924 IFM

Operating instructions

Grinding protection set for G1/2 hygienic welding

adapter

E43924

Contents

1 Preliminary note 3

1.1 Symbols used 3
1.2 Warnings.... 3

2 Safety instructions.... 4

3 Intended use.... 5
4 Installation.... 6

4.1 Installation of E43924 on the special welding adapter E43919 6
4.2 Processing of the weld seam for special welding adapters 6

5 Disposal 8

1 Preliminary note

You will find instructions, technical data, approvals and further information using the QR code on the unit / packaging or at documentation.ifm.com.

1.1 Symbols used

√ Requirement
Instructions
Reaction, result

[...] Designation of keys, buttons or indications

→ Cross-reference

Important note

Non-compliance may result in malfunction or interference.

Information

Supplementary note

1.2 Warnings

Warnings indicate the possibility of personal injury and damage to property. This enables safe product handling. Warnings are graded as follows:

WARNING

Warning of serious personal injury

▷ If the warning is not observed, fatal and serious injuries are possible.

CAUTION

Warning of minor to moderate personal injury

▷ If the warning is not observed, minor to moderate injuries are possible.

ATTENTION

Warning of damage to property

▷ If the warning is not observed, damage to property is possible.

2 Safety instructions

• Read this document before setting up the product and keep it during the entire service life.
• The product must be suitable for the corresponding applications and environmental conditions without any restrictions.
• Only use the product for its intended purpose (→ Intended use).
• If the operating instructions or the technical data are not adhered to, personal injury and/or damage to property may occur.
• The manufacturer assumes no liability or warranty for any consequences caused by tampering with the product or incorrect use by the operator.
• Installation, set-up, operation and maintenance of the product must be carried out by qualified personnel authorised by the machine operator.

3 Intended use

The grinding protection set provides protection for the transition area for the special adapter E43919 when reworking the weld seam.

1: M12 nut
2: High hemisphere D = 70
3: Protective cable entry
4: Flat half shell D = 70
5: M12 screw

One set of the E43924 is for one-time use.

4 Installation

ATTENTION

Dangers for the plant and environment during rework.

▶ Consider possible dangers and adhere to applicable regulations and guidelines.

WARNING

Dangers for persons during rework.

▶ Consider possible dangers and adhere to applicable regulations and guidelines.

The grinding protection must be centred on both sides before final tightening.

Do not scratch the surfaces with the grinding protection caps.

One grinding protection set is for one-time use.

4.1 Installation of E43924 on the special welding adapter E43919

▶ Install the grinding protection E43924 on the welded adapter E43919.

1: High hemisphere D = 70
2: M12 nut
3: M12 screw
4: Protective cable entry
5: Welding adapter E43919
6: Flat half shell D = 70

4.2 Processing of the weld seam for special welding adapters

Observe and use protective devices and equipment according to the product specifications, installation conditions and ambient conditions.
Observe and use the operating instructions and safety instructions for the tools used.

Do not remove any material from the special welding adapter in the transition area.

▶ Guide the grinding tool parallel to the surface to be processed.

Fig. 1: Schematic illustration, components may vary.

5 Disposal

▶ After use dispose of the product or components in an environmentally friendly way in accordance with the applicable national regulations.