NorBreeze ALIZE 80 DB - Basket NODOR - Free user manual and instructions

USER MANUAL NorBreeze ALIZE 80 DB NODOR

The air outlet of the appliance must not be connected to a flue which is used for exhausting other fumes from appliances, such as a central heating, boilers etc..

For the external exhausting of the fumes, comply with the regulations in force.

The motor of the peripheral exhausting group is powered by the coo ker-hood placed in the kitchen.

Before connecting the cooker hood to the mains supply, make sure that the voltage indicated in the rating plate corresponds to the mains voltage in the home.

Before carrying out any sort of maintenance or cleaning operation, make sure that the appliance is disconnected from the electrical mains.

An appropriate maintenance ensures a good working and a good performance in the long run.

All models are built in class I, therefore they must be earthed.

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of

experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and under stand the hazards involved.

• Children shall not play with the appliance.

• Cleaning and user maintenance shall not be made by children without supervision.

• If the power cable is damaged, it must be replaced by a cable or a special assembly, available from the manufacturer or its service de partment technique.

• The room must have adequate ventilation when using the kitchen hood simultaneously with other appliances that use gas or other fuels (not yes applies to appliances that simply release the air back into the room);

• There is the possibility of fire if the cleaning operations are not carried out as indicated in the instructions;

• Do not prepare flambeed food under the kitchen hood.

ATTENTION: The accessible parts can burn if used in conjunction with the cooking appliances.

USES

The appliance is already arranged both for filtering and for suction performances.

• In its filtering version (Fig. 1), the air and fumes conveyed by the appliance are depured both by a grease filter and by an active coal filter, and put again into circulation through the side-grids of the chimney. For this version an air deflector placed on the superior part of the pipe and allowing air-recycling is necessary (Fig. 1A).

• In its ducting version (Fig. 2), fumes are directly conveyed outside, through an evacuation duct connected with the superior part of the wall or the ceiling. Both coal filter and air deflector are not necessary in this case.

INSTALLATION

Before installing the appliance, make sure that none of the parts is damaged in any way. In case of damaged parts, contact your retailer and do not proceed with installation.

Read all of the following instructions fully care before installing the appliance.

• Use an air outlet pipe of the shortest possible length.
• Limit the number of pipe bends.
• Use a material approved by standards and regulations.
• Avoid any sudden changes in pipe section (recommended constant diameter: 150mm or equal surface area).
• The manufacturer shall not respond for air capacity or noise problems due to non-compliance with above mentioned instructions, and no warranty shall be given.

Using the special drilling jig(fig. 5A), drill the holes to install the hood on the wall; the products shall be installed at a minimum distance of 500mm from the cook-top.

Fix the hood to the wall by using the dowels and the screws supplied (fig. 6).

Open the font panel by raising the lower part up as per fig. 7 and remove the remove the grease filter (fig. 8). Fix the product to the wall by using the screws supplied as per fig. 9.

* Dicting version

Connect the hood flange to the air outlet using a suitable pipe. Make the electrical connection using the power cable.

Chimney Installation

Lift up the internal stainless steel chimney up to wished installation height. Trace with a pencil the end of the internal chimney on the both sides (fig. 11), lower the whole chimney and position the fixing bracket in correspondence with marking made (fig. 12); fix the bracket using the screws supplied (fig. 13). Lift up the internal chimney until it covers the bracket and block it by fixing screws positioned on both sides (fig. 14).

Filtering version

Install the air outlet grill above the hood in the relative seat (see fig. 15). The chimneys are not necessary.

The charcoal filter is installed as shown in fig. 16, by fitting it into its seat that is found just behind the metal grease filter.

Charcoal filters should be replaced according to the effective use of the hood, and however at least once every 6 months.

OPERATION

A: Light switch ON/OFF
B: Reduce speed / OFF motor
C: Speed Indicators
D: ON motor / increase
E: 10 - minute timer

At the top of the product there is a switch to turn off the hood (fig. 19).

ATT: This switch does not disconnect the product from the mains.

The touch control key allows to set the desidered function by touching the relative key.

If the electrical power supply to the product SLTC is cut, 15 seconds are needed for selfdiagnostics after the functions are restored.

In the meanwhile, its operation may be incorrect.

DIMMABLE LIGHTS FUNCTION

THIS FUNCTION PROVIDES FOR LIGHTS DIMMABILITY, RANGING FROM 20% TO 100%, BY CONTINUOUSLY PRESSING THE LIGHT KEY ON THE REMOTE CONTROL.

FUNCTIONS ARE THE FOLLOWING:

• HOOD LIGHT OFF - SHORTLY PRESS THE KEY - LIGHT ON AT 100%.
• LIGHT ON AT 100% - SHORTLY PRESS THE KEY - LIGHT OFF.
• LIGHT ON AT 100% CONTINUUSLY PRESS THE KEY-BRIGHTNESS REDUCTION.
• RELEASING THE KEY DURING REDUCTION OR INCREASE - LIGHT KEEPS THE LUMINOUS INTENSITY REACHED.
• LIGHT ON - DIMMED - CONTINuously PRESS THE KEY - BRIGHTNESS IS INVERTED IF COMPARED TO THE PREVIOUS FUNCTION.

COLOUR TEMPERATURE SETTING

Make sure that the lights and the fan are off. Holding down the TIMER key will turn on the light at the previously set colour temperature. Press and hold the Light key to change the colour temperature.

As long as the key is kept pressed, the colour temperature is changed from warm to cold, just leave the Light key to select the desired colour. Exit the colour temperature selection function by pressing the ON/OFF key.

TIMING

As a result of the new EU65 "Energy label" and EU66 "Ecodesign" regulations issued by the European Commission, which came into force on January 1st, 2015, our products have been adapted to comply with these new requirements.

All of the models complying with the energy label requirements, are equipped with new electronics including a timer device for suction speeds control, when the air capacity exceeds 650m^3/h .

Internal motor models, with maximum air capacity higher than 650m^3 /h are equipped with a timer device that automatically switches the suction speed from 4th to 3rd speed, after 6 minutes operation.

The energy consumption of the appliance in stand - by mode is lower than 0.5W

MAINTENANCE

An accurate maintenance guarantees good functioning and long-lasting performance.

Particular care is due to the grease filter. It can be removed by following the instructions below.

For the models SLTC111 Touch Control Version: The saturation of the filter is indicated by the flashing speed indicators (Fig. 17C).

Press the timer button to reset.

The grease filter needs cleaning by regular handwashing or in dishwasher every two months at least or depending on its use.

In case the appliance is used in its filtering version, the active coal filter needs to be periodically replaced.

To clean the appliance, we recommend warm water and neutral detergent, while abrasive products should be avoided.

The power cord shall be replaced by authorized staff only.

Replacement of the LED bar:

Using an appropriate tool, remove the LED bar from its seat (refer to Fig. 18), disconnect it electronically through the appropriate connector then replace it with a LED bar with same characteristics.

SOMMAIRE

FR

Avertissements

The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. This appliance is marked according to the European directive 2012/19/EC on waste electrical and electronic equipment (WEEE).