Quik Stik Xpress WSB25X - Blender Waring Commercial - Free user manual and instructions

Product Type	Rechargeable immersion blender
Brand	Waring Commercial
Model	Quik Stik Xpress WSB25X
Power Supply	Rechargeable battery with wall charger
Battery Type	Rechargeable (not specified)
Initial charging time	Approximately 15 hours
Available speeds	High and Low
Safety switch	Yes, simultaneous on/off with power button
Shaft material	Stainless steel
Motor housing material	Plastic
Warranty	1 year limited (defects in materials and workmanship)
Recommended uses	Soups, sauces, mayonnaise, purees, porridges, etc.
Cleaning	Remove battery, wash stainless steel shaft with water and detergent solution
Disinfection	Use a chlorine solution (100 ppm) after cleaning
Safety	Very sharp blade, safety lock, do not use if cord is damaged
Included accessories	Wall charger, blending shaft
Maximum immersion depth	3/4 of the shaft
Important instructions	Do not immerse motor block, do not use outdoors
After-sales service	Authorized Waring centers (address provided in the manual)
Regular maintenance	Cleaning and disinfection after each use

Frequently Asked Questions - Quik Stik Xpress WSB25X Waring Commercial

How to charge the blender for the first time?

Before first use, charge the appliance for about 15 hours. Plug the wall charger into an electrical outlet, then place the blender on the charger. The green light turns on during charging.

How to turn on and use the blender?

Press simultaneously the POWER ON button on the front and the safety switch on the back. Choose high (HIGH) or low (LOW) speed with the switch under the battery. Press STOP to stop.

Can I blend hot liquids?

Yes, but use a large container to avoid splashes and burns. Do not immerse more than 3/4 of the shaft in the liquid.

How to clean the blender?

Always remove the battery before cleaning. Wash the stainless steel shaft with warm water and a non-foaming detergent solution. Never immerse the motor block in water. Rinse and disinfect with a chlorine solution (100 ppm). Air dry.

What to do if food gets stuck between the blade and the blade guard?

Press STOP, remove the battery, then dislodge the food with a spatula (never use fingers, the blade is very sharp). Put the battery back and continue.

What is the warranty on this blender?

Waring offers a limited one-year warranty against defects in materials and workmanship, provided the appliance is used normally. To obtain service, send the appliance to an authorized center (address in the manual).

Can I use the blender to crush ice?

Yes, but use crushed ice rather than ice cubes for best results.

How long should I charge the appliance after use?

It is recommended to put the blender back on the charger after each use so it is always ready. Leave it charging until the next use.

Is the battery removable?

Yes, the battery can be removed for cleaning or replacement. The manual indicates to always remove the battery before cleaning the blade.

What to do if the blender does not turn on?

Check that the battery is charged and properly installed. Make sure to press both buttons simultaneously. If the problem persists, contact Waring after-sales service.

USER MANUAL Quik Stik Xpress WSB25X Waring Commercial

HIGH LOW POWER ON Lift to Remove STOP WARING WARING COMMERCIAL POWER CHARGS NS

QUIK STIK XPRESS™

WSB25X

For your safety and continued enjoyment of this product, always read the instruction book carefully before using.

When using an electrical appliance, basic safety precautions should always be followed, including the following:

READ ALL INSTRUCTIONS.

1. Unplug from outlet when not in use and before cleaning.
2. To protect against risk of electrical shock, do not put motor base, cord or plug in water or other liquid. The blade guard and shaft of this appliance have been designed for submersion into water or other liquids. Never submerge any other portion of this unit in any liquid.
3. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
4. Keep hands, hair, clothing, and utensils away from blade and mixing container while operating the immersion blender to prevent the possibility of severe injury to persons and/or damage to the blender. A spatula may be used but must be used only when the unit is not operating. Avoid contact with moving parts.
5. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or is dropped or damaged in any manner. Return the appliance to the nearest Waring authorized service facility for examination, repair, electrical or mechanical adjustment.
6. The use of accessory attachments not recommended or sold by Waring for this specific model may result in fire, electric shock or personal injury.
7. Do not use outdoors.
8. Do not let any cord hang over the edge of the table or counter. Do not let cord come into contact with hot surfaces, including stovetop.
9. Do not place on or near a hot gas or electric burner, or in a heated oven.
10. Blade is SHARP. Handle carefully.
11. When mixing liquids, especially hot liquids, use a tall container or make only small quantities at a time to reduce spillage and possibility of injury.

SAVE THESE INSTRUCTIONS

BEFORE YOU BEGIN

NOTE: Always remove the battery pack of the immersion blender before cleaning the metal blade.

Before using the cordless rechargeable immersion blender, Waring suggests that you wipe the unit with a clean, damp cloth to remove any dirt or dust. Place the metal blade end of the hand blender under running water to rinse it. Dry thoroughly with a soft absorbent cloth. Read all instructions completely for detailed operating procedures.

INTENDED USE

The Waring ^b Quik Stik Express ^b Cordless Rechargeable Immersion Blender is intended for use in restaurants, small kitchens and small companies. You can operate directly in the pot to mix and liquefy everything from soups, stews, creams and salad dressings to pancake mixes, pastes, sauces, mayonnaise and much, much more. The Cordless Rechargeable Immersion Blender may also be used to prepare purées of vegetables, porridge, fruit creams, etc. for nurseries or special diets.

OPERATION

1. Plug wall mount charger into outlet.
2. Place immersion blender in charging station. The green light will illuminate while charging. NOTE: Initial charge for the immersion blender will be approximately 15 hours.
3. When immersion blender is fully charged, remove from charging station and immerse the shaft end into the pot. DO NOT SUBMERGE MORE THAN 3/4 OF THE SHAFT LENGTH.
4. The immersion blender has 3 buttons. The safety button is located on the back of the blender. The POWER ON button is located on the front of the unit just below the speed control switch. To start unit, press and release the safety button and the power button simultaneously. Unit will run continuously until STOP button is pressed.
5. Select the desired speed, High or Low, by using the switch below the battery pack.
6. Angle the immersion blender slightly and start to stir only when the blade is immersed. Keep the blade off the bottom of the pot so that container will not be sucked up by the vortex action.
7. When mixing is complete, press the STOP button located below the power ON button.
8. Remove the immersion blender from the pot only after blender has come to a complete stop.

IMPORTANT: Always place immersion blender on charging station after each use. Keep the appliance out of reach of children.

• To prevent splattering, be careful never to remove the immersion blender from liquid while in operation.
• When a recipe calls for ice, use crushed ice (not whole cubes) for best results.

NOTE: If a piece of food becomes lodged in the protective guard surrounding the metal blade, follow the safety instructions noted below:

1. Press the STOP button and remove the battery pack from the immersion blender.
2. Once the power source has been disconnected, use a spatula to carefully remove the food lodged in the blade guard. Avoid injury. The blade is sharp. DO NOT USE YOUR FINGERS TO REMOVE LODGED OBJECTS.
3. After the lodged food has been removed, replace the battery pack and continue processing.

CLEANING INSTRUCTIONS

THE CORDLESS IMMERSION BLENDER MUST BE CLEANED AND DRIED ACCORDING TO THE FOLLOWING INSTRUCTIONS AFTER EACH USE.

For Food Service Applications

IMPORTANT: Always remove battery pack before cleaning.

• Wash, rinse, and sanitize the stainless steel portion of the unit prior to initial use, after each use, or whenever it will not be used again within a period of 1 hour.
• Clean and sanitize the plastic motor housing prior to initial use and after each use.
• Washing solutions based on non-sudsing detergents, and chlorine-based sanitizing solutions having a minimum chloride concentration of 100 PPM are recommended.

The following washing, rinsing, and sanitizing solutions, or their equivalents, may be used.

DILUTION

SOLUTION PRODUCT IN WATER TEMPERATURE

Washing *Ajax® Sanitizer ¼ oz per Hot 115°F (46°C) Cleaner Powder 2½ gallons

Rinsing		Plain water	Warm 95°F (35°C)
Sanitizing	*Clorox® Institutional Bleach	1 Tbl./gallon	Cold 50–70°F (10°–21°C)

- In repetitive use applications, frequent cleaning will prolong life.

To wash and sanitize the immersion blender:

1. Rinse the exterior and interior stainless steel portion of the blender under running water. Scrub and flush the exterior and interior stainless steel portion to dislodge and remove as much food residue as possible.
2. Wipe down the exterior of the plastic housing and the stainless steel portion of the blender with a soft cloth or sponge dampened with the washing solution.
3. Immerse approximately 3/4 of the length of the stainless steel portion in a container of the washing solution and run for two (2) minutes on High.
4. Repeat steps two (2) and three (3) using clean rinse water in place of the washing solution.

NOTE - IMPORTANT

IN ORDER TO MINIMIZE THE POSSIBILITY OF SCALDING, TEMPERATURE OF THE WASHING SOLUTION AND RINSE WATER MUST NOT EXCEED 115°F (46°C).

1. Wipe down the exterior of the plastic housing and the stainless steel portion of the Quik Stik Xpress ^™ immersion blender with a soft cloth or sponge dampened with the sanitizing solution.
2. Immerse approximately 3/4 of the length of the stainless steel portion in a container of the sanitizing solution and run for two (2) minutes on High.
3. DO NOT RINSE AFTER SANITIZING IS COMPLETE. Allow to air dry before use.

NOTE

DO NOT IMMERSE PLASTIC MOTOR HOUSING IN WASHING SOLUTION, RINSE WATER, OR SANITIZING SOLUTION. PREVENT LIQUID FROM RUNNING INTO PLASTIC HOUSING BY WRINGING ALL EXCESS MOISTURE FROM CLOTHS OR SPONGES BEFORE USING THEM.

WarrantY - LIMITED One Year Warranty

Waring warrants every new WARING COMMERCIAL PRODUCT to be free from defects in material and workmanship for a period of 1 year from the date of purchase when used with foodstuffs, nonabrasive liquids (other than detergents) and nonabrasive semi-liquids, provided it has not been subjected to loads in excess of the indicated rating.

Under this warranty, Waring Commercial will repair or replace any part which, upon examination, appears to us to be defective in materials or workmanship, provided the unit is delivered prepaid to the Waring Service Center at 314 Ella T. Grasso Avenue, Torrington, CT 06790, or any Authorized Service Center.

This warranty does not: a) apply to any unit which has become worn, defective, damaged or broken due to use, repairs, or servicing by other than the Waring Service Center or an Authorized Service Center or due to abuse, misuse, overloading or tampering; b) cover consequential damages of any kind.

This warranty gives you specific legal rights, and you may have other rights which vary from state to state so that certain limitations or exclusions set forth above may not apply to you.

WARNING - This warranty is VOID if the appliance is used on Direct Current (D.C.)

SerVICe

Refer to the list of Authorized Service Centers enclosed with your Waring Commercial Product for the name of the nearest Service Center, or contact Waring in one of the following 3 ways:

1) Mail:

WARING Service Center

314 Ella T. Grasso Ave.

Torrington, CT 06790 USA

WARING

COMMERCIAL

2) Phone Product Service:

(800) 4WARING or [phone]

3) Internet: http://www.waringcommercialproducts.com

E-mail: [e-mail]

Ship units for repair to the above address or to an Authorized Service Center. Do not ship to a Waring Sales Office.

Waring Service Center

314 Ella T. Grasso Ave.

Torrington, CT 06790 USA

(800) 4WARING ó [phone]

3) Por Internet:

http://www.waringcommercialproducts.com

Waring Service Center

314 Ella T. Grasso Ave.

Torrington, CT 06790 USA

(800) 4WARING ou [phone]

3) Par Internet:

http://www.waringcommercialproducts.com

©2012 Waring Commercial

314 Ella T. Grasso Ave.

Torrington, CT 06790

www.waringcommercialproducts.com

12WC131095

IB-11367