AR4A20 - Vacuum Cleaner ARDES - Free user manual and instructions

USER MANUAL AR4A20 ARDES

ASH VACUUM CLEANER - Instructions for use

This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.

Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by children without supervision.

If the power cable gets damaged, it has to be replaced only at a service centre approved by the manufacturer in order to avoid a hazard.

Do not leave the unit on if it is not supervised by the user.

The temperature of the ash must not exceed 45^ .

WARNING: do not suck up ash or other incandescent materials (e.g. cigarettes); there is a risk of fire if the temperature of the material to be removed is greater than 45^ .

Do not suck up liquids, flammable and explosive materials, corrosive materials, harmful materials, fire-start materials.

Do not use the unit without the filters in position or with a damaged filter.

Keep the pipe and the filters clean.

Use only the original filters and accessories; in case of need, contact an authorised service centre.

Disconnect the unit from the power supply during cleaning operations.

ATTENTION : read this booklet carefully it contains important instructions for a safe installation, use and maintenance. Important instructions to be kept for future reference.

Keep handy the guarantee, receipt of payment and these instructions for future use and reference.

After removing the packaging, check the appliance for any signs of damage.

In case of visible damage, do not use it and contact a qualified technician.

Do not leave parts of the packaging within the reach of children. This appliance is not a children's toy: it is an electrical device and must be treated with the necessary caution.

Before connecting the appliance, make sure that the power supply voltage matches the indication on the data plate.

If the plug and socket are not compatible, the socket has to be replaced with a suitable type by skilled persons.

Do not use adapters or extension cables which do not meet current safety standards or that exceed the current carrying capacity limits.

When you don't use the appliance disconnect it from the power supply and assure that the interruptor is off.

Do not tug on the power cable or on the appliance itself to remove the plug from the socket.

The use of any electrical appliance requires that a number of basic rules are observed, namely:

• Never touch the appliance with wet or humid hands.
• Do not use the appliance when barefoot.
• Do not leave the appliance exposed to weathering (rain, sunlight).
• Do not subject it to rough handling.

The appliance has been designed and manufactured to operate in the home as ASH VACUUM CLEANER. Any other use is considered inappropriate and dangerous.

Do not use the appliance out of doors.

In case of a breakdown or malfunctioning of the appliance, disconnect it at once.

Do not attempt to repair it, but take it to a service centre approved by the manufacturer.

If you decide you do not want to use this appliance any longer, disable it by cutting the power cable - of course, after disconnecting it from the socket.

The power cable should be extended to its full lenght to avoid over heating.

For safety reasons, the appliance should never be opened.

Place the appliance on a fiat surface during use.

USERINSTRUCTIONS

(see figure at the end of the booklet)

1 - Handle
2 - Switch
3 - Top cover
4 - Container cover
5 - Connection for SUCTION function
6 - Flexible metal hose
7 - Rigid aluminium pipe
8 - Dust shaking button
9 - Locking clip

10 - Container
11 - Filter presence switch
12 - Motor base
13 - Motor ventilation grid
14 - Washable F9 filter
15 - screw for F9 filter
16 - Fireproof fabric filter
17 - Connection for BLOW function

1. Install the F9 filter (14) on the motor base (12) and secure it well with the fixing screw (15). The plastic part of the filter must

press against the filter presence switch (11), otherwise the unit will not work (figure 2 at the end of the booklet).

Note - the filter must be removed and cleaned after each use.

1. Install the fabric filter (16) on top of the F9 filter, making sure that it covers it completely.

Note - the filter must be removed and cleaned after each use.

1. Place the cover (4) on the container (10) and close the locking clip (9).

2. "SUCTION" FUNCTION: connect the flexible metal hose (6) to the suction connection (5)

"BLOW" FUNCTION: connect the flexible metal hose (6) to the blow connection (17).

Note - insert the hose fitting in the guides on the relative connection (5 or 17) and turn it clockwise to lock it in place.

1. "SUCTION" FUNCTION: Make sure that the material to be sucked up has cooled down.

Note - be careful because it may be cool on the outside but still hot on the inside and, when it comes in contact with the air, it may become incandescent again.

1. Position the aluminium pipe (7) near the material to be sucked up or blown.

2. Make sure that the switch (2) is set to "0", then insert the plug in the power outlet.

3. Turn on the unit by turning the switch (2) to position "l".

4. "SUCTION" FUNCTION: Suck up the ash using the aluminium pipe (7).

NOTE: if the suction power decreases during use, perform the following operations: with the unit on, press the dusk shaking button 5 times (8) with the aluminium pipe (7), waiting 2-3 seconds before pressing each time (see figure 3 at the end of the booklet).

If the suction power does not improve, it is necessary to switch the unit off, disconnect it from the power supply and clean the filters (see MAINTENANCE).

"BLOW" FUNCTION: direct the aluminium pipe (7) towards the material to be blown.

1. After use, turn the unit off by turning the switch (2) to position "0".
2. Remove the plug from the power outlet.
3. Remove the flexible hose by turning the fitting counterclockwise. Empty out the container (10), clean the filters (14 + 16) and the hoses (6 + 7) as indicated in the "Maintenance" paragraph.

MAINTENANCE

NOTE: it is advisable to carry out the cleaning operations outdoors Disconnect the plug from the power outlet before performing any cleaning and maintenance operation.

Disconnect the hose (6) by turning it counter-clockwise, open the locking clip (9), remove the cover (4) and remove the filters (14-16).

• Empty out the container (10) and, if necessary, wash it with water.
• Empty out the hoses (6-7) and, if necessary, wash them with water.
• Clean the filters (14-16):

O after each use, shake the filters and remove any dust residues using a brush;
o after several uses, if the suction power seems to have reduced, wash the filters with cold water only, then let them dry completely (24h for F9 filter) before putting it back in place (do not use dryers or other means).

Note: washing in water gradually deteriorates the filters. If, after washing the filters, the suction power still seems reduced, replace the filters.

Reassemble the parts on the unit only when completely dry.

• To clean the unit externally, use a soft and slightly damp cloth.

Do not use overly wet substances, liquids or cloths, because any infiltration could damage the unit irreparably.

Do not use alcohol or chemicals to clean the unit and the filters.

NEVER SOAK THE UNIT IN WATER.

DISPOSAL

USER INFORMATION

"Implementation of Directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE)", pertaining to reduced use of hazardous substances in electrical and electronic equipment, as well as to waste disposal".

The symbol of the crossed-out wheelie bin on the equipment or on its packaging indicates that the product must be disposed of separately from other waste at the end of its service life.

The user must therefore take the dismissed equipment to suitable separate collection centres for electrical and electronic waste.

For more details, please contact the appropriate local authority.

Suitable segregated collection of the equipment for subsequent recycling, treatment or environmentally-friendly disposal helps prevent damage to the environment and to human health, and encourages the re-use and/or recycling of the materials that make up the equipment.

Abusive disposal of the product by the user shall result in the application of administrative fines in accordance with the laws in force.

GUARANTEE

Terms and Conditions

The guarantee is valid for 24 months.

This guarantee applies only if it has been duly filled in and is submitted with the receipt showing the date of purchase.

The guarantee covers the replacement or repair of parts making up the appliance which were faulty at source due to manufacturing faults.

After the guarantee has expired, the appliance will be repaired against payment.

The manufacturer declines any responsibility for damage to persons, animals or property due to misuse of the appliance and failure to observe the directions contained in the instructions.

Limits

All rights under this guarantee and any responsibility on our part will be voided if the appliance has been:

• mishandled by unauthorized persons
• improperly used, stored or transported.

The guarantee does not cover damage to the outward appearance or any other that does not prevent regular operation.

If any faults should be found despite the care taken in selecting the materials and in creating the product, or if any information or advice are required, please contact your local dealer.

AVENTISSEMENTS