Rebel G30037 - Lawn mower G3 Ferrari - Free user manual and instructions

USER MANUAL Rebel G30037 G3 Ferrari

Safety instructions. p. 7

General information. p. 9

G30037 p.9

Operating. p. 9

Maintenance and cleaning. p. 10

Technical features p. 10

Waste of electric and electronic equipment (WEEE

Directive) p. 27

PORTUGUES: p. 10

ESPAÑOL p. 14

DEUTSCH p. 18

FRANCAIS p. 22

This symbol warns the user that un-insulated dangerous voltage inside the system may cause an electrical shock. Do not open the case.

Class II Appliance symbol. The double insulated electrical appliance is one which has been designed in such a way that it does not require a safety connection to electrical earth/ground.

Caution: this symbol reminds the user to read carefully the important operations and maintenance instructions in this owner's guide.

AVVERTENZE DI SICUREZZA

ENGLISH: SAFETY INSTRUCTIONS

The following are important notes on the installation, use and maintenance; save this instruction manual for future reference; use the equipment only as specified in this guide; any other use is considered improper and dangerous; therefore, the manufacturer cannot be held responsible in the event of damages caused by improper, incorrect or unreasonable use.

Before use, ensure the equipment is undamaged; if in doubt, do not attempt to use it and contact the authorized service center; do not leave packing materials (i.e. plastic bags, polystyrene foam, nails, staples, etc.) within the reach of children as they are potential sources of danger; always remember that they must be separately collected. Make sure that the rating information given on the technical label are compatible with those of the electricity grid; the installation must be performed according to the manufacturer's instructions considering the maximum power of the appliance as shown on the label; an incorrect installation may cause damage to people, animals or things, for which the manufacturer cannot be considered responsible thereof.

If it is necessary to use adapters, multiple sockets or electrical extensions, use only those that comply with current safety standards; in any case do not exceed the power consumption limits indicated on the electrical adapter and / or extensions, as well as the maximum power shown on multiple adaptor.

Do not leave the unit plugged; better to remove the plug from the mains when the device is not in use. Always disconnect from power supply if you leave it unattended.

Cleaning operations should be carried out after unplugging the unit.

If the unit is out of order and you do not want to fix it, it must be made inoperable by cutting power cord.

• Do not allow the power cord to get closer to sharp objects or in contact with hot surfaces; do not pull it to disconnect the plug.
• Do not use the appliance in the event of damage to the power cord, plug, or in case of short circuits; to repair the product only address an authorized service center.
• Do not handle or touch the appliance with wet hands or bare feet. Do not expose the appliance to harmful weather conditions such as rain, moisture, frost, etc.. Always store it in a dry place.
• This appliance can be used by children of 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they received supervision or instruction concerning use of the appliance in a safe way and understand hazards involved; children shall not play with the appliance; cleaning and user maintenance shall not be made by children without supervision.
• Children must not play with the appliance.
• Keep the appliance and its cord out of reach of children less than 8 years.
  If the power cord is damaged, or in case of failure and / or malfunction do not tamper with the unit. The reparation must be done by manufacturer or by service center authorized by the manufacturer in order to prevent any risk. Failure to comply with the above may compromise the unit safety and invalidate the warranty.
• This appliance is intended to be used in household and similar applications such as: staff kitchen areas in shops, offices and other working environments; by clients in hotels, motels and other residential type environments; farm houses, bed and breakfast type environments.
• The appliance is not intended to be operated by means of an external timer or separate remote-control system.

• Before every use, unroll the power cord.

• Use original spare parts and accessories only.

• Do not subject the product to strong impacts, serious damages may result.

Do not use near or under flammable materials (like curtains), heat, cold spots and steam.

GENERAL INFORMATION

WARNING: never use the unit for any reason inside the bath or in the shower. If it should fall into the water does not pick it up and immediately disconnect the power plug. Avoid any splashes of water from getting inside of it. If this happens, the hair clipper must be checked by qualified personnel before operating it again.

• Do not immerse the appliance in water or other liquids.
• Use extreme caution when using: do not use in a state of sleepiness and perform delicate movements.
• Do not use on wigs or irritated skin.
• Do not use the clipper for more than 10 minutes continuously and allow to completely cool down for at least 5 minutes.
• Power off the device while changing attachment.
• Clean and lubricate the clipper regularly to ensure better performance and longer life.
• Never leave the appliance unattended while it is running.
• Do not wrap the power cord around the unit during use.

DESCRIPTION G30037

1. Cutting blade
2. Blade lever
3. On-off button
4. Spacer combs
5. Hair comb
6. Scissors
7. Lubricating oil
8. Small brush

OPERATING

Turn the power switch (3) to "0" and insert the power plug into the electrical outlet. Install one of the available combs. The choice of the comb depends on the length of hair that you want to achieve.

Comb 4A:

3mm

Comb 4B:

6mm

Comb 4C:

9mm

Comb 4D:

12mm

To insert a comb, align the cutting blade and push until it snaps in position.

Also, use the lever (2) to decrease or increase the length of the cut (see figure). You can use the clipper without comb only if you are using the hair comb (5) or if you want to make precision finishes.

• Once finished cutting operation, turn off the device by setting the power button (3) to "0" position.
• Let it cool down then store the clipper and its accessories out of the reach of children.

MAINTENANCE AND CLEANING

Disconnect the clipper from the power adaptor, and unplug it from the power outlet before starting any cleaning operations.

After each cut, always clean used comb and cutting blade by blowing over them or using the small brush (8). Use supplied lubricating oil (7) for the blade (see figure). 2 or 3 drops are enough if this operation is carried out frequently. Use only the provided oil or similar oil without acids. Clean the main body by using a soft damp cloth, never immerse the unit in water or other liquids.

ALIGN THE BLADE

Before using for the first time and after each cleaning of the blades, especially if you have removed the fixed blade, ensure that it is realigned correctly (about 1.2mm between fixed blade and moving blade). If the alignment is not correct, put 2 drops of oil on the blade, turn the product on for 5 seconds, pull the plug and loosen the screws of the fixed blade. Realign the blades and tighten the screws.

TECHNICAL FEATURES

• Power supply: AC 230V~50Hz - 7W power
• Cutting heights from 3 up to 12mm - Cutting lever
• Accessories: 4 spacer combs, scissors, hair comb, lubricating oil, small brush

PORTUGUES: ADVERTÉNCIAS

The product is made of non-biodegradable and potentially polluting substances if not properly disposed of; other parts can be recycled. It's our duty to contribute to the ecological health of the environment following the correct procedures for disposal. The crossed out wheelie bin symbol indicates the product complies with the requirements of the new directives introduced to protect the environment (2002/96/EC, 2003/108/EC, 2002/95/EC, 2012/19/EC) and must be properly disposed at the end of its lifetime. If you need further information, ask for the dedicated waste disposal areas at your place of residence. Who does not dispose of the product as specified in this section shall be liable according to the law.

RESIDUOS DE APARELHIOS ELECTRICOS E ELECTRONICOS

To find the nearest service center, please call the telephone number 0541 694246, fax number 0541 756430 or contact us at [e-mail] asking for the service centers supervisor.

Appliance is conform to the pertinent European regulation and is therefore marked with the CE mark.

www.g3ferrari.it TREVIDEA S.r.l.