IAN 76617 - Air bed Meradiso - Free user manual and instructions

USER MANUAL IAN 76617 Meradiso

Operation and Safety Notes

SE

KOMfOrtAbeDubbelluftMADrAss

GB/IEOperation and Safety NotesPage 5

Introduction / Safety advice

Double Air Bed

Introduction

Before using the product for the first time, take time to familiarise yourself with the product first. Read the following instructions

for use and safety instructions carefully. Only use the product as described and for the designated areas of application. Please keep these instructions in a safe place. If you hand this product on to a third party, you must also pass on all documents relating to the product.

IntendedUse

The product is intended for leisure and camping use. The product is not suitable for children under the age of 3. Any use other than previously mentioned or any product modification is prohibited and can lead to injuries and / or product damage. The manufacturer is not liable for any damages caused by any use other than for the intended purpose. The product is not intended for commercial use.

Description of parts and features

1 End cap
2 Valve opening
3 Stopper
4Buckle
5 Attachment for pillow
6 End cap
7 Valve opening
8 Valve (for pillow)
Self adhesive repair patch
[10] Air bed
11 Pillow
12 Carrying bag

-Technicaldata

Dimensions: approx. 195 × 81 × 25 cm

(L× W× H) per single bed

Max. load: 140 kg per single bed

Rated air pressure: 0.38 PSI (0.026 bar)

- Scope of delivery

2 Air beds
2 Pillows
2 Self adhesive repair patches
1 Carrying bag
1 Set of directions for use

Safety advice

KEEP ALL THE SAFETY ADVICE AND INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE!

WARNING! RISK OF FATAL INJURY AND RISK OF ACCIDENTS FOR INFANTS AND

CHILDREN! Never leave children unattended with the packaging material or the product. There is a risk of suffocation from the packaging materials and a risk of fatal injury by strangulation. Children often underestimate dangers.

DANGYIONING!

LIFE! Always keep the product out of reach of children under 3 years of age. The packaged product includes some small parts which could endanger life if swallowed or inhaled.

CAUTION! RISK OF INJURY! Make sure that all parts are undamaged. Damaged parts could adversely affect safety and function.

CAUTION! RISK OF INJURY! Make sure that you do not pump too much air into the product. Otherwise the product may burst.

Make sure that the product is only used by competent persons.

CAUTION! RISK OF INJURY! Do not use this product as a swimming aid.

5GB/IE

Safety advice/Operation

• Keep flocked surface of airbed away from moisture.
  Do not use the product in water.
  CAUTION! Keep away from fire. Otherwise damage to the product can result.
  CAUTION! RISK OF POISONING AND RISK OF DAMAGE TO PROPERTY! Do not light a fire in the vicinity of this product and keep it away from heat sources.
  Please make sure that this product is placed on a level surface and not on any sharp or pointed objects. Otherwise damage to the product can result.
  Do not wash the product in the washing machine.
  CAUTION!Make sure that you do not load more than 140kg onto each single bed. Otherwise this could result in injuries and/or damage to the product.
  Use the valve, 8 only together with suitable pump adapters. Otherwise this may result in damage to the valve 2, 8.

Operation

- Pumping up airbed and pillow

Note: Before using the product for the first time, check it carefully for holes, porous places and seams that are not airtight.

Recommendation: Pump the product up and leave it alone for one day. Let a new product air outside in fresh air for a couple of days.

CAUTION! Inflatable plastic products react sensitively to the cold and hot. That is why you should never use the product when the ambient temperature falls to below 15^ and rises above 40^ . Otherwise damage to the product may result.

Note: Basically, only an adult should be responsible for pumping the airbed up. Make sure that you do not pump too much air into the product. On no account should you use a compressor. Stop the process when resistance increases during pumping and the seams start to stretch. Otherwise the material might tear. Only use manual pumps and / or

pumps specifically designed for use with inflatable plastic products.

Roll the product out first and then check for holes, tears and other damage (see Fig. A).
Turn the end cap 1 of the valve opening 2 anti-clockwise off the air valve in order to open it.
Take the end cap 6 off the valve opening 7 in order to open the valve 8.

Pump the product up.

First pump the air b up and then attach the pillow 11 (see Fig. C).

IMPORTANT! Keep in mind that air temperature and weather conditions can affect the air pressure inside inflatable products. In cold weather the product behaves as if it has less air pressure in it because the air inside contracts. Under these conditions you may have to add air. In hot weather the air inside expands. Under these conditions you may have to remove air in order to avoid overfilling.

Turn the end c b of the valve opening 2 clockwise onto the air valve to close it.
Place the end onto the valve opening 7 in order to close the valve 8.

- Deflating airbed and pillow

Turn the stopper 3 anti-clockwise to open the air valve.
Pull the end cap 6 off the valve opening 7 in order to open the valve 8.
□ Allow the air to escape completely.
Slowly fold the product together (see Fig. A).

Note: Make sure that the product is completely dry before folding it together.

Fixing the single beds together

If need be, the two single air beds 10 can be fixed together either on top of each other or side by side in order to raise the surface you can lie on or to expand it.

Operation / Maintenance / Cleaning and care / Disposal

Push the buckles into each other to close the buckles (see Fig. D 1-2).
Press the buttons of the buckles down and pull them apart in order to open the buckles 4 (see Fig. D 3-4).

Fixing them on top of each other:

Remove the pill from one of the air beds 10 and place the other air bed 10 flush on top of it (see Fig. E).
Close the buck on the side as described above.

Fixing the beds side by side:

Place the two air beds next to each other so that the ends with the pillows 11 point in the same direction (see Fig. C).
Close the buck es as described above.

- Maintenance

Mending airbed and pillow

Note: Minor damage may be repaired using the supplied self adhesive repair patches 9.

First let the air out of the product (see "Deflating airbed and pillow").
Clean the damaged area with alcohol.
Abrade the area around the site of the damage with fine sandpaper.
Cut out a piece of the repair patch. Note: Make sure that the repair patch largely overlaps the edges of the leak.
Round the corners off and place the repair patch over the leak or hole. Use a pencil to draw around the edges of the repair patch.
Place the repair patch onto the damaged part.
Press the repair patch firmly down onto the leak. You may have to place a heavy object onto the relevant area.
Wait for 24 hours before you pump up the product again.

- Cleaning and care

Do not use corrosive or abrasive cleaning agents.
Clean the flocked surface of the product using a brush.
Clean the plastic surfaces with water and / or a little mild soap solution.
Do not expose the product to extreme weather conditions such as extreme temperature, wind and rain.
Do not allow the product to be subjected to frost.
Ensure that the inside and outside of the product are completely dry if you intend to store it indoors for a long period. Failure to observe this advice could result in the build-up of mildew and mould.
Fold up the product with the flocked surface on the inside.
Store the product in dark, dry place - out of reach of children.
The ideal storage temperature is between 10 and 20^
Make sure that the va, 8 is shut if you wish to store the product for any length of time.
Do not allow sharp objects to come into contact with the product while it is in storage.
Never powder the product with talcum.

- Disposal

The packaging is made entirely of recyclable materials, which you may dispose of at local recycling facilities.

Contact your local refuse disposal authority for more details of how to dispose of your worn-out product.

Lit gonflable comfort double

Introduction