AR1K20 - Uncategorized ARDES - Free user manual and instructions

USER MANUAL AR1K20 ARDES

AND ABOVE AND INDIVIDUALS WITH REDUCED

WITH THE UNIT. CLEANING AND MAINTENANCE

After removing the packaging, check the appliance for any signs of damage. In case of visible damage, do not use it and contact a qualied technician. Do not leave parts of the packaging within the reach of children. This appliance is not a children’s toy: it is an electrical device and must be treated with the necessary caution. Before connecting the appliance, make sure that the power supply voltage matches the indication on the data plate. If the plug and socket are not compatible, have the socket replaced with a suitable type by skilled persons. Do not use adapters or extension cables which do not meet current safety standards or that exceed the current carrying capacity limits. Disconnect the appliance from the power supply socket whenever it is not in use. Do not tug on the power cable or on the appliance itself to remove the plug from the socket. The use of any electrical appliance requires that a number of basic rules are observed, namely: - Never touch the appliance with wet or humid hands. - This appliance must not be used by individuals (including children) with diminished physical, sensory or mental abilities or who lack the experience or knowledge on how to operate it unless they are supervised or have been instructed on the use of the appliance by someone who is responsible for their safety. Children must be supervised to make sure that they do not play with the appliance. - Do not use the appliance when barefoot. - Do not leave the appliance exposed to weathering (rain, sunlight). - Do not subject it to rough handling. In case of failure, disconnect it at once. Do not attempt to repair it, but take it to a service centre approved by the manufacturer. If you decide you do not want to use this appliance any longer, disable it by cutting the power cable - of course, after disconnecting it from the socket. If the power cable gets damaged, have it replaced only at a service centre approved by the manufacturer. In case of a breakdown or malfunctioning of the appliance, disconnect it at once. Do not attempt to repair it, but take it to a service centre approved by the manufacturer. The appliance has been designed and manufactured to operate in the home. Any other use is considered inappropriate and dangerous. 8Do not use the appliance out of doors. During use, rest the appliance on a at surface. The accessible surfaces of the appliance may be hot when it is operating. For safety reasons, the appliance should never be opened. Wait until the cylindrical immersion heater has cooled fully before putting it back into its box. The cylindrical immersion heater can become very hot and it warms the water in the container in which it is immersed. Use a pot coaster to protect your worktop from any container used with the device. Use clamps to pick any object inside the water bath. Be extremely careful when moving containers lled with hot water. Technical informations This product has been manufactured in conformity to current 2014/35/EU and 2014/30/EU. Technical data indicated on the appliance.

3 - Water level markings

9Instructions for use Insert the heater in the cooking container and secure it to the latter’s walls with the clamp (5). Fill the container with water to a level that falls between the two MIN and MAX marks (3) on the cylindrical immersion heater (4). Switch the heater on by pressing the relevant button for a few seconds. When the display (1) lights up the following indications will appear: - the water temperature setting for cooking, on the top right-hand side (SET TEMP); - the actual water temperature when the cylindrical immersion heater is immersed, expressed in °C, in the centre of the display; - the cooking time to be set (SET TIME), on the bottom left-hand side; - the elapsed cooking time, which varies gradually as the device operates (WORK TIME), on the bottom right-hand side. After switching the device on, set the temperature to be reached by the water, up to maximum 95°C. Turn the adjustment knob (2) downwards or upwards until reaching the desired value. The temperature can be varied at any time during cooking. Press the SET button once to set the cooking time in hours and a second time for the minutes; make the adjustments with the same knob used for adjusting the temperature. Both the hours and minutes can be set to between 1 and 59. Once the cooking settings have been dened, start the device by pressing the switch-on button again. The water will start heating up and you will notice that the water temperature shown in the centre of the display will start rising until reaching the temperature set on the top right-hand side. The heater will then emit three buzzes repeatedly at regular intervals for a few seconds, until the SET button is pressed for 2 seconds. At this point, you can immerse the prepared foodstuffs in the bag. CAUTION: if the food is vacuum-packed, you can immerse the bags completely into the water, but if the bag has an opening/closing zone, the latter must be left out of the water after letting all the air escape from the bag and hermetically sealing the opening. Should water penetrate the bag in contact with the food, the cooking principle of this device will be entirely lost. While the device heats, the countdown will start on the bottom right- hand side of the display. Cooking terminates when the set temperature is reached. The device will emit three buzzes repeatedly at regular intervals. The food can now be removed from the pot or container. 10Maintenance If the water evaporates during cooking and drops below the minimum mark, the device will switch off automatically. CAUTION: the water may be very hot, therefore use clamps or protective utensils to avoid the risk of burns while removing the food. This appliance does not require any special maintenance. Disconnect the plug from the socket and let the appliance cool down well before cleaning it. Before cleaning the device, always disconnect the power cord from the socket and leave the heater to cool completely. In order to avoid scale build-up on the cylindrical immersion heater, perform the following cleaning operations at least once a month: Insert the device in the container and ll the latter with water up to the MAX mark on the cylindrical immersion heater. Set the temperature to 70°C and add 5 g of citric acid (edible) per litre of water. Operate the heater for 20 minutes after the water has reached the set temperature of 70°C. Switch the device off and pull out the plug, then leave it to cool and wash the lower part of the heater in cold water. Strictly avoid using abrasive products or chemical solvents. NEVER IMMERSE THE HEATER’S DISPLAY IN WATER. Dry the device fully before storing it away. Periodically check that there are no cuts or burnt section along the power cord. Do not use the device if its power cord gets damaged, but pull out the plug and contact an authorised technical assistance centre. Dry carefully the appliance before to put it back. Periodically make sure the power cord is not cut or burnt. If the cable should have been damaged, do not use the appliance, remove the plug and contact an authorized after sales service centre. Fault legend. Error code: E02. The digital thermostat is broken. Contact the technical assistance centre. Error code: E05. Verify that the water level falls between the MIN and MAX marks. Switch the device off before raising the water level.

NEBO ZNALOSTÍ, KDYŽ JIM BYL ZAJIŠTĚN

GUARANTEE Terms and Conditions The guarantee is valid for 24 months. This guarantee applies only if it has been duly lled in and is submitted with the receipt showing the date of purchase. The guarantee covers the replacement or repair of parts making up the appliance which were faulty at source due to manufacturing faults. After the guarantee has expired, the appliance will be repaired against payment. The manufacturer declines any responsibility for damage to persons, animals or property due to misuse of the appliance and failure to observe the directions contained in the instructions. Limits All rights under this guarantee and any responsibility on our part will be voided if the appliance has been: - mishandled by unauthorized persons - improperly used, stored or transported. The guarantee does not cover damage to the outward appearance or any other that does not prevent regular operation. If any faults should be found despite the care taken in selecting the materials and in creating the product, or if any information or advice are required, please contact your local dealer. USER INFORMATION pursuant to art. 26 of Italian Legislative Decree no. 49 of 2 April 2014 “Implementation of Directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE)”, pertaining to reduced use of hazardous substances in electrical and electronic equipment, as well as to waste disposal”. The symbol of the crossed-out wheelie bin on the equipment or on its packaging indicates that the product must be disposed of separately from other waste at the end of its service life. The user must therefore take the dismissed equipment to suitable separate collection centres for electrical and electronic waste, or return it to the dealer in case they purchase a new device of equivalent type, at a one-to-one-ratio. Suitable segregated collection of the equipment for subsequent recycling, treatment or environmentally-friendly disposal helps prevent damage to the environment and to human health, and encourages the re-use and/or recycling of the materials that make up the equipment. Abusive disposal of the product by the user shall result in the application of administrative nes in accordance with the laws in force.44