Stylistic R727 - Tablet FUJITSU - Free user manual and instructions

USER MANUAL Stylistic R727 FUJITSU

http://support.ts. fujitsu.com/Manuals/", joint au manuel d’utilisation de votre appareil. Regulatory notices If there is no FCC logo and also no FCC ID on the device then this device is not approved by the Federal Communications Commission (FCC) of the USA. Although it is not explicitly forbidden to travel the US trading area ca rrying this device, but to avoid trouble at customs clearance Fujitsu Technology Solutions GmbH recommends no t to bring this device into the US trading area. On your STYLISTIC R727, the FCC ID information can be retrieved by th e following steps: With keyboard

1. Press the ON/OFF button to sw itch the device on.

key to enter the BIOS Setup Utility.

3. Press the Enter key to see the information on Reg ulatory C ompliance.

1. Press the ON/OFF button to switch the device on, and keep the volume up

button pressed to enter the BIOS Setup Utility.

2. Tap on the Display Regulatory Compliance menu entry.

Regulatory information for Tablet PCs without radio device Regulatoryinform ation NOTICE: Changes or modifications not expressly approved by Fujitsu Technology Solutions could void this user’s authority to operate the equipment. Notice to Users of Radios and Television These limits are designed to provid e reasonable protection against harmfu l interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance w ith the instructions, may cause harmful interference to radio communications. However, there is no g uarantee that interference will not occur in a 86 FujitsuRemarques du constructeur particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or m ore of the following mea sures:

• Reorient or relocate the receiving antenna.

• Increase the sep aration between the equipment and receiver.

• Connect the equipment into an outlet that is on a different circuit than the receiver.

• Consult the dealer or an experienced radio/TV technician for help. Notice to Users of the US Telephone Network Your Tablet PC may be supplied with an internal modem which complies with Part 68 o f the FCC rules. On this Tablet PC is a label that contains the FCC Registration Number and the Ringer Eq uivalence Number (REN) for this equipment among other information. If requested, the user must provide their telephone company with the following information:

1. The telephone number to which the Tablet PC is connected.

2. The Ringer Equivalence Number (REN) for this equipment.

3. The equipment requires a standard m od ular jack type USOC RJ-11C

which is FCC Part 68 compliant.

4. The FCC Registration Number.

This equipment is designed to be connected to the telephone network or premises w iring using a standard mod ular jack type USOC RJ-11C which is FCC Part 68 compliant and a line cord between the modem and the telephone network w ith a minimum of 26AWG. The R EN is used to determine th e number of devices that you may co nnect to your telephone line and still have all of those devices ring when your number is called. Too many devices on one line may result in failure to ring in response to an incoming call. In most, but not all, areas the sum of the RENs of all of the devices should not exceed five (5). To be certain of the nu m ber of devices you may conn ect to your line, as determined by the RENs, contact your local telephone company. If this equipment causes harm to the telephone network, your telephone company may discontinue your service temporarily. If possible, they will notify you in advance. If advance notice is not practical they will notify you as soon as possible. You will also be advised of your right to file a c omplaint with the FCC. This fax modem also c omplies with fax branding requirements per FCC Part 68. Your telephone company will probably ask you to disconnect this equipment from the telephone network until the problem is corrected and you are sure that the equipment is not malfunctioning. This equipment may not be used on coin-op erated telephones provided by you r telephone company. Connection to party lines is subject to state tariffs. Contact your state ’s pu blic utility commission, public service commission or corporation commission for more information. This equipment includes automatic d ialing capability. When programming and/or making test calls to emergency numbers:

• Remain on the line and briefly explain to the dispatcher the reason for the call.

• Perform such activities in off-peak hours, such as early morning or late e vening. FCC rules prohibit the use of non-hearing aid com patible telephone s in the following locations or ap plications:

• All public or semipublic coin-operated or credit card telephones.

• Elevators, highways, tunnels (automobile, subway, railroad or pedestrian) where a person with impaired hearing might be isolated in an em ergency.

• Places where telephon es are speci fically installed to alert emergency authorities such as fire, police or medical assistance personnel. Fujitsu 87Remarques du constructeur

• Hospital rooms, residential health care facilities, con valescent homes and prisons.

• Hotel, motel or apartment lobbies.

• Stores where telephones are used by patrons to order merchandise.

• Public transportation terminals where telephones are used to call taxis or to reserve lodging or rental cars.

Pour assurer la sécurité, les utilisateurs doivent véri fier que la prise de terre du service d’électricité, les lignes télphoniques et l es conduites d’eau métalliques s ont connectées ensemble. Les utilisateurs NE doivent PAS t enter d’établir ces connexions eux-mêmes, mais doivent contacter les services d’inspection d’installations électriques appropriés ou un électricien. Ceci peut être particu lière ment important en régions rurales. UL Notice This unit requi res an AC adapter to operate. Use only UL List ed Class 2 adapter. The correct ou tput rat ing is indicated on the AC adapter label. Refer to the illustration below for the c orrect AC Adapter output polarity: CAUTION: To reduce the risk of fire, use only 26AWG or larger telecommunica tions line cord. For Authorized Repair Technicians Only CAUTION: For continued protection against risk of fire, replace only with the same type and rating fuse. WARNIN G: Danger of explosion if Lithium (CMOS) battery is incorre ctly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instruction. Fujitsu 89Remarques du constructeur FCC Regulatory information for Tablet PCs with radio device Regulatoryinform ation Federal Communications Commission statement This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device. FCC Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This e quipment generates, uses, and can radiate radio f requen cy energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment doe s cause harmful interference to radio or television reception, which can be determined by turn ing the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.

2. Increase the distance between the equipment an d the receiver.

3. Connect the equipment to an outlet on a circuit different from the one the receiver is connect ed to.

4. Consult the dealer or an experienced radio/TV technician for help.

Please no te the following regulatory information related to the optional radio d evice. FCC Radio Frequency Exposure statement This radio device has been evaluated under FCC Bulletin OET 65C and found compliant with the requirements as set forth in CFR 47 Sections 2.1 091, 2.1093, and 15.247 (b) (4) addressing RF Exposure from radio frequency devices. The radiated output power of this radio device is far below the FCC radio frequ ency exposure limits. Nevertheless, this device shall be used in such a m an ner that the potential for human contact during normal operation is minimized. When using this device, a certain separation distance between antenna and nearby persons must be maintained to ensure RF exposure compliance. In order to comply with RF exposure limits established in the ANSI C95.1 standards, the distance between the antennas and the user should not be less than 20 cm (8 inches). Regulatory Notes an d S tatem ents Radio device, Health and Authorization for use Radio frequency electromagnetic energy is emitted from the radio devices. The energy levels of these emissions, however, are far much less than the electromagnetic energy emissions from wireless devices such as mobile phones. Radio devices are safe for use b y consumers because they operate within the guidelines found in radio frequen cy safety standards and recommendations. The use of the radio devices m ay be restricted in some situations or environme nts, such as:

• on board an airplane, or

• in an explosive environment, or

• in situations where the interference risk to othe r devices or services is perceived or identified as harmful. In cases in which the policy regarding use of radio de vices in specific environments is not clear (e.g., airports, hospitals, chemical/oil/gas industrial plants, private buildings), obtain authorization to use these devices prior to operating the equipment. 90 FujitsuRemarques du constructeur Regulatory Information/Disclaimers Installation and use of this radio device must be in strict accordance with the instructions included in the user d ocumentation provided with the product. Any changes or modifications made to this device that are not expressly approved by the manufacturer may void the user’s authority to operate the equipment. The manufacturer is not responsible for any radio or television interference caused by unauthorized mo dification of this device, or the substitution or attachment of connecting cables and equipment oth er than those specified by the manufacturer. It is the responsibility of the user to correct any interference caused by such unauthorized modification, substitution or attachment. The m anufa cturer and its authorize d resellers or distributors will assume no liability for any damage or violation of government regulations arising from failure to comply with these guide lines. Export restrict ion s This product or software contains encryption code which may not be exported or transferred from the US or Canada without an approved US Department of Commerce export license. This device complies with Part 15 of FCC Rules, as well as ICES 003 B / NMB 003 B. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesirable operation. Modifications not expressly authorized by Fujitsu Technology Solutions may invalidate the user’s right to operate this equipment. Fujitsu 91Index Index