Ambient 04.1540.0011 - Uncategorized WMF - Free user manual and instructions

USER MANUAL Ambient 04.1540.0011 WMF

Instruction manual Before use The appliance may be used only for the intended purpose and in accordance with this instructionmanual. You are therefore advised to read the instruction manual carefully before use, as it providesinstructions for using, cleaning and caring for the appliance. We acceptno liability for any damage caused if the instructions in this manual are not followed. Keep this instruction manual in a safe place and pass it on to any subsequent user together with the appliance. The safety precautions must be observed during use. Technical information about the mains adapter Mains voltage: 220–240 V~, 50–60 Hz Power consumption: 2.5 watts Protection class: III Additional safety information

• The mains adapter should be connected only to earthed wall sockets that have been installed in accordance with the regulations. The power cable and plug must be dry. ▪ Do not pull or clamp the connection cable over sharp edges. Do not leave it dangling. Protect it from heat and oil. ▪ Only use an extension cable if it is in perfect condition. ▪ Never pull the mains adapter out of the socket by the cable or with wet hands. ▪ Do not place the appliance on hot surfaces, such as hotplates or near open gas flames, as this could melt the casing. ▪ When the appliance is not being used, pull the mains adapter out of the socket. ▪ Never place the LED insert in water or clean it with water. Only clean it with a damp cloth. ▪ Stop using the appliance and/or unplug the mains adapter immediately if: ⋅ The appliance, cable or mains adapter is damaged; ⋅ You suspect that there is a defect after the appliance has fallen or suffered a similar incident; ⋅ The appliance is leaking. ▪ In such cases, arrange for the appliance to be repaired. ▪ No liability is accepted for any damage resulting from misuse, incorrect operation or improper repair. Warranty claims are likewise excluded in such cases. ▪ Warning: only charge the rechargeable batteries using the enclosed USB plug. ▪ Note: risk of frostbite if the coolpack is in direct and prolonged contact with skin. Use The WMF AMBIENT champagne and wine cooler is suitable for chilling wine, champagne and water bottles with a diameter of up to 92 mm. Important safety information

• This appliance is not a toy.

• Appliances can be used by persons with reduced physical, sensory or mental capacities or a lack of experience and/or knowledge if they are supervised or have been instructed on how to use the appliance safely and they understand the hazards involved.

• This appliance may not be used by children. Keep the appliance and its power cord out of the reach of children.

• Only use the appliance with the correct mains adapter.

• If the mains adapter is damaged, it must be replaced. This is available from the manufacturer or its customer service department.

• This appliance is designed for use in households and similar environments, such as: ⋅ Staff kitchen areas in shops, offices and other commercial environments; ⋅ Farmhouses; ⋅ By guests at hotels, motels and other residential facilities; ⋅ At bed-and-breakfast establishments.

• The appliance is not intended for purely commercial use.

• Always disconnect the appliance from the mains supply if it is to be left unattended, as well as before assembling, disassembling or cleaning it.

• The appliance is designed for indoor household use only. en10 11

Three ways in which the LED lights on this appliance work: ⋅ Example 1: the wine cooler is connected to the power socket via the USB adapter Once the ON/OFF switch on the wine cooler is in Position I, the LED light can be switched on via the Easy Touch function on the base of the wine cooler: 1st Touch: 10% brightness 2nd Touch: 50% brightness 3rd Touch: 100% brightness 4th Touch: off ⋅ Example 2: the wine cooler is connected to the power socket via the USB adapter and rechargeable batteries are also inserted The same as example 1. In addition, a green LED will blink at the bottom of the light ring (approx. every 2 seconds) to indicate that the rechargeable batteries are not fully charged. The green LED will switch off once the rechargeable batteries are fully charged. ⋅ Example 3: only batteries/rechargeable batteries are being used If the ON/OFF switch is in Position I, a green LED on the bottom of the ring will be continuously illuminated. This indicates that the energy being used is supplied by the rechargeable batteries. At the top brightness level (100%), standard non-rechargeable batteries will last around 4 hours. Tip: reduce the level of brightness to prolong battery life and illumination. Switching WMF Ambient light on and off using the WMF Easy Touch function

• The WMF Easy Touch function allows for easy operation of the LED light.

• Touch the stainless steel casing on the base to switch the illumination on and off. Repeatedly touching the casing cycles through the three brightness settings and then switches the light off. 1st Touch: 10% brightness 2nd Touch: 50% brightness 3rd Touch: 100% brightness 4th Touch: off Initial operation Please note that no electrically conductive objects should be placed near the device, and ensure that the cable is not twisted to guarantee trouble-free use of the WMF Easy Touch function. Coolpack The coolpack is included in the box of the WMF AMBIENT champagne and wine cooler. This should be chilled in the freezer at a temperature of –18°C for at least four hours before use in the champagne and wine cooler to achieve the maximum cooling. USB adapter The box includes a USB adapter. This powers to the LED light or recharges the rechargeable batteries, if being used. Batteries/rechargeable batteries Batteries/rechargeable batteries are not included. Either batteries (AA) or rechargeable batteries can be used in this cooler. All batteries must have the same capacity and should ideally be the same age.

WARNING: do not connect the USB cable if non-rechargeable batteries are being used. There

is a risk that the batteries might leak and this could cause considerable damage to health or personal injury. Removing/inserting upper LED light ring The upper LED light ring can be removed so the coolpack can be easily taken out for cleaning. When putting in the LED light ring, please note that it can only be inserted in one position. The triangles printed on the top of the light ring and in the casing of the wine cooler provide guidance for inserting the upper LED light ring. A click will confirm that the light ring has been correctly positioned. The LED light ring will only work if the ring has been placed correctly. Initial operation of LED light Once the coolpack and upper LED light ring have been inserted in the wine cooler from the top, the ON/ OFF switch on the bottom of the wine cooler should be in Position 1 to switch on the light. It must be switched on for the LED to work. Then, simply touch the base of the stainless steel casing and the wine cooler will be illuminated This appliance features decorative LED illumination at the top and bottom of the stainless steel casing. The individually controllable ambient light has three different brightness settings.12 13

Cleaning and care Unplug the mains plug before cleaning. Unplug the mains plug and remove the cable from the stainless steel casing. Under no circumstances should you immerse the LED insert and stainless steel casing in water. If necessary, simply wipe the outside with a damp cloth. Never use abrasive cleaning agents. The appliance complies with European directives 2014/35/EU, 2014/30/EU and 2009/125/EU. At the end of its life, this product must not be disposed of in normal household waste but must instead be delivered to a collection point for recycling electrical and electronic appliances. The materials are recyclable in accordance with their labelling. Reuse, recycling and other ways of reusing old appliances make an important contribution to protecting our environment. Please ask your local authorities for information about the appropriate disposal point. Subject to change.14 15