HZ31 - Massage device INVENTUM - Free user manual and instructions

Frequently Asked Questions - HZ31 INVENTUM

USER MANUAL HZ31 INVENTUM

explanation of symbols page 10

1. safety instructions page 12
2. appliance description page14
3. intended use page 14
4. operation page14
5. cleaning & maintenance page 15
   6.storage page 16
6. disposal page 16
   8.problems & solutions page 16

general terms and conditions of service and warranty page 33

Deutsch

explanation of symbols

	Read the instructions!		Do not wash.
			Do not bleach.
	Do not insert pins!		Do not dry in dryer.
			Do not iron.
	Do not use when the foot warmer is folded or rolled!		Do not dry clean.
		OEKO-TEX® CONFIDENCE IN TEXTILES STANDARD 100 06.0.43510 Hohenstein HTI Copied on Schadabrach Genetec s/n schadabrach office Tested for harmful substances www.oeko-tex.com/tested100	The textiles used for this device meet stringent human ecological requirements of Oeko-Tex Standard 100, as verified by Hohenstein Research Institute.
0-3	Do not use for very young children (0-3 years of age).
	Dispose of the packaging in an environmentally friendly way.		Manufacturer
CE	This product satisfies the requirements of the applicable European and national directives.	KEMA EUR	A quality mark for electrical appliances that meet the safety requirements of DEKRA SE (formerly KEMA).

The device has double protective insulation and therefore complies with protection class 2.	Please dispose of the device in accordance with EC Directive - WEEE (Waste Electrical and Electronic Equipment).
WARNING; Warning of risk of injury or danger to your health.
CAUTION; Safety information about possible damage to the device/accessories.
NOTE; Refers to important information.

Important safety instructions - read carefully and keep for later reference!

WARNING

• Non-observation of the following notes may result in personal injury or material damage (electric shock, skin burns, fire). The following safety and hazard information is not only intended to protect your health and the health of others, it should also protect the product. For this reason, pay attention to these safety notes and include these instructions when handing over the product to others.
• This foot warmer must not be used by persons who are not sensitive to heat or by other vulnerable persons who may not be able to react to overheating (e.g. diabetics, people with skin alterations due to illness or scarred tissue in the application area, after taking pain relief medication or alcohol).
• This foot warmer must not be used by very young children (0-3 years old) as they are unable to respond to overheating.
• This foot warmer can be used by children older than 3 and younger than 8 years of age provided they are supervised. For this, the control must always be set to the minimum temperature.
• This foot warmer may be used by children over the age of 8 and by people with reduced physical, sensory or mental skills or a lack of experience or knowledge, provided that they are supervised and have been instructed on how to use the foot warmer safely, and are fully aware of the consequent risks of use.
  Children must not play with the foot warmer.
• Cleaning and user maintenance must not be performed by children unless supervised.
• This foot warmer is not designed for use in hospitals.
• This foot warmer is only intended for domestic/private use, not for commercial use.
• This foot warmer must not be used to keep animals warm.
• Do not use this foot warmer with shoes.
• Do not insert pins.
• Do not use when folded or bunched up.
• Do not use if wet.

• This foot warmer must only be connected to the mains voltage that is specified on the label.

• The electrical and magnetic fields emitted by this foot warmer may interfere with the function of a pacemaker. However, they are still well below the limits: electrical field strength: max. 5000 V/m, magnetic field strength: max. 80 A/m, magnetic flux density: max. 0.1 millitesla. Please therefore consult your doctor and the manufacturer of your pacemaker before using this foot warmer.

• Do not pull, twist or make sharp bends in the cables.
• If the cable and control are not positioned properly, there may be a risk of becoming entangled in, being strangled by, tripping over, or stepping on the cable and control of the foot warmer. The user must ensure that excess lengths of cable, and cables in general, are safely routed.
• Please check this foot warmer frequently for signs of wear and tear or damage. If any such signs are evident, if the foot warmer has been used incorrectly or if it no longer heats up, it must be checked by the manufacturer before being switched on again.
• Under no circumstances should you open or repair the foot warmer (including the accessories) yourself because faultless functionality can no longer be guaranteed thereafter. Failure to observe this will invalidate the warranty.
• If the mains connection cable of this foot warmer is damaged, it must be disposed of. If it cannot be removed, the foot warmer must be disposed of.
• When this foot warmer is switched on:
• Do not place any sharp objects on it
• Do not place any heat sources, such as hot water bottles, heat pads or similar, on it
• The electronic components in the control warm up when the foot warmer is in use. For this reason, the control must never be covered or placed on the foot warmer when it is in use.
• It is essential to observe the information relating to the following chapters: Operation, Cleaning and maintenance, Storage.
• If you should have any questions about using our devices, please contact our Customer Services department.

2 appliance description

HZ30/HZ31

Electric foot warmer

Size: 26 × 26 × 32 cm

Switch with 3 illuminated settings

Automatic switch off after 90 minutes

Removable lining hand washable

100 Watt

1. Illuminated display for temperature settings
2. Mains plug
3. Sliding switch for ON/OFF and temperature settings
4. Mains cable
5. Control
6. Foot warmer

3 intended use

CAUTION

This foot warmer is intend only for heating human feet.

4 operation

4.1 Safety

CAUTION

• The foot warmer has been provided with the INVENTUM SAFETY SYSTEM (ISS). This sensor technology prevents overheating of the foot warmer on the entire surface through automatic deactivation in case of breakdown. If the SAFETY SYSTEM has switched off the foot warmer, the temperature levels in activated condition are no longer lighted.
  Do note that for reasons of safety the foot warmer can no longer be used after a breakdown and should be sent to the indicated service address.

4.2 Initial use

CAUTION

Make sure the foot warmer does not fold or crumple during use.

• Insert the plug in the socket.

4.3 Switching on

To switch on the foot warmer, set the slider for ON/OFF and temperature settings to setting 1, 2 or 3. The temperature setting is illuminated when switched on.

4.4 Setting the temperature

Setting 0: OFF

Setting 1: minimum heat

Setting 2: medium heat

Setting 3: maximum heat

NOTE

• The fastest way to heat up the foot warmer is to select the highest temperature setting of the control, first.

NOTE

• This foot warmer has a fast heating function, which allows the foot warmer to warm up faster in the first 10 minutes.

WARNING

If the foot warmer is used continuously (for several hours) it is recommended to use the lowest setting (1) of the control to avoid overheating of the feet of the user, which may lead to burns to the skin.

4.5 Automatic switch off

This foot warmer is equipped with an automatic switch-off function. This turns off the heat supply approx. 90 minutes after the initial use of the foot warmer. The temperature setting display then starts to flash. So that the foot warmer can be switched back on, the sliding switch for ON/OFF and temperature setting must first be set to setting O (OFF). After about 5 seconds it is possible to switch it on again.

4.6 Switching off

To switch off the foot warmer, set the slider for ON/OFF and temperature settings to setting 0 (OFF). The temperature settings are then no longer illuminated.

NOTE

If the foot warmer is not in use, switch the sliding switch for ON/OFF and temperature settings to setting 0 (OFF) and unplug the mains plug from the socket.

5 cleaning & maintenance

WARNING

Before cleaning, always remove the mains plug from the socket first. Otherwise there is a risk of electric shock.

CAUTION

The control must never get in contact to water or other liquids. Otherwise, the control may be damaged.

• To clean the control, use a dry, lint-free cloth. Do not use any chemical or abrasive cleaning agents.
• Small marks on the foot warmer can be removed with a damp cloth or sponge, or if necessary, with a little liquid detergent for delicate laundry.

CAUTION

Please note that the foot warmer may not be washed, chemically cleaned, wrung out, tumble dried, put through a mangle or ironed. Failure to do so may damage the foot warmer.

• The removable fleece lining can be washed by hand.

• Use a delicate laundry detergent and measure it out according to the manufacturer's instructions.

• Never switch on the foot warmer in order to dry it in this way! You will run the risk of an electric shock.

• Only start using the foot warmer again when the inner cover and foot warmer have fully dried. Otherwise you will run the risk of an electric shock.

6 storage

If you do not plan to use the foot warmer for a long period of time, we recommend that you store it in the original packaging.

CAUTION

• Please allow the footwarmer to cool down first. Otherwise, the footwarmer may be damaged.
• To avoid sharp folds in the footwarmer, do not place objects on top of it while it is being stored.

7 disposal

Legislation requires that all electrical and electronic equipment must be collected for reuse and recycling. Electrical and electronic equipment marked with the symbol indicating separate collection of such equipment must be returned to a municipal waste collection point.

8 problems & solutions

Problem Cause Remedy
The temperature settings are not illuminated while - the mains plug is connected to a working socket; - the sliding switch is set to 1, 2 or 3.	The safety system has switched the foot warmer off permanently.	Send the foot warmer to the service department.

general terms and conditions of service and warranty

We do not need to remind you of the importance of service. After all, we develop our products to a standard so that you can enjoy them for many years, without any concerns. If, nevertheless, there is a problem, we believe you are entitled to a solution straight away. Hence our products come with an exchange service, on top of the rights and claims you are entitled to by law. By exchanging a product or part, we save you time, effort and costs.

2-year full manufacturer's warranty

1. Customers enjoy a 2-year full manufacturer's warranty on all Inventum products. Within this period, a faulty product or part will always be exchanged for a new model, free of charge. In order to claim under the 2-year full manufacturer's warranty, you can either return the product to the shop you bought it from or contact the Inventum costumer service department via the form at www.inventum.eu/service-aanvraag.
2. The 2-year warranty period starts from the date the product is bought.
3. In order to claim under the warranty, you must produce a copy of the original receipt.
4. The warranty applies only to normal domestic use of Inventum products within the Netherlands.

Breakdowns or faults outside the warranty period

1. Breakdowns or faults in small or large domestic appliances outside the warranty period, can be reported to the costumer services department via the form at www.inventum.eu/service-aanvraag or by calling the costumer services department.
2. The costumer services department may ask you to send the product for inspection or repair. The costs of dispatch will be at your expense.
3. The inspection to establish whether repair is possible involves a charge. You need to grant your permission for this, in advance.
4. In the event of a large domestic appliance, Inventum, at your request, can send out a service engineer. In that case, you will be charged the call-out costs, as well as parts and labour.
5. In the event of an instruction to repair, the repair costs must be paid in advance. In the event of a repair by a service engineer, the costs of the repair must be settled with the engineer onsite, preferably by means of PIN payment.

Warranty exclusions

1. The following is excluded from the aforesaid warranties:

normal wear and tear;
- improper use or misuse;
insufficient maintenance;
- failure to comply with the operating and maintenance instructions;
- unprofessional installation or repairs by third parties or the customer himself;
- non-original parts used by the customer;
- use for commercial or business purposes;
- removal of the serial number and/or rating label.

1. In addition, the warranty does not apply to normal consumer goods, such as:

2. dough hooks, baking tins, (carbon) filters, etc.;

3. batteries, bulbs, carbon filters, fat filters etc.;
   external connection cables;

4. glass accessories and glass parts such as oven doors;
   and similar items.

5. Transport damage not caused by Inventum is also excluded. Therefore, inspect your new device before starting to use it. If you detect any damage, you must report this to the store where you purchased the product within 5 working days, or to the Inventum customer service department via the form at www.inventum.eu/service-aanvraag. If transport damage is not reported within this period, Inventum does not accept any liability in this respect.

6. The following are excluded from warranty and/or replacement: faults, loss of and damage to the device as a result of an event that is normally insured under the home contents insurance.

Important to know

1. The replacement or repair of a faulty product, or a part thereof, does not lead to an extension of the original warranty period.
2. If a complaint is unfounded, all costs arising from it will be at the customer's expense.
3. Following expiry of the warranty period, all costs of repair or replacement, including administration costs, dispatch and call-out charges, will be charged to the customer.
4. Inventum cannot be held liable for damage caused by external events, unless this liability arises from mandatory statutory provisions.
5. These warranty and service provisions are governed by Dutch law. Disputes will be settled exclusively by the competent Dutch court.

@ instagram.com/inventum1908
f facebook.com/jinventum1908
品 youtube.com/inventum1908