PerfectJuice SF2000 - Juicer AEG - Free user manual and instructions

USER MANUAL PerfectJuice SF2000 AEG

17Safety advice Read the following instruction carefully before using the appliance for the rst time.

• Thisapplianceisnotintendedforuse bypersons(includingchildren)with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

• Childrenshouldbesupervisedto ensure that they do not play with the appliance.

• Theappliancemayonlybeconnected to a power supply whose voltage and frequency comply with the specications on the rating plate!

• Neveruseorpickuptheapplianceif – the supply cord is damaged, –thehousingisdamaged.”

• Theappliancemustonlybe connected to an earthed socket. If necessary an extension cable suitable for 10 A can be used.

• Iftheapplianceorthesupplycord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualied person, in order to avoid hazard.

• Alwaysplacetheapplianceonaat, level surface.

• Theappliancemustbeswitchedo and the mains plug withdrawn before cleaning and maintenance.

• Applianceisforindooruseonly.

• Thisapplianceisintendedfor domestic use only. The manufacturer cannot accept any liability for possible damage caused by improper or incorrect use.

• Nevertouchthebladesorinserts with your hand or any tools while the appliance is plugged in.

• Donotimmersetheappliancein water or any other liquid.

• Whenprocessingheavyload,donot use the appliance continuously for more than 40 seconds. Allow to cool down before restarting.

• Donotletcordhangoveredgeof table or counter, do not let cord contact hot surface, including the stove.

• Neveruseaccessoriesorparts made by other manufactures not recommended or sold; may cause a risk of injury to persons.

• Onlyusetheappliancewhenhandle is locked, never reach into the feeding tube with your ngers of an object while the appliance is running.

• Donotremovethepulpcontainer when the appliance is in operation.

• Makesureallpartsarecorrectly mounted before you switch on the appliance.

• Makesurethemotorandblade have completely stopped before disassembling and cleaning.

• Donotusetheapplianceifthe rotating sieve is damaged.

• Pleasedisconnectthesupplypower and put the switch to the o position when you open the lid.

• Switchotheapplianceand disconnect from supply before changing accessories or approaching parts that move in use.

• Donotlettheappliancerunformore than 8 minutes without interruption. If you have not nished extracting juice, switch o the appliance and let it cool down to room temperature before you continue.

• Juice300ggingerfor10seconds.You have to exert a higher pressing force (ofupto6kg)onthepusher.Donot let the appliance run for more than 70 seconds without interruption. If you have not nished extracting juice, switch o the appliance and let it cool down to room temperature before you continue.

3. Put the two lters in the juice

collector, the large lter should t securely onto the clutch. The small lter ts inside the large lter. Make suretheylockintoplace(“click”).

1. The appliance will only function

if all parts have been properly assembled and the lid has been properly locked in place with the handle.

2. Place the juice collector into the

4. Place the pulp container into the

appliance by tilting it forwards slightly. Insert the top rst and then push the bottom end.

6. Slide the pusher into the feeding

tube by aligning the groove in the pusher with the small protrusion on the inside of the feeding tube.

5. Hold the lid over the lter and

lower it into position, snap the handle onto the lid to lock it into place(“click”).Makesurethehandle is locked into position on both side of the lid.

19Operating instructions Getting started

8. To separate the foam from the juice

when pouring the juice into a glass, insert the foam separator by sliding it into the juice jug.

7. Place the juice jug under the spout.

1. Plug cord plug into the power

socket, switch the appliance on by turning the control knob to setting ”1”lowerspeedor“2”(normalspeed). Speed“1”isespeciallysuitablefor softfruitsandvegetables.Speed“2” is suitable for all kinds of fruits and vegetables.

3. Gently press them down towards

the rotating lter by means of the pusher. Notice: do not exert too much pressure on the pusher, as this could aect the quality of the end result and it could even cause the lter to come to a halt.

2. Put the pre-cut pieces in the

object into the feeding tube.

5. After you have processed all

ingredients and the juice ow has stopped, turn the knob to the position ‘0’ and wait till the lter has stopped rotating. Then remove the plug from wall socket.

1. Switch the appliance o, remove the

plug from the wall socket and wait until the lter has stopped rotating.

2. Remove the detachable parts from

the motor unit. Remove the pusher. Open the handle.

4. Remove the juice collector together

5. Clean these parts with the cleaning

brush in warm water with some washing-up liquid and rinse them under the tap.

6. Clean the motor base with a damp

cloth, never immerse the motor base in water nor rinse it under the tap. Avoid touching the sharp blades. Store the appliance in dry environment.

CleaningDisposal Packaging materials The packaging materials are environ- mentally friendly and can be recycled. The plastic components are identied by markings, e.g. >PE<, >PS<, etc. Please dispose of the packaging materials in the appropriate container at the community waste disposal facilities. Old appliance The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city ofce, your household waste disposal service or the shop where you purchased the product. Disposal Problem Possible cause Solution The Juice Extractor does not switch ON. Components are not xed properly. Check if all components are properly locked into position.The speed selector is not on the right position. Choose appropiate speed.The plug is not properly connected to the power outlet.Check the connection of the plug to the outlet or try another outlet.The appliance can still not function well after our recommended inspections.Functional problem. Contact authorized service.The product produces abnormal noice, smell, smoke and increased temperature.Functional problem. Disconnect the power supply, stop using and contact authorized service.