Blender To Go BL1070721 - Blender WAVES - Free user manual and instructions

Frequently Asked Questions - Blender To Go BL1070721 WAVES

USER MANUAL Blender To Go BL1070721 WAVES

SAFETY INSTRUCTIONS General Information

1. Read these instructions carefully and keep them in a safe place.
2. Only use the appliance as described in this manual.
3. In case of damage caused by failure of not living up to this manual the warranty will decay immediately. The manufacturer/importer accepts no liability for damages caused by failure to not living up the manual, a negligent use or use not in accordance with the requirements of this manual.
4. This appliance is not intended for use by persons (including children) when reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
5. Children should be supervised to ensure that they do not play with the appliance.
6. Cleaning and user maintenance shall not be made by children unless they are older than 8 years and supervised.
7. Keep the appliance and its cord out of reach of children less than 8 years.
8. Always remove the power cord and let it cool: Before moving the unit; Before the unit is stored;

Before you go mounting or dismantle parts; Before cleaning or maintenance work; After use.

1. Only have the appliance repaired by a qualified service centre.

2. Qualified service center: after-sales service of the manufacturer/importer, which is qualified to carry out repair to avoid any kind of danger. In case of problems please return the appliance to this service.

Electricity and heat

1. Before use, check that the mains power supply voltage is the same and the voltage is the same as the voltage indicated on the appliance.
2. Always plug the appliance into an earthed plug socket.
3. Regularly check the power cord for damage.
4. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
5. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or is dropped or damaged in any manner. Return appliance to manufacturer or the nearest authorized service agent for examination, repair or electrical or mechanical adjustment.
6. To remove the plug from the plug socket, pull the plug. Do not pull the power cord.

7. Make sure the power cord does not come into contact with hot surfaces.

8. Always remove the plug from the plug socket before you move the appliance.

9. The machine should not be operated by means of an external timer-switch or by means of a separate system with remote control.
10. To avoid a circuit overload, do not operate another high voltage appliance on the same circuit.
11. To protect against electric shock do not immerse cord, plugs, or housing in water or other liquid.
12. Do not touch the appliance if it falls into water. Remove the plug from its socket, turn off the appliance and do not use it again.
13. Do not use the appliance close to hot objects such as a stove or oven.

Using the appliance

1. This appliance is intended to be used in household and similar applications such as: Staff kitchen areas in shop, offices and other working environment; Farmhouses; By clients in hotels, motels and other residential type environments; Bed and breakfast type environments.
2. The use of accessory attachment not recommended by the appliance manufacturer may cause injuries.
3. Only use the appliance indoors, in dry areas away from water.

4. Do not immerse the appliance or the mains plug in water or other liquids. There is a danger to life due to electric shock!

5. To reduce the risk of electric shock, do not use the appliance outdoors or on wet surfaces.

6. Children are unable to recognize the hazards associated with incorrect handling of electrical appliances. Therefore, children should never use electric household appliances unsupervised.
7. Close supervision is necessary for any appliance being used by or near children.
8. Never leave the appliance unattended during use.
9. Care should be taken when handling the sharp cutting blades, emptying the bowl and during cleaning.
10. Shut down the product before changing accessories or approaching the parts which are moving during operation.
11. Do not allow children to use the blender without supervision.
12. This appliance is intended for household use only.

German

1. Spill-Proof Drinking Lid
2. Lid Storage Position
3. Sport Bottle
4. Blade Assembly
   5.Blender Base

HOW TO USE

The blender cannot crush ice.

Clean blender according to the instructions in the "CLEANING" section.

1. Place the sport bottle on a flat surface with the open end facing up. Fill the sport bottle with your favorite ingredients. Be sure not to fill ingredients over the maximum marking.
2. Fasten the blade assembly on the open end of the sport bottle. Turn the sport bottle upside down to lock it in the base for hands-free operation. Be careful for the sharp blades.
3. To lock the bottle well, make sure the bulge point on the side of blade assembly slide to the right close side of the fillister of the blender base. Plug in the appliance.
4. It takes about 1-2 minutes to finish the blending. Unplug the appliance after the blending has finished.
5. Slide and turn the sport bottle over, place it on a flat surface. Replace the blade assembly with the drinking lid. In this way you have got a bottle of healthy drink to enjoy freely.
6. This product is equipped with 1 safety lock on the slot of the housing. It only works when the jug has been placed correctly.

NOTE:

1. Put liquids in the cup first, unless a recipe says otherwise.

2. Cut all firm fruits and vegetables into pieces no larger than 3/4 inch (1.8 cm) to 1 inch (2.5 cm).

3. Don't overload sport bottle. If the motor stalls, unplug the unit immediately and let it cool for at least 15 minutes. Then, remove a portion of the food and continue.
4. This blender could not be used to mash potatoes, whip egg whites or cream, mix stiff dough or grind raw meat.
5. For optimal performance, place desired ingredients in the Sport Bottle according to the following order: liquids, fresh ingredients, frozen fruit, yogurt and ice cream.

CLEANING

1. First Remove the mains plug from the wall socket, do not immerse the motor housing in water, you can clean the motor housing with a humid cloth. Do not use abrasive cleaning materials.
2. Disassemble the other parts after each use and wash them in soapy water. Then rinse with clean water and dry thoroughly. Do not wash these parts in a dishwasher.

CAUTION

• Never use boiling liquids or make hot drink (>60^)
• Never run the blender empty or with solids only.

The blender works 1 minute and stops 1 minute for 5 cycles, then let the motor cool down for at least 15 minutes.

TECHNICAL DATA

Supply voltage: 220 - 240V 50Hz

Power consumption: 250W

GUARANTEE AND CUSTOMER SERVICE

Before delivery our devices are subjected to rigorous quality control. If, despite all care, damage has occurred during production or transportation, please return the device to your dealer. In addition to statutory legal rights, the purchaser has an option to claim under the terms of the following guarantee:

For the purchased device we provide 2 years guarantee, commencing from the day of sale. If you have a defective product, you can directly go back to the point of purchase.

Defects which arise due to improper handling of the device and malfunctions due to interventions and repairs by third parties or the fitting of non-original parts are not covered by this guarantee. Always keep your receipt, without the receipt you can't claim any form of warranty. Damage caused by not following the instruction manual, will lead to a void of warranty, if this results in consequential damages then we will not be liable. Neither can we hold responsible for material damage or personal injury caused by improper use if the instruction manual is not properly executed. Damage to accessories does not mean free replacement of the whole appliance. In such case please contact our service department. Broken glass or breakage of plastic parts is always subject to a charge. Defects to consumables or parts subjected to wearing, as well as cleaning, maintenance or the replacement of said parts are not covered by the warranty and are to be paid.

ENVIRONMENT FRIENDLY DISPOSAL

You can help protect the environment!

Please remember to respect the local regulations: hand in the non-working electrical equipments to an appropriate waste disposal centre.

Emerio Holland B.V.

Kenaupark 9

2011 MP Haarlem

Nederland

Customer service:

T: [phone]

E: [e-mail]

MERKMALE