BS 1266 - Vacuum Cleaner CLATRONIC - Free user manual and instructions

Product type	Canister vacuum cleaner
Brand	Clatronic
Model	BS 1266
Power supply	220-240 V ~ 50 Hz
Rated power	1200 W
Maximum power	1700 W
Protection class	II
Filter type	Washable motor protection filter and exhaust filter
Bag capacity	Not specified (standard dust bag)
Included accessories	Floor nozzle, 2-in-1 crevice tool (crevice tool and brush), telescopic tube
Suction power adjustment	Power selector (low, medium, high)
Bag full indicator	Yes, red light on the housing
Cord rewind	Yes, with rewind button
Parking position	Yes, at the rear and underneath
Cord length	Approximately 5 m (estimated)
Warranty	24 months
Maintenance	Clean filters after about 10 bag changes; wash in hot water without detergent
Safety	Do not vacuum liquids, hot ashes or sharp objects; do not use without filter

Frequently Asked Questions - BS 1266 CLATRONIC

How to change the dust bag of the Clatronic BS 1266 vacuum cleaner?

Unplug the appliance. Open the bag compartment using the handle (7). Remove the full bag from the top. Insert a new bag, making sure it properly engages in its guide. Close the cover until it clicks.

How to clean the vacuum cleaner filters?

Unplug the appliance. For the motor protection filter, lift it and clean it after about 10 bag changes. You can wash it in hot water without detergent. For the exhaust filter, open the filter cover (8) and remove the filter. Wash it in the same way. Put the filters back completely dry before using the appliance again.

How to adjust the suction power?

Use the power selector (1) on the appliance. Low setting for curtains and delicate fabrics, medium for long-pile carpets, high for robust carpets and rugs.

What is the purpose of the 2-in-1 crevice tool?

The 2-in-1 crevice tool combines a crevice tool and a brush. To use as a brush, pull the brush part until it clicks. It is ideal for vacuuming sofas, curtains, corners and crevices.

What to do if the vacuum cleaner no longer sucks?

First check the power setting: if too low, increase it. Check if the dust bag is full: replace if necessary. Check if the filters are dirty: clean them. Finally, inspect the hose and nozzle for any blockage.

How to store the vacuum cleaner?

Unplug the appliance and let it cool down. Fully rewind the cord. For horizontal storage, insert the brush hook into the parking position on the back of the appliance. For vertical storage, use the parking position underneath the appliance.

What is the maximum power of the vacuum cleaner?

The maximum power is 1700 W, with a rated power of 1200 W. The appliance operates on a 220-240 V ~ 50 Hz power supply.

How to use the air regulator?

The air regulator (12) is on the hose handle. Open it to reduce suction or to release a stuck object in the nozzle.

What are the important safety instructions?

Never vacuum liquids, hot ashes or sharp objects. Do not use the appliance in a damp location. Never use it without a filter. Keep nozzles away from hair, clothing and body parts. Always unplug before cleaning.

How to maintain the power cord?

Only unwind the cord up to the yellow mark, never to the red mark to avoid damaging the rewinder. To store, press the rewind button (4) while guiding the cord. Do not repair a defective cord yourself; contact a professional.

USER MANUAL BS 1266 CLATRONIC

Black vacuum cleaner with coiled hose and control panel, no visible text or symbols on device body

CE

BODENSTAUBSAUGER

Stofzuiger • Aspirateur-traîneau • Aspiradora • Aspirador • Aspirapolvere a carrello • Gulvstøvsuger Floor-type vacuum cleaner • Odkurzacz • Porszívó • Vysavač koberců • Пылесої

BS 1266

DEUTSCH

NORSK

Inhalt

Overview of the Components ...... Page 3

7 Instruction Manual...... Page 25

Technical Data Page 27

9 Guarantee Page

FRANÇAIS

JEZYK POLSKI

Sommaire

Line drawing of a hand holding a syringe or tube, no text or symbols present

D-47906 Kempen/Germany

Line drawing of a person holding a syringe, no text or symbols present

Line drawing of a hand holding a syringe, no text or symbols present

Line drawing of a hand holding a syringe, no text or symbols present

Line drawing of a hand holding a syringe, no text or symbols present

Limpe as componentes.

Causa possível:

Line drawing of a hand holding a syringe, no text or symbols present

Line drawing of a hand holding a syringe, no text or symbols present

General Safety Instructions

Read the operating instructions carefully before putting the appliance into operation and keep the instructions including the warranty, the receipt and, if possible, the box with the internal packing. If you give this device to other people, please also pass on the operating instructions.

• The appliance is designed exclusively for private use and for the envisaged purpose. This appliance is not fit for commercial use. Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. If the appliance is humid or wet, unplug it immediately.
• When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories.
• Do not operate the machine without supervision. If you should leave the workplace, always switch the machine off or remove the plug from the socket (pull the plug itself, not the lead).
• Check the appliance and the cable for damage on a regular basis. Do not use the appliance if it is damaged.
• Do not try to repair the appliance on your own. Always contact an authorized technician. To avoid the exposure to danger, always have a faulty cable be replaced only by the manufacturer, by our customer service or by a qualified person and with a cable of the same type.
• Use only original spare parts.
• Pay careful attention to the following "Special Safety Instructions".

Children and Frail Individuals

- In order to ensure your children's safety, please keep all packaging (plastic bags, boxes, polystyrene etc.) out of their reach.

Caution! Do not allow small children to play with the foil as there is a danger of suffocation!

- In order to protect children or frail individuals from the hazards of electrical equipment, please ensure that this device is only used under supervision. This device is not a toy. Do not allow small children to play with it.

Special Safety Instructions

• Do not suck up liquids!
• Do not suck up hot ashes or pointed or sharp objects!
• Do not use the appliance in humid rooms!
• Never use without the filter. Check that the filter is inserted correctly!
• Hair, clothing and body parts away from the vacuum nozzle during use!
• Keep the vacuum cleaner away from sources of heat like radiators, ovens, etc.!

Overview of the Components

1 Vacuum power regulator

2	On/off	switch
3	Carrying	handle
4	Cable-winding	key

5 Dust bag compartment
6 Dust bag fi lling display
7 Handle for opening the dust bag compartment
8 Filter cover - Outlet fi Iter

9	Hose	connection
10	Vacuum	hose
11	Suction tube
12	Air Slide
13	Floor nozzle
14	„2-in-1“ nozzle

(groove and brush nozzle)

15 Parking assistance

Not shown

Hook on the suction tube

Start-up

• Insert the connection head of the suction hose into the hose connector until it locks in place. To do so, please press the buttons simultaneously. In order to release the hose again, please press the buttons once more on the connection head.
• Keep the buttons pressed down and then pull out the hose.
• Insert the vacuum tube into the handle if required.

Telescope Vacuum Pipe

Line drawing of a hand holding a syringe, no text or symbols present

• The height-adjustable vacuum pipe enables individual alignment to your height.
• Unlock the coupling by pressing the key in the direction of the arrow.
• Slide the vacuum pipe to the desired length.
  • To lock the device, release the key until you hear it lock in place.

Using the Appliance

1. Unwind the length of cable you require.
2. Insert the mains plug into a correctly installed 230 V, 50 Hz power socket. Turn the vacuum cleaner on by pressing the on/off switch (2) down with your foot.
3. Set the vacuum power with the vacuum power regulator (1).
4. Vacuum at a steady speed. There is no need to exert pressure.

Attention: pay attention to the range that can be covered with the cable length.

Vacuum power regulator (1)

Low vacuum power: For curtains and delicate fabrics

Medium vacuum power: For long-pile velour carpets and textile fl ooring

High vacuum power: For sturdy rugs and floors

Cable winding device

Pull out the cable up to the maximum length indicated with the yellow mark. Never pull the cable out up to the red mark as the cable winding can be damaged. Said damages are not covered by the warranty.

Winding

Press the cable (4) winding button and guide the cable. Hold the cable to avoid wrapping.

Nozzle Attachment

Crevice and jointed nozzle:	For vacuuming upholstery, curtains and in corners and crevices etc.„2-in-1“ nozzle: When this is folded together it can be used as a groove nozzle. If you would like to use the brush nozzle, pull the brush section in the direction of the arrow until it locks in place.
Floor nozzle: To clean carpets or smooth surfaces.
Smooth floors:	Press down the lever with the brush symbol with your foot. The brush is now visible.
Carpets:	Press the lever In the opposite direction. The brushes are now retracted.
Releasing the nozzles:	Pull these off while turning slightly.

Air Slide (12)

Open the air slide on the hose handle in order to regulate the airflow or to clear any particles sticking to the nozzle.

Dust bag replacement display (6)

Hold the hose up into air. If the display is red the bag is full. Please replace it.

Changing the dust bag

• Pull the plug out of the socket.
• Open the lid of the dust bag compartment by the handle (7) (the cover must click into place).
• Remove the bag by carefully pulling the clamp towards the front so that the bag becomes more accessible. Then remove the dust bag by pulling it upwards.
• Insert a new bag. Please ensure that the bag is located correctly in the guide mechanism. Then reinsert the retainer. Close the cover so that it snaps into place.

Filter

Motor protection fi Iter (inlet fi Iter)

The inlet filter is located in the dust bag compartment. The filter is located vertically in the rear section of the dust housing. Remove the filter by pulling upwards. Clean the engine protection filter after 10 dust bag changes. If necessary, the filter can also be washed in warm water without any additives. Place it back into place only once it is completely dry!

Outlet fi Iter

The appliance is also equipped with an outlet fi liter. This fi liter is to be found under the fi liter cover (8).

• Press the lever on the underside of the ventilation grille upwards in order to open the ventilation grille.
• Then pull the grille out towards the front.
• Remove the filter and clean as described above.
• Please re-insert the filter correctly and close the ventilation grille (until it clicks in place).

Cleaning and storage

Cleaning

• Pull the plug out of the socket before cleaning!
• Clean the casing with a dry cloth.

Storage

• Let the iron cool down completely.
  • Wind the cable completely.
• If you position the device horizontally: Please insert the hook of the floor nozzle into the parking assistant on the rear of the device.
• If you place the vacuum cleaner in a vertical position: Please hang the hook of the floor nozzle in the parking aid on the underside of the vacuum.

Troubleshooting

• The Device Does Not Work.

Remedy: Check the connection to the mains. Check the position of the switch.

• The device does not suck up anything.

Possible Cause: The suction power is set too low. Remedy: Check the position of the control switch.

Possible Cause: The dust bag is full.

Remedy:

Renew the dust bag.

or

Possible Cause:

The filters are dirty.

Remedy:

Clean the components.

Possible Cause:

There is a foreign body in the suction tube or the nozzle.

Remedy:

Check the accessories for foreign bodies.

Noise development

The sound pressure level in the ear of an operator (LpA) was measured according to DIN EN ISO 3744.

Sound pressure level detected: 80.0 dB(A) (no limit)

Technical Data

Model: BS 1266

Power supply: 220-240 V, 50 Hz

Power consumption:

Pnom 1200 W

P max. 1700 W

Protection class:....II

This device has been tested according to all relevant current CE guidelines, such as electromagnetic compatibility and low voltage directives, and has been constructed in accordance with the latest safety regulations.

Subject to technical changes without prior notice!

Guarantee

The device supplied by our Company is covered by a 24 month guarantee starting on the date of purchase (receipt).

During the life of the guarantee any fault of the device or its accessories ascribable to material or manufacturing defects will be eliminated free of charge by repairing or, at our discretion, by replacing it. The guarantee services do not entail an extension of the life of the guarantee nor do they give rise to any right to a new guarantee!

Proof of the guarantee is provided by the proof of purchase. Without proof of purchase no free replacement or repair will be carried out.

If you wish to make a claim under the guarantee please return the entire machine in the original packaging to your dealer together with the receipt.

Defects to consumables or parts subject to wearing as well as cleaning, maintenance or the replacement of said parts are not covered by the guarantee and hence are to be paid!

The guarantee lapses in case of unauthorized tampering.

After the expiry of the guarantee

After the expiry of the guarantee repairs can be carried by the competent dealer or repair service against the payment of the ensuing costs.

Meaning of the "Dustbin" Symbol

Protect our environment: do not dispose of electrical equipment in the domestic waste.

Please return any electrical equipment that you will no longer use to the collection points provided for their disposal.

This helps avoid the potential effects of incorrect disposal on the environment and human health.

This will contribute to the recycling and other forms of reutilisation of electrical and electronic equipment.

Information concerning where the equipment can be disposed of can be obtained from your local authority.

Line drawing of a hand holding a syringe, no text or symbols present

Line drawing of a hand holding a syringe, no text or symbols present

Line drawing of a person holding a syringe, no text or symbols present

Line drawing of a hand holding a syringe, no text or symbols present