CB 839 - Lawn mower BOMANN - Free user manual and instructions

USER MANUAL CB 839 BOMANN

BOMANN brand hairpin with black base and white head (no visible text or symbols on body)

Labeled diagram of a hairbrush with numbered parts including a brush, screwdriver, and accessories

D

4, 6, 8, 10, 12, 14, 16

Zubehör

D-47906 Kempen/Germany

General Safety Instructions

Read the operating instructions carefully before putting the appliance into operation and keep the instructions including the warranty, the receipt and, if possible, the box with the internal packing. If you give this device to other people, please also pass on the operating instructions.

• The appliance is designed exclusively for private use and for the envisaged purpose. This appliance is not fi t for commercial use. Do not use it outdoors. Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. If the appliance is humid or wet, unplug it immediately.
• When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull the plug itself, not the lead) if the appliance is not being used and remove the attached accessories.
• Do not operate the machine without supervision. If you leave the room you should always turn the device off. Remove the plug from the socket.
• Check the appliance and the cable for damage on a regular basis. Do not use the appliance if it is damaged.
• Do not try to repair the appliance on your own. Always contact an authorized technician. To avoid the exposure to danger, always have a faulty cable be replaced only by the manufacturer, by our customer service or by a qualified person and with a cable of the same type.
• Use only original spare parts.
• Pay careful attention to the following "Special Safety Instructions".

GB

Children and Frail Individuals

- In order to ensure your children's safety, please keep all packaging (plastic bags, boxes, polystyrene etc.) out of their reach.

WARNING!

Do not allow small children to play with the foil as there is a danger of suffocation!

- In order to protect children or frail individuals from the hazards of electrical equipment, please ensure that this device is only used under supervision. This device is not a toy. Do not allow small children to play with it.

Symbols in these Instructions for Use

Important information for your safety is specially marked. It is essential to comply with these instructions in order to avoid accidents and prevent damage to the machine:

WARNING:

This warns you of dangers to your health and indicates possible injury risks.

△ CAUTION: This refers to possible hazards to the machine or other objects.

i NOTE: This highlights tips and information.

Special safety instructions for this device

• Use this machine to cut dry hair only.
• Use this machine to cut only hair and beards.
• Do not charge the machine in a humid atmosphere.
• When charging keep the machine away from direct sunlight or sources of heat.
• Do not press the cutting head too much against the skin. Danger of injury!
• Never use any adapter other than that supplied with the machine.

WARNING OF ELECTRIC SHOCK!

Do not use this device near baths, wash basins or other vessels containing water.

Overview of the Components

1 Cutting head 7 Charging station/mounting
2 ON selector 8 Locking switch (Lock/Unlock)
3 Cutting length comb
4, 6, 8, 10, 12, 14, 16
4 Charging LED 1 Comb
5 Connection socket 2 Cleaning brush
6 Adapter (charger) 3 Special oil

Accessories

GB

Charging up the Device

• Move the function switch to the OFF position.
• Connect the connecting cable to the connection socket of the haircutting machine.
• Insert the plug of the mains adapter into a 230V/50Hz socket.
• The charging control lamp lights up during the charging process.

i NOTE: The lamp does not provide any indication of the charging status of the battery.

• Charge the battery for 8 hours before initial use.
• Subsequent charging times are also 8 hours.

i USEFUL TIPS ON BATTERY LIFE

Battery life can be lengthened by paying attention to the following instructions:

• Wait until the battery is almost completely flat at before charging it.
• Never leave the machine connected to the charger for more than 8 hours.
• Charge the machine only with room temperatures between 0 and +40^ .

Use

Short Operating Time

If you have used the device continuously for 5 minutes, please let it cool down fur approximately 5 minutes.

Beard trimming and cutting

Shift the selector (2) to the ON position. Start with the longest cutting level and shorten the whole beard or the beard on the chin or cheeks gradually to the desired length.

CAUTION:

Lock the selected cutting length (cutting length comb) in position with the locking switch located on the back of the housing (position – „lock“).

Hair cutting/thinning

Shift the selector (2) to the ON position. Start with the longest cutting level and shorten the hair gradually to the desired length.

GB

CAUTION:

Lock the selected cutting length (cutting length comb) in position with the locking switch located on the back of the housing (position – „lock“).

Contour cutting and neck shaving

• Remove the cutting length comb (3) and shift the selector (2) to the ON position.
• The shearing head enables the precise trimming of the beard contours even areas, which are diffi cult to reach, and the clean shaving of the hairline in the neck area.

Maintenance and care

The regular cleaning and maintenance of the machine will guarantee optimal results and long machine life.

• Use only a slightly humid and soft cloth to clean the machine.
  • After using each time remove all the hair left on the machine with cleaning brush.
• Remove the cutting length comb and the cutting head to either blow away the hair particles or brush them away with the cleaning brush.
• After using the machine each time apply 1-2 drops of acid-free oil (sewing machine oil) on the cutting head.

CAUTION: It is not allowed to recharge the battery continuously more than 8 hours.

Technical Data

Model: CB 839

Power supply: 230 V, 50 Hz

Mains adapter: 2,2 V DC, 800 mA, 4 W

Protection class:....II

Net weight: 0,35 kg

This device has been tested according to all relevant current CE guidelines, such as electromagnetic compatibility and low voltage directives, and has been constructed in accordance with the latest safety regulations.

Subject to technical changes without prior notice!

GB

Battery Disposal

The device contains rechargeable batteries.

Used standard and rechargeable batteries should not be disposed of in the domestic waste.

- The batteries must be removed before the product is disposed of.

WARNING:

Disconnect the device from the mains before you remove the battery!

- Please use a small Phillips screwdriver to release the screw from the battery compartment.

• Use a pair of scissors to cut through the wires on the positive and negative poles of the battery.
• Now remove the battery.
• These can be returned to a collection point for old batteries or special refuse. Contact your local authority for further information.

Meaning of the "Dustbin" Symbol

Protect our environment: do not dispose of electrical equipment in the domestic waste.

Please return any electrical equipment that you will no longer use to the collection points provided for their disposal.

This helps avoid the potential effects of incorrect disposal on the environment and human health.

This will contribute to the recycling and other forms of reutilisation of electrical and electronic equipment.

Information concerning where the equipment can be disposed of can be obtained from your local authority.

GB