D3700 - Hair dryer REMINGTON - Free user manual and instructions

USER MANUAL D3700 REMINGTON

B5(0B,)8B'B/LQGG ENGLISH

Thank you for buying your new Remington product.Before use, please read the instructions carefully, and keep them in a safe place for future reference.. PRODUCT FEATURES

2200 Watt dual-turbo hairdryer Ionic conditioning reduces static and frizz for healthy looking shiny hair Dual turbine fans for faster drying time and low noise 3 heat and 2 speed switch settings Additional settings on a separate rocker switch: (i)Turbo setting for ultimate speed drying (ii)Cool setting for a blast of cool air to set styles (iii)Switch to ‘0’ for conventional use with the 3 heat and 2 speed settings Concentrator m cable with hang up loop

Squeeze out excess moisture with a towel and comb through. To use the 3 heat & 2 Speed settings please ensure the Turbo/Cool switch is set in the ‘0’ position. B5(0B,)8B'B/LQGG 3 Years warrantyENGLISH

To use the cool function press the Turbo/Cool switch to the right, the heat switch should be set to minimum with your preferred speed. Return to the ‘0’ position once you have finished styling. To use the turbo function press the Turbo/Cool switch to the left and return to the ‘0’ position once you have finished styling. For maximum turbo results, set the speed switch to maximum with your preferred heat setting.

CLEANING AND MAINTENANCE

To maintain peak product performance and to prolong motor life, it is important to regularly remove dust and dirt from the rear grille and clean with a soft brush. SAFETY CAUTIONS

WARNING – FOR ADDITIONAL PROTECTION THE INSTALLATION

OF A RESIDUAL CURRENT DEVICE (RCD) WITH A RATED RESIDUAL OPERATING CURRENT NOT EXCEEDING 30mA IS ADVISABLE. ASK AN ELECTRICIAN FOR ADVICE. WARNING – THIS APPLIANCE MUST NOT BE TAKEN INTO A BATHROOM. IT SHOULD NOT BE USED NEAR BATHTUBS, SHOWERS, BASINS OR OTHER VESSELS CONTAINING WATER OR OTHER LIQUIDS. This product is not suitable for use in bath or shower. THE HAIRDRYER SHOULD BE UNPLUGGED FROM MAINS SUPPLY WHEN NOT IN USE. Do not leave the dryer unattended when switched on. Allow the dryer to cool down before storage. Do not immerse in water or other liquids. Do not wrap the cord around the unit. Check cord regularly for any sign of damage. Damaged cords can be dangerous. In use, take care that the inlet and outlet grilles are not blocked in any way as this will cause the unit to automatically stop. Should this occur, switch off and allow the unit to cool down. Ensure the inlet grille is free from obstructions such as household fluff, loose hair etc.

B5(0B,)8B'B/LQGG ENGLISH

Do not place hairdryer on soft material e.g. carpet, bedding, towels, rugs etc. Do not leave the dryer switched on when you set it down. Always ensure the voltage to be used corresponds to the voltage stated on the unit. Do not direct the airflow towards the eyes or other sensitive areas. Do not use any attachments with this hairdryer, other than those supplied by Remington

Avoid allowing any part of the hairdryer to contact the face, neck or scalp. This appliance is not intended for commercial or salon use. If the supply cord of this unit becomes damaged, discontinue use immediately and return the appliance to your nearest authorised Remington service dealer for repair or replacement in order to avoid a hazard. Special tools are required for any examination, adjustment or repair. Unqualified repair work could lead to hazardous conditions for the user. We do not accept responsibility for damage to the product, persons or other item(s), caused by misuse, abuse or non-compliance with these instructions. Keep this product out of reach of children. The use of this appliance by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge can give cause to hazards. Persons responsible for their safety should give explicit instructions or supervise the use of the appliance.

WIRING INSTRUCTIONS UK PLUGS ONLY

This product is fitted with a BS1363 plug fused at 13A. If the plug is unsuitable, it should be disconnected and an appropriate plug fitted as detailed below. If it is necessary to replace the plug fuse, use only fuses that are approved to BS1362, rated at 13A. If in doubt consult a qualified electrician.The wires in the mains lead are coloured in accordance with following code: BLUE - NEUTRAL BROWN - LIVEAs the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:- The wire which is coloured BLUE must be connected to the terminal which is marked ‘N’ or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal which is marked ‘L’ or coloured RED. Never connect either of the wires to the big EARTH terminal marked ‘E’ or coloured GREEN or GREEN AND YELLOW.B5(0B,)8B'B/LQGG ENGLISH

This product has been checked and is free of defects. We warrant this product against any defects that are due to faulty material or workmanship for the warranty period from the original date of consumer purchase. If the product should become defective within the warranty period, we will repair any such defect or elect to replace the product or any part of it without charge provided there is proof of purchase. This does not mean an extension of the warranty period. In the case of a warranty simply call the Remington

Service Center in your region. This warranty is offered over and above your normal statutory rights. The warranty shall apply in all countries in which our product was sold via an authorised dealer. This warranty does not include damage to the product by accident or misuse, abuse, alteration to the product or use inconsistent with the technical and/or safety instructions required. This warranty shall not apply if the product has been dismantled or repaired by a person not authorised by us. For further information on recycling see www.remington-europe.com